How to Drain the Wuling Hongguang Radiator?

[OBennett]

Steps to drain the Wuling Hongguang radiator: 1. Open the engine compartment when the car is cold and check if the coolant is sufficient. There are MAX and MIN level marks on the side of the coolant reservoir. If the level is below the MIN mark when the car is cold, add coolant according to the marks on the reservoir. 2. Inspect all connecting pipes for cracks and leaks, with special attention to the five-way pipe. 3. Drain the old antifreeze, flush the liquid channels with clean water, allowing water to continuously flow through the engine cooling system. Then start the engine and let it idle for 3 to 5 minutes to circulate the water. Continue adding clean water until the water coming out is clear. 4. To allow the new antifreeze to flow quickly into the radiator, about 1 hour after draining, add the new antifreeze through the radiator hose. Add another bottle of antifreeze to the antifreeze reservoir until it is nearly full. Start the car and let it run for 10 minutes. At this point, the coolant level will drop slightly as some air is expelled from the cooling system. Add more antifreeze until the level is between the two marks. The dimensions of the Wuling Hongguang are 4390mm in length, 1660mm in width, and 1750mm in height, with a wheelbase of 2720mm.