How to Drain Oil from a Car?

1 Answers
LeKeira
07/30/25 4:50am
Methods for draining oil from a car: 1. Draining oil on a flat road is not easy. To drain oil from a small car, first fill the fuel tank, then drive to a slope, put the gear in first, pull the handbrake, and secure the car properly; 2. Open the fuel tank cap, insert a pre-prepared soft tube into the tank as far down as possible, use airflow to draw the oil out, and prepare a container for the oil. This is a traditional method for draining gasoline from a car, but it cannot completely drain all the gasoline. When oil needs to be drained, you can go to a repair shop or a 4S store to use professional equipment for oil draining. The main function of engine oil is to reduce friction and wear of moving parts and to remove sludge and paint from the engine.
Was this review help?
16
1
Share
More Forum Discussions

Is it necessary to apply paint protection film?

For some high-end cars, it is still necessary to apply. Here is the relevant information: 1. Paint protection film has excellent durability: The main areas to apply paint protection film include the front and rear bumpers, the front edge of the engine hood, the front edge of the wheel rims, the outer edges of the rearview mirrors, the edges of the doors, the inner edges of the door handles, the keyholes, the trunk, and the side door steps. It protects the paint surface from minor scratches and chipping. 2. Invisible car wrap: It has strong wear resistance, scratch resistance, flexibility, and prevents malicious scratches, providing comprehensive protection for the car paint. Because the car paint film is very tough, it is also vividly called "rhino skin." It can protect the paint surfaces of various parts of the car body from peeling and scratching, avoiding rust, aging, and yellowing of the paint surface. A piece of "rhino skin" also has the ability to prevent stone chips and resist UV radiation. Due to its outstanding data extensibility, transparency, and surface adaptability, it will never affect the appearance of the car body after application. It is now being used by more and more car manufacturers.
10
0
Share

Does Rim Edge Wear Have Any Impact?

Whether rim edge wear has an impact depends on the extent of the wear. If the situation is severe, it needs to be repaired at a maintenance shop. If the rim is only slightly scratched, wheel balancing may not be necessary. However, if the rim is damaged to the point of requiring replacement, a wheel balance test will be needed. Wheel balancing is performed to ensure that the car tires remain relatively stable during high-speed rotation, maintaining normal vehicle operation. This process is carried out on a specific balancing machine, where balance weights are attached to the inner side of the tire to achieve stability. The balance weights are measured in grams (g), with common sizes including 5g, 10g, 15g, 20g, and up to around 50g. Rim edge scratches can be categorized into the following three situations: If the edge of the rim is severely scratched, it needs to be repaired. Otherwise, the rim may not fit tightly with the tire, leading to air leakage. If the rim is scratched to the point where the primer is exposed, it also requires repair. If left unattended for a long time, the scratched area may wrinkle and expand, eventually leading to rust and corrosion. If the rim is damaged to the point of deformation, this is considered a severe situation that affects the vehicle's operation. Immediate repair or even replacement is necessary.
4
4
Share

What does 'max' mean in cars?

Usually, 'MAX' stands for 'maximum'. When you turn on the A/C cooling switch and then press MAX, the air conditioning system will activate the strongest cooling mode with the blower output at its maximum. Therefore, the MAX button on a car's air conditioning indicates the strongest cooling function, which helps to lower the cabin temperature as quickly as possible. More details about 'max' are as follows: 1. Introduction one: The term 'max' can be seen not only on air conditioning control buttons but also on various fluid reservoirs in the engine compartment. Here, 'max' also carries the meaning of 'maximum' or 'highest', sometimes simply denoted by 'M'. 2. Introduction two: The 'max' marking on fluid reservoirs indicates the upper limit of the fluid level. The fluid level should not exceed the horizontal line corresponding to 'max'. Naturally, where there is an upper limit, there is also a lower limit. 3. Introduction three: The lowest fluid level marking indicates that the fluid should not go below the horizontal line corresponding to 'low'. This is most evident in the overflow tank (i.e., the radiator). The optimal fluid level is between the upper and lower limits.
18
2
Share

How to Turn Off the Rear Wiper of Volkswagen Tayron?

The method to turn off the rear wiper of the Volkswagen Tayron is to pull the wiper lever upward to close it, and press it downward to turn it on. The rear wiper is the wiper on the rear windshield of the car, commonly equipped on SUVs, MPVs, hatchbacks, and some liftbacks. Below are the precautions for using wipers: 1. Maintain cleanliness: If streaks appear on the windshield, the wiper blades may be dirty. Use a towel dampened with alcohol to wipe along the edge of the wiper blade to remove accumulated dirt, debris, and dead leaves over time. 2. Check the rubber: If the wiper makes a harsh noise while operating, the rubber strip may be aged or cracked. If the wear is not severe, you can use sandpaper to smooth out rough spots on the surface. 3. Avoid sunlight: High temperatures are the enemy of rubber materials and will accelerate the aging of wiper blades. 4. Refill fluid: To prolong the lifespan of the components, always use official windshield washer fluid. Also, pay attention to the remaining capacity of the washer fluid. 5. Remove frost: In cold northern regions with heavy snowfall, the car's wipers can easily freeze. Do not force the wipers to operate at this time, as it may cause the wiper to bend, wear the wiper blades, damage the glass, and potentially directly harm the wiper motor.
11
0
Share

Which cars are equipped with Torsen full-time four-wheel drive?

Torsen full-time four-wheel drive is available in the following models: 1. Subaru XV: The Subaru XV is a very unique car that looks like both a sedan and an SUV. This is because it is built on the Impreza platform, so it inherits all the fine traditions of the Impreza. The Subaru XV is relatively small in size, so its space is not outstanding in its class, but it has excellent handling and safety performance. 2. Legacy: The Legacy is currently Subaru's only sedan, and it's a mid-size sedan at that. However, the Legacy's exterior design is quite ordinary, not resembling a car of this era. The interior is also quite plain, with little sense of design. The space is adequate but not outstanding. 3. Forester: The Subaru Forester is a compact SUV. Many people think it is sporty, but in fact, it is purely a family car. Although the interior and exterior design are quite moderate and the power is also average, its spacious interior and off-road capability that surpasses ordinary family SUVs are commendable. It is a family SUV with its own unique personality. 4. Outback: The Outback is a mid-size SUV under Subaru. Since Subaru is a niche brand, not many people know about it. The Outback's biggest feature is its excellent handling.
11
4
Share

Where is the fuel tank cap switch located on the older model Focus?

The older model Focus does not have a fuel tank cap switch. It features an integrated lock system. When the car doors are unlocked, simply push the fuel tank cap slightly inward towards the car body, and the cap will automatically pop open. Push it again to close it automatically. Remember to turn off the engine when refueling by opening the fuel tank cap. Fuel tank location: For weight distribution purposes, fuel tanks are typically located at the rear of the car. The structure of the car chassis varies, taking into account the size of the suspension and even the design of the exhaust. As a result, the fuel tank often cannot be placed directly in the center of the rear. This is why many fuel tanks are designed in various shapes and installed either to the left or right, aiming to maintain the vehicle's balance. Fuel tank cap opening methods: Due to considerations like refueling efficiency and pipeline length costs, the fuel tank cap is usually installed on one side of the tank. The fuel tank cap consists of an outer cap and an inner cap. The inner cap can be unscrewed by hand, but some models, like Ford, do not have an inner cap. The opening methods for the outer cap vary among different car brands and models, mainly including: in-car switch opening, mechanical key opening, direct press opening, and in-car central lock opening. Among these, the most common method is opening via an in-car switch.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.