How to disable the automatic locking function on Baojun?

1 Answers
McAaliyah
07/29/25 8:48pm
Introduction to disabling automatic locking on Baojun: All Baojun models are equipped with an automatic locking function. The vehicle will automatically lock all doors when the speed reaches 10 km/h after starting. If you unlock the car with the key but don't open any door, it will automatically lock again after about 15 seconds. To disable this function, simply open and then close any door. Below is some relevant information about automatic locking: 1. Generally, vehicles come with automatic locking enabled from the factory as an anti-theft and safety feature. This function automatically locks the doors after the car starts moving, preventing potential robbery incidents during traffic jams or at red lights by stopping doors from being opened from outside. 2. While driving, automatic locking can protect children inside the vehicle by preventing them from accidentally opening door handles and causing accidents.
Was this review help?
18
5
Share
More Forum Discussions

What is the normal oil pressure for a 4-cylinder diesel engine?

Regardless of the number of cylinders, the normal operating oil pressure should be between 0.3-0.45MPa. Normal oil pressure range for diesel engines: For diesel engines, an oil pressure of 3 to 5 units is considered normal, with about 1 unit at idle. It should be noted that the oil pressure of diesel and gasoline engines depends on specific models, so the above data is only an estimate. Reasons for abnormal oil pressure in diesel engines: Due to component wear, improper assembly, or other faults, diesel engines may experience low or no oil pressure. Diesel engines are generally equipped with a pressure regulating valve to adjust the oil pressure.
10
4
Share

What are the reasons for car window lifting failure?

There are usually three main reasons for car window switch failure: 1. Loose window regulator screws; Solution: Tighten the regulator screws; 2. Window regulator jamming, caused by deformed or damaged window channels, loose regulator fixing screws, misaligned guide rails, or damaged window regulators; Solution: Clean or replace the window channels, or loosen the window mounting screws to adjust the window position; 3. Disconnected ground wires in the combination switch, disconnected main power wires, poor relay contact, damaged relay, or failure to turn off; Solution: Inspect and repair the circuit.
4
2
Share

When driving, should you engage the handbrake first or shift gears first?

For manual transmission vehicles, you should shift into gear first before releasing the handbrake. Below are the steps for starting a manual transmission car: 1. Master clutch pedal operation through practice - press firmly all the way down and release slowly. 2. Learn to coordinate the throttle and clutch. When starting, shift into first gear, gradually release the clutch while adding throttle at the half-clutch point, then fully release the clutch after the car moves. 3. Learn proper shift timing - shift around 2000 RPM by reducing throttle first before pressing the clutch to avoid forced disengagement, then change gears.
16
5
Share

What is the difference between Porsche Cayman and 718?

Cayman is actually the 718, with the Cayman being the hardtop version of the 718. The 718 also has a convertible version, which is called the Boxster. Here are more details about the 718: 1. The 718 is a mid-engine sports car under Porsche, and like the Porsche 911, it uses a horizontally opposed engine. 2. The standard 718 is equipped with a 2.0-liter turbocharged engine, producing 300 horsepower and a maximum torque of 380 Nm. This engine features direct fuel injection technology and uses an aluminum alloy cylinder head and block. It is paired with a 7-speed dual-clutch transmission. 3. The 718 uses MacPherson strut independent suspension for both the front and rear.
14
4
Share

How to reset the tire pressure warning on Baojun E200?

You can reinflate and adjust the tire pressure. After inspection, if all tires are normal, ensure the tire pressure is correct, ideally with all four tires having the same pressure. A normal range of 2.4–2.6 BAR is acceptable. In summer, the tire pressure can be slightly lower, or if you frequently drive on dirt roads, the pressure can also be slightly lower. Once the tire pressure is normal, there are several ways to reset the tire pressure warning icon, which may vary by vehicle. Some methods include holding down a physical button or accessing settings in the dashboard menu. After resetting the warning, restart the vehicle to continue driving.
15
2
Share

What Are the Reasons for Reduced Car Power?

There are four main reasons why a car's power may not be as good as before: 1. Excessive carbon buildup in the engine, leading to insufficient air intake and affecting the car's power; 2. Reduced spark plug efficiency, incorrect spark plug gap, damaged distributor rotor, weak high-voltage spark, or internal faults in the electronic ignition system and pulse signal generator; 3. Blocked intake system, poor valve sealing, weakened or shortened valve springs; 4. Issues in the fuel supply system, such as dirt or moisture in the fuel lines, improper adjustment of the carburetor float, or defects and improper adjustment of the emission control system.
7
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.