How to Deal with Peeling on Car Headlight Surface?

Is It Normal for an Automatic Transmission Car to Jerk When Stopping?

Automatic transmission cars jerking when coming to a stop is a normal occurrence. All automatic transmission vehicles will experience a slight jerk at the moment of braking, though it should not be too noticeable. Below is a detailed explanation regarding this phenomenon: 1. Overview: Automatic transmission cars typically use hydraulic transmission devices to replace the mechanical clutch found in manual transmission cars, hence there is no clutch pedal. When the engine speed is low, the torque transmitted by the fluid is limited and insufficient to propel the car forward. When the gear selector is placed in drive and the brake pedal is released, as the accelerator is pressed and engine speed increases, the transmitted torque grows, pushing the car forward. 2. Braking Precautions for Automatic Transmission: When there is sufficient braking distance, press the brake pedal slowly and continuously to decelerate evenly. As the car is about to come to a complete stop, gradually release the brake pedal until it is fully lifted when the car is stationary.

13

4

Share

Can the Wuling Hongguang Mini support fast charging?

Wuling Hongguang Mini does not support fast charging. Here are some charging precautions for the Wuling Hongguang Mini: 1. You can use the included charger to charge with a household 220V power supply, or use paid charging stations on the roadside; 2. It only supports slow charging, so it cannot use fast charging stations to complete charging within one and a half hours; 3. Do not completely deplete the battery before recharging during use; 4. It is not necessary to charge the battery to 100% capacity; 5. When the temperature is too low, do not charge the vehicle directly. You need to start the vehicle to preheat for about half an hour before charging.

15

2

Share

Is it allowed to reverse on highway ramps?

Reversing on highway ramps is not allowed and is considered illegal, resulting in a 12-point penalty. According to the Road Traffic Safety Law, parking on highway ramps is also prohibited and will incur a 6-point penalty on the driver's license. Article 17 of the "Highway Traffic Management Regulations" stipulates: When driving normally on highways, motor vehicles must adhere to the following rules: no reversing, no driving against traffic, no crossing the central divider to make U-turns or turns; no test driving or learning to drive motor vehicles; no reversing, overtaking, or parking on ramps, acceleration lanes, or deceleration lanes; no straddling or pressing lane dividers and no continuous driving in overtaking lanes; no overtaking from the right side; except in cases of obstacles, breakdowns, or other necessary stops, no arbitrary stopping, picking up/dropping off passengers, or loading/unloading goods; except for entering or exiting emergency parking strips and shoulders due to stopping, no driving on emergency parking strips or shoulders. When driving on highways, motor vehicles must not change lanes arbitrarily or continuously, must adhere to the minimum and maximum speed limits, must not stop arbitrarily, must not occupy emergency lanes, and must report emergencies to the police promptly.

1

5

Share

Who gets penalized when caught by traffic police without a vehicle license: the driver or the owner?

When caught by traffic police without a vehicle license, the driver is the one who gets penalized. The relevant provisions of the Road Traffic Safety Law of the People's Republic of China are as follows: 1. Article 95 stipulates: If a motor vehicle driven on the road does not display a motor vehicle license plate, does not have an inspection compliance mark or insurance mark, or does not carry the vehicle license or driver's license, the traffic management department of the public security organ shall detain the motor vehicle and notify the party to provide the corresponding plates, marks, or complete the necessary procedures. 2. Article 90 stipulates: If a motor vehicle driver violates the road traffic safety laws and regulations regarding road traffic rules, they shall be given a warning or fined not less than 20 yuan but not more than 200 yuan. If there are other provisions in this law, the penalties shall be imposed in accordance with those provisions.

18

3

Share

Reasons for abnormal noise in the clutch pedal of Wuling Hongguang S

The reasons for abnormal noise in the clutch pedal of Wuling Hongguang S are as follows: 1. Severe wear or lack of oil in the release bearing, or the bearing return spring being too soft, broken, or detached; 2. Wear and looseness between the release lever bracket pin and the hole; 3. The pedal return spring being too soft, detached, or broken; 4. Loose rivets on the driven disc, fractured steel plates, or broken damping springs. Additional information: Fault diagnosis and troubleshooting: 1. Press the clutch pedal to make the release lever contact the release bearing. If a "grinding" sound is heard, it indicates noise from the release bearing. If the noise persists after lubrication, the bearing is worn or damaged. 2. After releasing the clutch pedal, increase the engine speed. If there is an intermittent impact sound, it indicates noise from the release bearing sliding back and forth. Remove the clutch bottom cover and check if the release bearing return spring is broken or detached. 3. If noise occurs when the pedal is fully depressed and disappears when released, it indicates wear and looseness between the intermediate pressure plate drive pin and the pin hole of the clutch. 4. If noise occurs when the clutch just engages or disengages while repeatedly pressing the pedal, it indicates wear and looseness between the release lever and the bracket pin and hole, or loose and exposed rivets. 5. If noise occurs when the engine starts and disappears when the pedal is lifted, it indicates burning or damage to the release bearing.

13

5

Share

Is It Normal for an Automatic Car to Make Abnormal Noises When Shifting to P Gear?

It is not normal for an automatic car to make abnormal noises when shifting to P gear. The noise could be the sound of the car unlocking, and the driving method should be adjusted promptly. Below are detailed introductions about automatic cars: 1. Overview: An automatic car generally refers to a car that uses an automatic transmission (AT) to adjust the speed. While driving, the control system of the automatic transmission automatically selects the appropriate gear based on the engine's speed and load, replacing the driver's subjective judgment of timing and gear shifting operations. In simple terms, an automatic car is a "fool-proof car." 2. Transmission Types: There are mainly two types of automatic transmissions used in cars. One is the stepped automatic transmission, and the other is the continuously variable transmission (CVT). The most commonly used in passenger cars is the mechanical continuously variable transmission.

14

3

Share

How to Deal with Peeling on Car Headlight Surface?

Is It Normal for an Automatic Transmission Car to Jerk When Stopping?

Can the Wuling Hongguang Mini support fast charging?

Is it allowed to reverse on highway ramps?

Who gets penalized when caught by traffic police without a vehicle license: the driver or the owner?

Reasons for abnormal noise in the clutch pedal of Wuling Hongguang S

Is It Normal for an Automatic Car to Make Abnormal Noises When Shifting to P Gear?

How to Drive a New Energy Vehicle?

Will the 2019 3-cylinder Lingpai shake after five years of driving?

How to Check Brake Fluid?

What are the steps for parking an automatic transmission car?