How to Disassemble the Verano Key?

[DiElaina]

To disassemble the Verano car key, follow these steps: 1. At the small groove of the hook, use a flat-head screwdriver to gently pry the back side. 2. You will notice a gap appearing, then slowly widen this gap. To replace the car key battery, proceed as follows: 1. Remove the key ring, place a 1-yuan coin into a groove on the key, then twist the coin to open it and replace the CR1620 button battery. 2. Identify the positive and negative poles (positive down, negative up) and install the battery correctly. 3. Initialization: After replacing the key, initialize it to restore the remote control function.

[McVanessa]

Removing the Verano key is actually quite simple, and I often help friends with it. There's a small gap on the front or back of the key. Use a small flathead screwdriver or a plastic pry tool to gently pry it open—avoid metal tools to prevent scratches. Be careful when prying; don't use too much force, as there might be clips inside. Once opened, you'll see the battery compartment. The battery is usually a CR2032. Take out the old one and replace it with a new battery, making sure the polarity is correct. After replacing, snap the case back together until you hear a click. Last time I changed the battery, I noticed the contacts were a bit dirty, so I cleaned them with a cotton swab before reassembling to avoid poor contact. The whole process takes just a few minutes, but if it's your first time, you might feel nervous—I recommend doing it in a well-lit area to avoid losing small parts. Regularly replacing the battery helps prevent key failure, which is quite practical.

[DeGia]

Safety comes first when disassembling the Verano key. Beginners should refer to the owner's manual or search for illustrated guides online. The key housing is plastic and prone to cracking, so I always recommend using plastic tools like guitar picks or dedicated pry tools. Gently pry open from the edge gap of the key—avoid forcing it, as this may damage the internal circuit board. After removing the old battery, check the battery compartment for corrosion and clean it with alcohol swabs if necessary. When replacing with a new CR2032 battery, ensure correct polarity. Test the key functions by pressing buttons to check if the light illuminates before reassembling the housing. I've seen cases where people skipped testing and had to reopen the key, wasting time. Take your time throughout the process to avoid finger cuts.

[TheoMarie]

Verano Key Disassembly Method: There is a small slot on the back of the key. Use a thin tool to insert and pry open the shell. Remove the battery and replace it with the CR2032 model, paying attention to the cleanliness of the contacts. When reassembling, align the clips. Tools can be a plastic pry bar or an old credit card cut into strips. The whole process is quick and efficient. After replacing the battery, test the remote function to ensure it works properly.