How to Deal with Water Leakage in the Floor of Volkswagen Bora?

2 Answers
StAllie
08/31/25 5:29am
Here are the relevant solutions for water leakage in the floor of Volkswagen Bora: 1. If there is water under the carpets, driver's side, passenger side, or rear seats, it is essential to address the water under the floor mats or carpets promptly. Failure to do so may lead to mold growth inside the car and damage to the vehicle's wiring harness or control units. 2. Depending on the severity of the water leakage, remove all seats from the cabin. Take out the floor mats, carpets, and other components. Dry the water inside thoroughly, and air-dry the carpets and floor mats. Replace any damaged control units. For any electrical wiring affected by water, ensure it is cleaned to remove moisture and dampness. While dealing with the interior water, always check the cause of the water entering the vehicle.
Was this review help?
14
0
Share
VeraRose
09/12/25 8:41am
My car is also a Volkswagen Bora, and I've encountered a situation where water leaked onto the floor, causing a musty smell inside the car. I suspect it might be due to clogged sunroof drainage holes, as rainwater had nowhere to go and seeped under the floor mats; or it could be aging door seals allowing water to leak in; sometimes, a blocked air conditioning drain pipe can cause condensed water to flow back in. When dealing with it, I first parked the car, lifted the floor mats to check where it was wet, then wiped it dry with a cloth and left the car with the AC on hot air or in the sun for a few days to eliminate the musty smell. If I found a clogged hole, I used a small wire to clear it; if the seals were damaged, I had to go to a shop to replace them. Don’t take it lightly—prolonged water exposure can cause electrical shorts, rust, and even safety hazards. When washing the car, pay extra attention to flushing the drainage holes to prevent future issues, especially since the Bora is an older model prone to minor problems. Simple repairs should suffice, but if not, it’s best to consult a professional mechanic.
Was this review help?
14
0
Share
Expand All
More Forum Discussions

What is the serrated white solid line inside the circle?

It is a variable direction lane marking. Below is the relevant introduction: 1. Introduction to variable direction lane markings: Variable direction lane markings mean that the direction after entering this lane must be determined according to the corresponding lane signal light instructions. Variable direction lanes have flexibility and guidance, which are different from ordinary lane indication lines. Ordinary lanes have markings on the ground indicating the direction. Variable direction lane markings are generally set up in sections with more complex traffic conditions. 2. Specific operation method: If you encounter this type of lane, you should drive according to the instructions of the corresponding lane signal light.
11
4
Share

What is the size of the Wuling Hongguang Mini's front windshield?

The height of the Wuling Hongguang Mini's windshield is no less than 38cm, and the width is no less than 93cm. Here are some related details: 1. Powertrain: The Wuling Hongguang is equipped with two engines, the P-TEC 1.2L and 1.5L-DVVT, both designed and manufactured according to General Motors' global powertrain standards. These engines feature a double overhead camshaft design. 2. Body dimensions: The top-tier model of the Wuling Hongguang has front seats with 8-way adjustable design, offering a fore-aft adjustment range of up to 190mm and a fore-aft movement range of 160mm. The new Wuling Hongguang has a body length of 4420mm, a width of 1685mm, and a height of 1755mm (1770mm with roof rack).
20
0
Share

What is the ground clearance of the Lincoln Nautilus?

The minimum ground clearance of the Lincoln Nautilus is 200 millimeters. The minimum ground clearance of the Lincoln Nautilus refers to the distance between the lowest point (excluding the wheels) and the supporting plane, which indicates the vehicle's ability to pass over obstacles such as rocks and tree stumps without collision. A higher ground clearance for the Lincoln Nautilus improves its off-road capability, but if the ground clearance is too high, the stability at high speeds may decrease. The Lincoln Nautilus is a midsize SUV under Changan Lincoln. The dimensions of the Lincoln Nautilus are 4849×1934×1693mm (length×width×height), with a wheelbase of 2850mm. Generally, the ground clearance of sedans ranges between 110mm and 150mm, while SUVs have a ground clearance between 200mm and 250mm. However, the ground clearance of the Lincoln Nautilus is not static; it also depends on the load condition. Therefore, changes in ground clearance should be considered based on the vehicle's load variations. When selecting a vehicle, ground clearance can be one of the reference factors. The choice should depend on the vehicle's intended use and driving conditions. For urban areas with well-paved roads, a lower ground clearance can enhance stability and comfort. For frequent off-road travel or driving in areas with poor road conditions, a higher ground clearance is advisable to improve off-road performance and avoid damage to the undercarriage.
12
2
Share

Where is the USB port located in the Levin Hybrid?

In the storage compartment in front of the front passenger seat. More information about the Levin Hybrid is as follows: 1. Overview: The Levin Hybrid version is equipped with a hybrid system consisting of a 1.8L Atkinson cycle engine and an electric motor, with the engine's maximum output power being 99 horsepower and the electric motor's maximum output power being 72 horsepower. The combined fuel consumption is 4.2L/100km. 2. Others: The Levin Hybrid is driven solely by the electric motor at low-speed starts, by both the engine and electric motor during normal driving conditions, and by both the engine and electric motor operating at full capacity during full acceleration.
3
1
Share

What are the standard tires for the Audi A6L?

The 2019 Audi A6L comes equipped with three tire sizes, all factory-installed tires are from the Goodyear brand. The tire models are 225/55R18, 245/45R19, and 255/40R20. Goodyear, officially known as The Goodyear Tire & Rubber Company, was founded in 1898 in the United States and has over a century of history. Goodyear is the world's largest tire manufacturing company, headquartered in Akron, Ohio, USA. The company primarily produces tires, engineered rubber products, and chemical products in over 90 factories across 28 countries. Goodyear also specializes in designing and producing matching tires and related equipment for many top international car manufacturers. International automotive brands that use Goodyear tires include Rolls-Royce, Mercedes-Benz, BMW, Audi, Volkswagen, General Motors, Ford, Chrysler, and Lexus, among others. The parameters on the tires have the following meanings: the first number represents the tire's width, the second number represents the aspect ratio, and the third number represents the diameter suitable for the wheel hub. Taking 225/55R18 as an example, these numbers mean: 225 indicates the tire's section width in millimeters, generally ranging between 145—285mm, with intervals of 10mm; 55 is the aspect ratio, which is the ratio of the tire's sidewall height to its section width, representing 55%. Typically, tire aspect ratios range between 30%—80%. Under normal circumstances, ordinary sedans should not use tires with an aspect ratio greater than 75%, while luxury cars and high-performance sports cars are recommended to use tires with an aspect ratio <60%; R stands for Radial, indicating the tire has a radial structure, and 15 is the wheel hub's outer diameter in inches.
14
5
Share

Is it necessary to remove the old paint for a full car repaint?

Yes, it is necessary. If the original car paint is not treated during a full repaint, the new putty and paint cannot adhere well to the surface, which can easily lead to peeling and bubbling later on, making the entire car look poor. Additionally, if new paint is applied over the old paint, the high pressure from car wash jets can easily cause the new paint to peel off. Additional information: The old paint can have some influence on the color of the new paint. Car paint consists of several layers. The top layer is the clear coat, followed by the base coat, then the primer, and finally the electroplated layer. Methods to remove the old paint typically involve sanding with sandpaper or using asphalt cleaner to dissolve the paint.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.