How to Disassemble the Tiggo 5x Key?
2 Answers
The method to disassemble the Tiggo 5x key is: 1. Push the mechanical key release slider to remove the mechanical key; 2. Use a flat-head screwdriver with tape wrapped around its tip to separate the smart key cover, then remove the circuit board; 3. After removing the battery holder from the circuit board, take out the depleted battery from the battery holder, then install a new battery with the positive side facing up. The Tiggo 5x is a compact SUV under Chery Automobile, with dimensions of 4358mm in length, 1830mm in width, and 1670mm in height, a wheelbase of 2630mm, a 5-door, 5-seat SUV body type, a 5-speed manual transmission, and a naturally aspirated intake form.
I've been driving a Chery Tiggo 5x for several years, and the main reasons for disassembling the key are to replace the battery or clean the interior. First, locate the gap in the key casing, usually there's a small notch on the side. Use a flat-head screwdriver to gently pry it open, being careful not to apply too much force to avoid scratching the plastic. Then, slowly separate the upper and lower covers, taking care not to pull and break the connection strip of the buttons. If the battery is dead, remove the old CR2032 coin cell and replace it with a new one of the same model, paying attention to the battery polarity to avoid installing it backwards. When reassembling, align the clips and press them to close. Usually, avoid getting the key wet or dropping it; with good maintenance, it can last a long time. Having the tools ready before disassembly will make the process smoother.
