···
Log in / Register

How to Determine if the Flywheel Needs Replacement

3 Answers
DiFelix
09/03/25 5:29am
Here is the relevant introduction on whether the flywheel needs replacement: 1. Check if the starter ring gear of the flywheel is in good condition: If there are broken teeth or severe wear at the tooth ends, it is damaged, and the ring gear or flywheel assembly should be replaced. 2. Check the flywheel surface for scratches, impact marks, severe burns, etc.: If the wear groove depth exceeds 0.50mm, it is damaged and should be repaired or replaced. The flywheel and pressure plate have dynamic balance requirements. A damaged flywheel can cause engine imbalance, leading to crankshaft fatigue and longitudinal cracks in the flywheel housing. The flywheel and pressure plate have dynamic balance requirements, and imbalance due to assembly reasons or component quality can result in crankshaft fatigue and longitudinal cracks in the flywheel housing. Additionally, the ring gear and flywheel are an interference fit, and the ring gear should be heated during assembly.
Was this review help?
14
0
Share
GenevieveFitz
09/15/25 6:58am
Having driven for decades, there are nuances in determining whether a flywheel needs replacement. For instance, if the engine vibrates excessively during operation, especially when accelerating and the car shakes noticeably, it's time for an inspection. Unusual noises or jerking sensations during gear shifts could signal flywheel wear. When replacing the clutch disc, it's wise to check the flywheel simultaneously to prevent it from causing issues with other components. I recall one instance where the car vibrated persistently at idle; upon inspection, the flywheel surface was uneven, later thinning and developing cracks, nearly damaging the transmission. Never neglect routine maintenance—if symptoms arise, promptly seek a professional evaluation to ensure safe driving without delay.
Was this review help?
2
5
Share
Expand All
JacksonLee
10/29/25 7:37am
Determining whether to replace the flywheel is quite simple—just observe your car's reactions while driving. If the car makes a buzzing noise during startup or exhibits noticeable shaking during acceleration, the flywheel might be damaged. Unstable idling is also a warning sign; my car had this issue last week, with erratic idling making me mistakenly think the tires were unbalanced. Pay attention if gear shifting isn't smooth—don't wait until the entire system fails before repairing it. An unbalanced flywheel not only ruins the driving experience but also affects the engine's lifespan. Addressing it promptly saves both hassle and money. The lesson is to check your car's condition monthly for early prevention.
Was this review help?
9
0
Share
Expand All
More Forum Discussions

What are the safety features of the Lavida?

Lavida's safety features include: driver and front passenger airbags, front side airbags, front and rear head airbags, tire pressure monitoring, seat belt reminder, ABS anti-lock braking system, brake force distribution, brake assist, traction control, electronic stability program, and autonomous emergency braking. The Lavida is a vehicle launched by SAIC Volkswagen, with dimensions of 4670mm in length, 1806mm in width, and 1474mm in height, and a wheelbase of 2688mm. The car is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 113ps and a maximum torque of 145nm. The Lavida's onboard navigation system combines touch screen and rotary knob controls, supports MP3 playback, and includes USB, AUX, and SD card expansion slots for ease of use and powerful functionality. The LCD screen features a foldable design.
11
5
Share

How to Install and Remove Car Floor Mat Clips?

Check the position of the clips and roughly place the floor mat into the car. Align the first clip and press it firmly into place. Align the second clip, press it firmly, then tighten the floor mat to complete the installation.
4
5
Share

How to Use a New Car Battery for the First Time?

First, charge with the initial current (one-tenth of the battery's capacity) until the electrolyte bubbles, raising the voltage of each cell to 2.3-2.4V. Then, continue charging with half of the initial current until the electrolyte bubbles vigorously. The voltage should be maintained continuously for 3 hours. Generally, after the charger light turns off, continue charging for 1-2 hours. The total charging time should be 8-10 hours.
17
1
Share

Does the Sagitar dashboard display when the battery is low?

The Sagitar dashboard will display a warning when the battery is low. If the battery power is insufficient while driving, a battery-like symbol will pop up on the dashboard, with a plus sign on one side and a minus sign on the other. If the low battery symbol appears during prolonged driving, it indicates that the battery is damaged or can no longer hold a charge. The Sagitar is an A+ sedan brand under FAW-Volkswagen, with a body length, width, and height of 4753mm, 1800mm, and 1462mm respectively, a wheelbase of 2731mm, and a fuel tank capacity of 50L. The vehicle is equipped with two engines: a 1.2T turbocharged engine and a 1.4T turbocharged engine. The 1.4T engine has a maximum power of 110KW, a maximum horsepower of 150PS, and a maximum torque of 250NM.
10
2
Share

Where is the air conditioning filter of Roewe 750 located?

Roewe 750's air conditioning filter is located under the wiper cover on the right side of the front passenger side. After opening the engine cover and removing the wiper cover, you can see it. It is generally recommended to replace the car's air conditioning filter every 10,000 kilometers or about one year. Its function is to filter particles and impurities in the air to ensure fresh air inside the car. The Roewe 750 is positioned as a mid-size car, with body dimensions of 4545mm in length, 1855mm in width, and 1719mm in height, and a wheelbase of 2700mm. In terms of power, the Roewe 750 is equipped with two engines: one is a 1.8T inline 4-cylinder turbocharged engine, and the other is a 2.5L V-type 6-cylinder naturally aspirated engine.
13
0
Share

What to Do When Car Air Conditioning Buttons Don't Respond?

If the pressure is too low, it indicates a lack of refrigerant, which needs to be replenished. Insufficient refrigerant will affect the cooling performance of the air conditioning system. Check whether the blower of the air conditioning system is operating normally. If the blower malfunctions, it may result in no cold air coming out of the vents.
8
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.