How to Deal with Water Under the Car Floor Mats

What Does It Mean When the ABS Light Comes On?

When the ABS light is displayed on your car, it indicates a malfunction in the vehicle's Anti-lock Braking System. During emergency braking, if the wheels lock up, the vehicle may lose control and skid, preventing the driver from slowing down or adjusting the vehicle's trajectory, which poses significant safety risks. There are several scenarios where the ABS light may illuminate, each with different causes and solutions, as detailed below: Scenario 1: The ABS warning light stays on continuously (most common). Cause 1: The ABS speed sensor's sensing area is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle's speed and calculating the wheel slip rate, thus failing to issue appropriate commands to regulate braking. Solution: Clean the dirt from the speed sensor and adjust the gap between the sensor and the signal ring to restore normal function. Cause 2: Poor signal transmission due to loose connections in the system wiring or faulty ABS relay contacts. Solution: Inspect the wiring connections and reconnect any loose parts. Scenario 2: The ABS warning light intermittently illuminates but turns off when accelerating. Cause: When multiple vehicle electrical devices are in use, the battery voltage may drop below 10.5V. As the engine speed increases and voltage rises, the ABS light turns off. This can also occur if the ABS system's power supply voltage is too low, such as due to poor terminal contact or grounding issues. Solution: Check the battery's specific gravity, inspect the charging system, and examine the power supply (e.g., voltage relay or poor power contact). Scenario 3: The ABS warning light remains on after engine start-up and only turns off when the engine is turned off (IGFF). Cause: Poor grounding of the ABS hydraulic valve body, faulty wiring connections at the valve body, or a malfunctioning ABS computer. Solution: Loosen and then retighten the grounding screw of the hydraulic valve body, cleaning the contact surface if necessary. Check for enlarged gaps in the connectors, and replace the ABS or ABS/ASR computer if needed. Scenario 4: The ABS warning light comes on during high-speed driving. Cause: At high speeds, the ABS computer detects a significant discrepancy between the rear and front wheel speed signals, or incorrect tire or wheel rim specifications. Solution: Refer to the vehicle's tire and wheel rim specifications, typically listed on the sticker near the fuel tank cap. Scenario 5: The ABS warning light intermittently illuminates. Cause: Improper adjustment of the brake light switch or poor internal contact within the brake light. Solution: Start the engine, press the brake pedal, and use your finger to push the brake switch linkage all the way down. Release the brake pedal to complete the self-setting position. Replace the brake light switch if necessary.

6

1

Share

Is It Necessary to Change to Snow Tires in Winter?

It is not mandatory to change to snow tires in winter. Here is an introduction to the functions of snow tires for cars in winter: 1. Anti-slip: Compared to regular tires, snow tires use a special formula to increase friction with snow and ice surfaces, improving passability and safety on snowy and icy roads. 2. Enhanced Traction: The tread material of snow tires is softer. The carefully formulated silica-mixed rubber compound allows for closer contact with smooth ice surfaces, generating greater friction than all-season tires. This significantly improves the vehicle's handling and safety on slippery ice surfaces.

11

5

Share

How to Place Temporary License Plates?

Two temporary license plates should be affixed simultaneously. One should be placed in the lower left or right corner of the front windshield inside the vehicle, in a position that does not obstruct the driver's view. The other should be affixed in the lower left corner of the rear windshield inside the vehicle. Here is more information about temporary license plates: 1. Introduction: Temporary license plates, also known as temporary vehicle movement permits, are paper license plates that allow vehicles to be driven on roads temporarily. They are issued by the vehicle management department of the public security bureau for newly purchased vehicles before formal registration. 2. Validity Period: The validity period of temporary license plates generally does not exceed thirty days. 3. Classification: There are four types: temporary plates for administrative districts, temporary plates for cross-administrative districts, temporary plates for testing purposes, and temporary plates for special-type motor vehicles.

2

0

Share

Why Does My Foot Keep Shaking When Pressing the Clutch?

The reasons for foot shaking when pressing the clutch are as follows: 1. Driving posture issue: First, check your driving posture to ensure that your feet can naturally rest on the pedals, with sufficient room for knee movement. It might be that the seat is positioned too far back, causing the clutch to be too far from your foot, making it difficult to press fully. Over time, this can increase fatigue and lead to foot shaking. If the seat is too far forward, causing your legs to be cramped at the clutch and brake pedals, it can also increase discomfort. 2. Emotional issue: The main reason is nervousness, which causes the leg muscles to tense up. If you notice foot shaking while practicing driving, it's advisable to take a break. Prolonged driving can lead to foot shaking. 3. Clutch pressing technique issue: When pressing the clutch, place the ball of your left foot on the clutch pedal with your heel firmly on the ground as a support point. Then press the clutch all the way down. If you cannot easily press the clutch pedal fully with your left foot, adjust the seat position. Note: Throughout the process of pressing the clutch, your heel should always remain firmly on the ground.

19

1

Share

Does the new Lavida have one-button start?

The new Lavida does not have one-button start. The Volkswagen New Lavida Plus 1.5L Comfort configuration is not equipped with one-button start and uses manual mechanical key ignition. Lavida is a sedan produced by Shanghai Volkswagen and was launched in June 2008. The Lavida is equipped with three displacement options: 1.4T, 1.5, and 2.0 liters, with an expected four model variants. Below are some related details about the new Lavida: 1. In-car navigation: The Lavida's in-car navigation system combines touch screen and rotary knob controls, with MP3 playback capability, supporting USB, AUX, and SD card expansion slots. It is user-friendly and feature-rich, with a foldable LCD screen design. 2. Technical highlights: The NIO concept car. The design of the Lavida originally stemmed from the NIO concept car showcased at the 2006 Beijing Auto Show. The design elements derived from the NIO concept car previewed the basic style of Volkswagen's localized sedan design in China. Compared to Volkswagen's products in Europe, the NIO's design is relatively understated.

1

Share

How Many Types of Car Phone Mounts Are There?

Currently, there are two main types of mounts available on the market: suction cup mounts and clip-on mounts. Here is more information about car phone mounts: 1. Suction Cup Car Mount: The suction cup car mount utilizes the adhesive power of a suction cup, allowing it to be placed in various locations inside the car, such as the front windshield or the dashboard, providing drivers with a more intuitive view of their phone. However, when driving on uneven roads, there is a chance the suction cup mount may detach. Additionally, its larger size can obstruct the driver's view, especially when attached to the windshield. 2. Clip-On Car Mount: The clip-on car mount can be secured to the air vents. Compared to the suction cup mount, it is more compact and does not block the driver's line of sight. It is also relatively cheaper. However, its installation position (on the air vents) is lower, which may reduce viewing convenience and require more attention, potentially creating safety hazards. 3. Magnetic Car Mount: As the name suggests, the magnetic car mount uses the mutual attraction of magnets to stay in place, making it less likely to fall off—provided the quality is good. Its small size allows it to be attached anywhere inside the car, making it a top choice for many drivers. However, since it requires 3M adhesive for fixation, it may leave behind hard-to-remove marks. Additionally, a metal plate must be attached to the back of the phone, which may affect its appearance.

6

1

Share

How to Deal with Water Under the Car Floor Mats

What Does It Mean When the ABS Light Comes On?

Is It Necessary to Change to Snow Tires in Winter?

How to Place Temporary License Plates?

Why Does My Foot Keep Shaking When Pressing the Clutch?

Does the new Lavida have one-button start?

How Many Types of Car Phone Mounts Are There?

Do I need to renew my driver's license one year after obtaining it?

Is there a difference between automatic transmission and manual-automatic transmission?

What does the blue color on the navigation mean?

How often should the tires on the Tiguan be replaced?