How to Drive a BMW 3 Series Automatic Transmission?

1 Answers
DeNoah
07/29/25 3:59pm
Here are the specific instructions for the gear positions of the BMW 3 Series automatic transmission: 1. Upon entering the vehicle, you will see the gear lever located on the right side of the driver. 2. Press the "P" button to engage the parking gear, which is used when parking. 3. Shift the gear lever into the "R" position for reverse gear; be sure to observe carefully when reversing. 4. Shift the gear lever into the "N" position for neutral gear. 5. Shift the gear lever into the "D" position for automatic driving mode. 6. Shift the gear lever into the "M" or "S" position for manual or sport mode; pushing upwards for "minus" and downwards for "plus" indicates downshifting and upshifting, respectively.
Was this review help?
8
4
Share
More Forum Discussions

How to connect the Roewe RX5 to the internet?

To connect the Roewe RX5 to the internet, follow these steps: 1. Turn on the mobile hotspot function on your phone; 2. Click on the application in the navigator, then click on settings; 3. Turn on the WLAN switch, select the WiFi of the mobile hotspot, and enter the password. After the car is connected to the internet, it can collect information about its environment and status through devices such as GPS, RFID, sensors, and camera image processing. The Roewe RX5 is an internet SUV under SAIC Roewe, with a length, width, and height of 4545mm, 1855mm, and 1690mm respectively, and a wheelbase of 2700mm. The car is equipped with features such as an electric tailgate, engine start-stop, seat heating, tire pressure monitoring, ESP body stability system, panoramic imaging, and hill descent control.
18
1
Share

What are the reasons why a car cannot start?

The reasons why a car cannot start are: 1. The spark plug is faulty, and the ignition module cannot work properly; 2. The fuel injector is faulty, and the fuel pump's fuel supply pressure is insufficient, causing it to fail to inject fuel; 3. The battery in the starting system is damaged, and there is not enough power to drive the starter motor; 4. The car has not been filled with antifreeze, causing the water circuit to freeze and the water pump to fail to operate; 5. There is excessive carbon buildup in the vehicle. When the engine is in a hot state, never open the radiator cap, otherwise you may be scalded by splashing coolant or high-temperature steam. After the engine has cooled, check that the coolant level is between the full and low marks. If not, add distilled water, purified water, or antifreeze. The liquid level after adding water should not exceed the full mark.
14
2
Share

Why Do So Many People Buy the Elegant Gold Lavida?

Because the Volkswagen Lavida offers stable engine performance, excellent durability, spacious interior, and has achieved both strong sales and a good reputation. Below is an introduction to the Lavida:1. Overview: The LAVIDA Lavida, Shanghai Volkswagen's first independently developed A-class car, became a highly sought-after model by media and consumers at the 2008 Beijing Auto Show.2. Design: Tailor-made for Chinese consumers, the Lavida maintains the superior quality of German design while incorporating aesthetic concepts reflecting traditional Chinese culture and cutting-edge design elements.3. Symbolism: It represents life, living, and hope, embodying the dynamic vitality of life and a lifestyle full of joy, promoting an innate life potential that bursts from within.
2
3
Share

How to Start a Car with One-Key Start?

The method to start a car with one-key start is as follows: 1. Press the start button once, at which point the ACC light will turn on, then press it again for the vehicle to perform a self-check; 2. Depress the brake pedal and press the start button to ignite the engine; 3. Release the foot brake and choose to warm up the car in place; 4. Depress the foot brake again, shift to D gear, and release the handbrake; 5. Slowly release the foot brake, add a little throttle, and the process is complete. The one-key start device is part of a smart car, serving as a button to simplify the ignition process, and it can also be used to turn off the engine. This device can be retrofitted at the original car key lock position or installed as an independent panel. Cars equipped with the one-key start function generally do not require inserting a key, but they all have a key insertion slot, which is used to start the car with a key in case the one-key start function malfunctions.
13
1
Share

What are the reversing techniques for towing a small vehicle?

Towing a small vehicle reversing techniques include reducing speed on sharp bends; when turning left, the front outer side should extend beyond the towing vehicle; when turning right, the inner rear side should stay close to the road centerline; when reversing, remain patient, always check the rearview mirror, and maintain a good sense of distance and direction. Below is relevant information about towing small vehicles: 1. Definition: A towing vehicle generally refers to a large truck or semi-trailer where the cab and trailer are connected by a towing mechanism. 2. Difference between towing vehicle and trailer: The front part with driving capability is called the towing vehicle, while the rear part without driving capability is called the trailer, which is pulled by the towing vehicle.
20
3
Share

How to Clean and Disinfect a Car Air Conditioner?

Methods for cleaning a car air conditioner: 1. Cleaning the air filter: (1) The air filter is usually located in the glove compartment on the passenger side, and some may be under the front windshield in the engine compartment. The exact location can be found in the vehicle's user manual. (2) Remove the old filter and clean or replace it. When installing the new filter, make sure to pay attention to the direction of the arrow on the filter; otherwise, it will not only be ineffective but also blow dust into the car. 2. Cleaning the air ducts: (1) Prepare an air conditioner cleaner before cleaning the ducts. (2) Shake the cleaner well before use and attach the included soft tube. Set the air conditioner to the maximum external circulation mode, but do not turn on the compressor (turn off the A/C button). (3) Aim the nozzle of the cleaner at the location of the air filter, and the suction inside will draw the cleaner in to clean the ducts. Be careful not to place the soft tube too close to the blower to prevent it from being sucked in. (4) After spraying the cleaner, let the air conditioner run in external circulation mode for 10 minutes. Ensure the engine is idling during this process to avoid draining the battery. The cleaner will foam and turn into liquid, cleaning the evaporator and ducts before draining out of the vehicle. 3. Cleaning the condenser: (1) The air conditioner condenser is located at the front of the vehicle. This step can be simple or complicated. (2) The simple method is to rinse it lightly with water, but avoid using a high-pressure water spray. (3) The complicated method involves removing the condenser for cleaning. It is recommended to have this done at a professional cleaning or repair shop.
20
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.