How to Drain Windshield Washer Fluid from the Car?
2 Answers
The most straightforward method to drain windshield washer fluid is by spraying it out through the wipers. Below are the steps to drain windshield washer fluid from your car: 1. If the windshield washer fluid is frozen, do not attempt to spray it immediately. Operating the windshield washer for several seconds continuously can cause the washer motor to overheat, leading to costly repairs. If the weather is favorable, you can park the car under the sun at noon and open the engine compartment to let it warm up. If the freezing isn't severe, the fluid will thaw on its own after some time. 2. You can add some warm water (not boiling water) to the washer fluid reservoir. Once the fluid thaws, drain it completely from the reservoir to prevent it from freezing again. Alternatively, wait until the engine warms up, and the washer fluid will naturally thaw. Then, completely drain the washer fluid from the reservoir.
As an experienced driver, I often handle car maintenance myself. To drain the windshield washer fluid, a simple and safe method is to spray it all out. First, pop the hood and let the engine cool for a few minutes to avoid burns or damage. Locate the transparent plastic reservoir, usually marked with a windshield washer icon, in the corner of the engine bay. Then, get in the car, turn the key to the ignition position without starting the engine, and simply hold down the windshield washer lever. The fluid will spray out from the windshield nozzles—keep pressing until it runs dry. This may take a few minutes, but it requires no tools and avoids messy hose disconnections. Once empty, you can refill with fresh fluid. If there's too much fluid to spray out, consider driving around to use it up, but avoid dry pumping for too long to prevent damaging the pump. Remember, this method is best for routine fluid changes—simple and efficient.
