How to Deal with the Rattling Noise in the Magotan's Center Console?

1 Answers
LeAngelo
07/28/25 3:36pm
Here are the methods to handle the rattling noise in the Magotan's center console: 1. Rattling from the air vents. Check if the air vents are loose or if the noise is caused by an installed perfume bottle. Tighten them or pad the edges with materials like 3M tape. 2. Loose center console panel. This is a rare occurrence. The solution is to remove and re-tighten it or wrap tape around the clips. 3. Friction between the center console and the A-pillar or windshield. Place a layer of felt cloth at the contact points. 4. Loose connectors/wiring harness inside the center console. This is especially important for vehicles with aftermarket reverse cameras, as a connector might be unplugged or the wiring harness not secured properly. Adjust as needed. 5. Foreign objects inside the center console storage box, such as lighters or coins. 6. Consider thermal expansion and contraction. Particularly in winter, rattling may occur when driving a cold car. Wait for the car to warm up, and this phenomenon can be ignored.
Was this review help?
13
4
Share
More Forum Discussions

Where is the fuel tank opened on the 10th generation Accord?

The fuel tank of the 10th generation Accord is located on the rear fender on the driver's side. There is no fuel tank lock button inside the car. When the vehicle is unlocked, pressing the fuel tank cover will automatically pop it open. After locking the car, the fuel tank cover will automatically lock. Content extension: 1. Try not to wait until the fuel light comes on before refueling. Because the fuel pump is located inside the fuel tank, it generates high temperatures during continuous operation, and being immersed in fuel helps to effectively cool it down. 2. Some models have specific requirements for fuel quality. Using gasoline with a lower octane rating than specified may cause engine knocking, while blindly using gasoline with a higher octane rating than required is also incorrect.
9
5
Share

What are the effects of sleeping in a car?

If you sleep in the car for a long time with the windows closed, it is easy to suffocate due to lack of oxygen in the car, which can be life-threatening. Try to avoid sleeping in the car, especially for long periods. If you must sleep in the car, it is possible as long as ventilation is ensured. Remember to ventilate to ensure air exchange between the inside and outside of the car. Related introductions are as follows: 1. To sleep in the car, first ensure that the vehicle is parked in a relatively open and well-ventilated place. Then, try to open the windows slightly before sleeping to ensure air exchange between the inside and outside of the car. 2. For short-term sleep, you can turn on the air conditioning and internal air circulation to ensure basic ventilation. After turning off the engine, relying solely on the battery power cannot maintain long-term ventilation.
8
1
Share

Within what ranking can you successfully book the Subject 2 test?

It depends on the capacity of the driving test center or examination venue. Normally, bookings within the top 300 are processed faster. Here is the relevant information: Five Booking Attempts: The Subject 2 test for the motor vehicle driver's license allows five successful booking attempts and examination opportunities. Once these five attempts are exceeded, the Subject 2 test can no longer be taken, and the entire driver's license examination process will be canceled, making it impossible to continue. To reattempt, you must register again. Approval Notification: A successful Subject 2 test booking is confirmed only when the status shows 'approved,' along with the test time, venue, session, and location details. If the review is not approved, the booking is considered unsuccessful.
10
0
Share

What are the various actions involved in driving?

The various actions involved in driving are as follows: Steering: Good coordination between both hands is required when steering. For turns of less than half a rotation, try to control the steering wheel mainly with the left hand, while the right hand follows the movement. For full rotations or more, the hands should follow at the ten o'clock or two o'clock positions. Turning on the indicator: When activating the turn signal, pay attention to the use of the left hand's fingers. The left hand should not leave the steering wheel; try to complete the action with the fingers. Starting the vehicle: Turn the key to the ignition position and hold it for about three seconds. Release the key promptly after the engine starts; do not keep turning it all the way, as this can make it difficult to start. Shifting gears: Shifting requires practice to master the technique. When shifting, hold the gear knob with the palm facing downward and avoid using excessive force, as this can lead to incorrect gear engagement and cause significant damage to the car.
17
1
Share

How to remove the fan of Hummer H2?

Below is the method for removing the fan of Hummer H2: 1. First, remove the fan protective casing. 2. Then, loosen the surrounding fixing screws. 3. After disconnecting the power supply wires and sensor wires connected to the engine, water temperature gauge, and air conditioning, the fan can be removed. Additional information: The electric fan only operates to reduce the temperature of the radiator. The radiator temperature is influenced by two factors: one is the cooling of the engine block and transmission, and the other is the heat dissipation of the air conditioning condenser. The air conditioning condenser and the radiator are two separate components, placed closely together, with the condenser in front and the radiator behind. The air conditioning is a relatively independent system within the vehicle. However, the activation of the air conditioning switch sends a signal to the electronic fan control unit J293, forcing the electronic fan to rotate.
6
2
Share

What are the scoring criteria for the right-angle turn in Subject 2?

The scoring criteria for the right-angle turn in Subject 2 are as follows: Exam criteria: If any wheel presses against the road edge line, 100 points will be deducted (previously, squeezing the edge line would deduct 20 points, while crossing the line would deduct 100 points. Under the new standard, squeezing the edge line is also increased to a 100-point deduction. Stopping midway will also result in a 100-point deduction. Site requirements: The right-angle turn course resembles an L-shape placed flat on the ground. After the implementation of the new regulations, the course length must be at least 1.5 times the length of the vehicle, and the width should be the wheelbase of small vehicles plus 1 meter. Before entering the right-angle turn, position the car as far away as possible from the turning point marker pole within the two boundary lines (the outer 1/3 of the front bumper should press the outer line, and the left edge of the front bumper should align with the marker point), then proceed slowly. When the rearview mirror on the side near the turning point aligns with the turning point, turn the steering wheel fully to that side. Once the front of the car straightens, return the steering wheel to the neutral position.
3
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.