How to Deal with Water Accumulation in the Car?

2 Answers
SamuelMarie
07/29/25 6:54am
Due to deformation of the window glass sealing strip, water may enter the car door. It is necessary to promptly check if the sealing strip is damaged. Poor sealing of the trunk sealing strip and rear taillight seals can also lead to water accumulation inside the car. The sealing strip should be replaced in time, and the sealing of the taillights should be checked. Check promptly whether the area under the floor mat is damp. If water accumulation is found, remove the sponge under the floor mat and dry it in the sun to prevent rainwater from soaking the car chassis.
Was this review help?
2
0
Share
Tami
08/12/25 10:16am
I remember that time after the rain when I found the car carpets soaked. I thought it was a minor leak, but upon inspection, I discovered the sunroof drain holes were clogged. I immediately took action: used old towels to soak up the water, opened all the doors for ventilation. Don’t overlook the corners and under the seats—standing water can corrode the frame and promote mold growth. Later, I carefully checked the leak point and found the sealant had aged and cracked, so I bought a cheap seal strip and replaced it myself. After ventilating for a few days and using a fan to dry it out, I tested the electronics to ensure no moisture damage and felt relieved. My advice: clean the drainage channels every time you wash the car—prevention is far more important than repair, saving both hassle and headaches.
Was this review help?
1
4
Share
Expand All
More Forum Discussions

How to Reset the Maintenance Reminder on a Golf?

Method to reset the maintenance reminder on a Golf: 1. With the engine turned off, press and hold the trip odometer reset button located below the tachometer; 2. Turn the ignition to the ON position, then release the trip odometer reset button. The display will show "SERVICE"; 3. Pull out the minute button on the clock and turn it to the right. The odometer reading will appear on the display; 4. Turn off the engine to reset the reminder message; 5. Turn the ignition to the ON position again, and the "SERVICE" indicator will disappear. The Golf's body dimensions are 4296mm in length, 1788mm in width, and 1471mm in height.
6
4
Share

What to Do When an Automatic Car Battery Dies?

Solutions for a dead battery in an automatic car: 1. Jump-start with jumper cables—if another vehicle is available nearby, this method saves time and effort. You'll need a functioning car and two relatively thick cables, paying attention to the correct connection sequence. 2. A portable car jump starter can solve the issue safely. Drive responsibly, monitor fuel and battery levels. 3. Push-start the car with help from nearby friends. Before pushing, turn the key to the ignition position. Once reaching a certain speed, quickly shift into first gear, release the clutch pedal, and press the accelerator. Once the engine starts, immediately depress the clutch pedal while controlling the throttle to prevent stalling. Then, stop slowly and continue charging the battery. 4. Towing-start with a tow rope—securely fasten both vehicles and begin towing slowly, ensuring safe speeds and driving conditions.
15
0
Share

Does a Car Need Fuel Additives?

Does a car need fuel additives? Adding fuel additives (cleaning type) to a car can effectively remove carbon deposits inside the engine by attaching to the pores of the carbon deposits and then decomposing and expelling them. Especially for turbocharged engines, long-term use can accumulate a lot of carbon deposits, and at this time, it is necessary to add this type of cleaning fuel additive. Fuel additives are a type of automotive chemical and a common name for the third generation of gasoline detergents. Their role is to solve the carbon deposit problem in the fuel system of fuel-injected vehicles, quickly restore the engine to optimal working conditions, and compensate for some deficiencies in gasoline properties, giving gasoline new and excellent characteristics such as improving atomization, reducing wear, protecting the engine, and lowering emissions.
15
3
Share

How to Solve Windshield Wiper Chattering?

Solutions for windshield wiper chattering: 1. If the chattering is caused by the wiper blade, which is a rubber product that hardens and ages over time, leading to chattering and ineffective cleaning, the simplest and most effective solution is to replace the wiper blade with a new one; 2. If the chattering is due to a misaligned wiper arm, remove the wiper blade and use two wrenches to adjust—one to hold the wiper arm steady and the other to adjust its angle until it fits snugly against the windshield; 3. If the chattering is caused by motor issues, such as insufficient power from the wiper motor, which results in shaking during operation, this may indicate motor damage or wear. In such cases, it is recommended to visit a professional repair shop for inspection and repair.
6
4
Share

Can You Wash Your Car Immediately After a High-Speed Run?

You should not wash your car immediately after a high-speed run; wait until the car has cooled down. After prolonged high-speed driving, both the brakes and the engine are in a very hot state. If water comes into contact with the hot engine cover or brake discs, thermal expansion and contraction can affect the vehicle, potentially causing minor issues like steering wheel vibration or severe problems such as brake system failure, compromising driving safety. Washing precautions: 1. Avoid washing the car before the engine has completely cooled down, as this can lead to premature aging of the engine. 2. Avoid washing the car under direct sunlight, as this can leave dried water spot marks on the body. 3. Avoid washing the car in extremely cold weather, as water freezing can cause the paint film to crack. 4. Avoid using anything other than soft water for washing, including hot water, alkaline water, or hard water, as these substances can damage the paint. Using hard water can leave marks and a film on the car's surface after drying.
11
3
Share

Will the warranty still be valid after installing a reverse camera?

Installing a reverse camera will not void the vehicle's warranty, but the aftermarket product itself is not covered by the original warranty. Additionally, it's important to note that any related malfunctions caused by self-modified wiring will also not be covered under warranty. The shop that installed the equipment is responsible for the warranty of the aftermarket product. The reverse camera, also known as a parking assist system, reverse visual system, or vehicle monitoring system, is widely used in various large, medium, and small vehicles for reversing or driving safety assistance. Whether in terms of structure and appearance or performance, current products each have their own characteristics. The most commonly used types are digital display, screen display, and multi-function rearview mirror display.
20
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.