How to Determine When a Sylphy Needs a Wheel Alignment?

1 Answers
VanRuby
07/29/25 11:48pm
Sylphy's method for determining the need for a wheel alignment is: When driving the vehicle, if you experience heavy steering, shaking, pulling to one side, misalignment, failure to return to center, or notice abnormal tire wear such as uneven wear, scalloped wear, block wear, or biased wear, as well as floating, bumping, or swaying sensations while driving, a wheel alignment should be performed. Taking the 2021 Sylphy Luxury Edition as an example, its body structure is a 4-door, 5-seater sedan with body dimensions of 4631mm in length, 1760mm in width, and 1503mm in height, a wheelbase of 2700mm, a fuel tank capacity of 50 liters, and a trunk capacity of 510 liters.
Was this review help?
10
4
Share
More Forum Discussions

What are the winter car maintenance items?

Winter car maintenance items include: 1. Maintain the cooling system and add antifreeze. When temperatures are extremely low and conditions permit, antifreeze can be used. Before use, thoroughly clean the cooling system and select high-quality, low-corrosive antifreeze to prevent damage to engine components due to poor-quality antifreeze. 2. Replace various fluids. Choose engine oil with lower viscosity. In low-temperature conditions, engine oil viscosity increases as temperature drops, reducing fluidity. Therefore, timely replacement with lower-viscosity oil can compensate for or eliminate this adverse effect. 3. Maintain preheating devices. For engines equipped with preheating devices (mostly diesel engines), inspect and maintain the preheating equipment before winter to ensure it is in good technical condition. Focus on checking circuits and fuel lines during maintenance to prevent poor preheating device performance from affecting engine startability. 4. Maintain electrical equipment and adjust electrolyte density. Appropriately increase the electrolyte density to prevent the battery case from cracking due to excessively low electrolyte density.
20
4
Share

Where is the fuel pump module located in the Audi A4L?

The fuel pump module in the Audi A4L is located under the rear seat on the right side. Open the cover above the fuel pump under the seat. Introduction to the fuel pump: The fuel pump is a lightweight and compact pump, which can be categorized into inline, distributor, and unit types. The fuel pump requires a power source to operate, and its lower camshaft is driven by the engine crankshaft gear. Steps to replace the automotive fuel pump: First, pry off the fuel pump cover; disconnect the wiring harness plug; remove the two fuel lines; take off the sealing ring; remove the fuel pump assembly; detach the fuel float rod; remove the fuel pump chamber cover; detach the two lines of the fuel pump chamber cover; remove the fuel level sensor PCB board; detach the fuel float rod linkage arm; pull out the fuel pump core; remove and clean the fuel filter screen; check if the sensor contacts are functioning properly; install the new fuel pump and reassemble all the removed parts in order; start the engine and check the fuel gauge's working condition.
11
5
Share

What Causes a Loud Noise When the Engine is Cold?

Engine cold start noise can be caused by a cracked exhaust pipe, worn spark plugs, depleted oil level, or damaged engine bearings. Cracked Exhaust Pipe: If the engine noise is coming from the exhaust pipe, it is highly likely due to a crack in the exhaust pipe, which can be resolved by replacement. Worn Spark Plugs: A high-pitched noise during high-speed engine operation may be caused by worn spark plugs or clogging due to dirt, and can be fixed by replacement. Depleted Oil Level: If the engine noise is very low and deep, it may be due to depleted oil level, which can be resolved by timely refilling. Damaged Engine Bearings: If the engine noise changes with the maximum power RPM, it may be due to damaged engine bearings, which can be fixed by replacement.
4
3
Share

What is the reason why the Geely Emgrand GL door cannot be opened in the rain?

Emgrand GL's door may not open on rainy days due to moisture in the car's central locking circuit. The following is an introduction to the central locking system: 1. Introduction: The full name of the central locking system is central control door lock, which is a car accessory. Using this lock, you can remotely open and lock the door without inserting the key into the keyhole. It consists of a door lock switch, actuator, and controller. 2. Main functions: When the driver locks the door next to them, the other doors are also locked at the same time. The driver can open all doors simultaneously through the door lock switch or open a single door individually; when the driving speed reaches a certain level, each door can lock itself to prevent passengers from accidentally opening the door by operating the door handle; in addition to the driver's door, other doors are equipped with separate spring lock switches, which can independently control a single door.
16
3
Share

What are the advantages of the Nissan X-Trail?

The advantages of the Nissan X-Trail lie in its power performance, interior space, and driving comfort. Power Performance: The X-Trail is equipped with 2.5L and 2.0L engines, corresponding to the MR20 and MR2.5 engine models, with power parameters of 154ps/204N.M and 137ps/246N.M respectively. It is paired with a CVT transmission that simulates 7 gears. Interior Space: The rear seating space is more than adequate, comfortably accommodating four passengers without any difficulty. The vehicle is also well-equipped with most necessary features. The interior materials consist of leather and soft plastics, featuring a minimalist style without excessive embellishments. The craftsmanship of the center console is exceptionally refined, resulting in an overall interior design that is simple yet elegant, highly popular among consumers. Driving Comfort: Long-distance driving does not induce significant fatigue. The noise insulation is satisfactory, and the engine operates quietly. Thanks to the X-Trail's soft suspension, it effectively filters out minor road vibrations, providing a pleasant surprise in ride comfort.
2
1
Share

What kind of vehicle is the Iveco Jinbei?

Iveco Jinbei is a minibus. Here are the detailed specifications: 1. Type: Nanjing Iveco minibus, available in 6-8 seat (microbus) and 9-12 seat (light bus) configurations. This is the most common type of minibus, suitable for general passenger transport or cargo delivery, and can be driven with a C1 driver's license. 2. Development History: SAIC Group and Nanjing Yuejin Group held a comprehensive cooperation signing ceremony at the Great Hall of the People, which received warm attention from central and State Council leaders, as well as full support from relevant national departments and leaders of Shanghai Municipality and Jiangsu Province. The Ministry of Commerce approved the asset and business integration plan of Nanjing Iveco and Nanjing Automobile Yuejin. The company held a launch conference at Nanjing Olympic Sports Center with 7,000 employees attending, marking the beginning of building a world-class commercial vehicle company.
9
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.