How to determine the temperature of the Honda XRV water temperature?

1 Answers
MacAubrey
07/29/25 5:58pm
On the dashboard of the Honda XRV, there is a water temperature light. When the engine is cold, the green water temperature light is on. Once the temperature rises, the green light disappears. If the temperature is too high, the red water temperature warning light will illuminate to alert the driver. Relevant details are as follows: 1. Under steady driving conditions, the water temperature gauge usually stays around 90°C. To check if components like the thermostat are functioning properly, observe whether the water temperature gauge exceeds 90°C for an extended period. 2. The normal operating temperature of the engine is generally around 80-90°C. Beyond this temperature, the water will start to boil, commonly referred to as 'overheating.' Excessive water temperature can reduce engine efficiency, weaken acceleration, drastically increase fuel consumption, and in severe cases, lead to engine damage such as piston fracture or cylinder scoring. 3. The engine water temperature is not necessarily better when lower. If it's too low, it can cause incomplete combustion of the air-fuel mixture, reduced power output, poor lubrication, and increased emissions.
Was this review help?
16
3
Share
More Forum Discussions

What does the AC switch on the air conditioner mean?

The car AC switch is the cooling switch, commonly referred to as turning on the cold air. The AC switch controls the compressor, which is one of the main components of the car's air conditioning refrigeration system, responsible for compressing and transporting refrigerant vapor. Proper use of the AC switch: 1. Cold seasons: In cold seasons, it is necessary to quickly raise the temperature inside the car. When the car starts, the engine begins to warm up. Wait until the engine temperature gauge needle points to the middle position, then turn on the warm air conditioning, and at the same time set the air circulation to external circulation to allow the cold air inside the car to be expelled or wait for 2 to 3 minutes before setting the air circulation to internal circulation. 2. Rainy or snowy weather: In rainy or snowy weather, when there is a large temperature difference between the inside and outside of the car, the front windshield is very prone to fogging. At this time, simply adjust the warm air outlet direction to the position that blows on the front windshield, and the fog can be removed in a few minutes.
13
4
Share

What is the fuel consumption of the Volkswagen Passat 2.0T?

The fuel consumption of the Passat 2.0T is 7.4-8.4L/100KM. More details about the Passat are as follows: 1. Design: The Passat adopts Volkswagen's latest design language, featuring a large inverted trapezoidal grille connected to deep blackened headlight clusters. The chrome trim running across the front of the car is just right, making it a design that grows on you the more you look at it. 2. Functional Configuration: In addition to manual adjustment, the seats also feature electric adjustment with front seat heating and a boss key function. 3. Powertrain: The Passat is equipped with 1.4T and 2.0T high/low power engines. The 1.4T engine delivers a maximum power of 110kW (150PS) and a peak torque of 250N·m. The 2.0T low-power model produces a maximum power of 137kW (186PS) and a peak torque of 320N·m. The 2.0T high-power version offers a maximum power of 162kW (220PS) and a peak torque of 350N·m, paired with a 7-speed dual-clutch transmission.
20
0
Share

What to Do When the Central Locking System Frequently Jumps?

For the reasons and solutions to the frequent jumping of the central locking system, the details are as follows: 1. Damaged brake light power line: When the central locking system receives the correct code signal, the control wave receiving circuit is triggered to increase the receiving time. If the input code signal does not match, the receiving circuit will not be triggered. Solution: Check the integrity of the power line promptly and replace it in time. 2. Incorrect power connection of the central locking system: If more than 10 code signals do not match, the lock will assume that the power connection of the central locking system is incorrect and will stop receiving any signals, including the correct code signals. Solution: In this case, the owner can mechanically insert the key into the door lock hole to open the door. 3. System not closed in time: Signal reception recovery, if the door is not opened within 30 seconds after unlocking it with the remote mechanism, the door will automatically lock again. Solution: Start the car with the key and turn the main switch of the remote door lock system off and then on again.
13
0
Share

What is the fault when the BMW X1 power steering fails?

BMW X1 power steering failure is caused by steering gear failure, power assistance failure, lack of oil, heavy steering, steering noise, or steering system oil leakage. More information about power steering is as follows: 1. Power steering system: It is mainly divided into hydraulic power steering and electric power steering. Hydraulic power steering is a traditional method with the advantages of low cost and sufficient steering power, commonly used in household vehicles. In comparison, electric power steering has more advantages. First, the motor provides assistance only during steering, which can reduce fuel consumption; second, the steering assistance level can be adjusted through software, providing a noticeable "road feel" at high speeds, improving vehicle stability; third, the system is easy to assemble and maintain. 2. Self-rescue method for electronic power steering failure: Lift the throttle, push the gear lever into a low gear, pull the parking brake, and when the speed significantly decreases, press the brake pedal to gradually stop the vehicle.
12
1
Share

What does trouble code C0018 mean?

C0018 trouble code, applicable to all automobile manufacturers, means Left Rear Inlet Control (Subfault). You cannot simply remove the negative ground cable of the battery to clear the trouble code, as it may cause the following issues: 1. Data loss: This may cause the control center computer of some vehicle models to lose normal records. Some vehicle models' control computers have an automatic memory function. After removing the negative ground cable of the battery, the engine operation data stored in RAM will be lost, resulting in poor performance of the vehicle for a considerable period after repair, or the reappearance of previously cleared trouble codes after driving for some time. 2. Malfunctioning features: Sometimes it may also cause some useful features to malfunction, such as the audio lock function, which is one of the common situations. In this case, the audio system will need to be repaired separately.
17
2
Share

How to Report an Insurance Claim After a Car Accident?

After a traffic accident occurs, immediately contact your insurance company and the traffic police department, while also protecting the scene. Wait for the insurance company's personnel to handle the insurance matters. Below are relevant introductions: 1. Commercial Insurance: Auto insurance, also known as motor vehicle insurance or car insurance, refers to a type of commercial insurance that covers personal injury or property damage caused by natural disasters or accidents involving motor vehicles. 2. Property Insurance: Auto insurance is a form of property insurance. Within the realm of property insurance, auto insurance is a relatively young category, as it emerged and developed alongside the advent and popularization of automobiles. Unlike modern motor vehicle insurance, early auto insurance primarily focused on third-party liability coverage and gradually expanded to include risks such as collision damage to the vehicle body.
13
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.