How to Deal with Nervousness During Driving Test Subject Two?

What are the materials used in new energy power batteries?

New energy power battery materials mainly include cathode materials, anode materials, electrolytes, and separators. Below is relevant information about new energy power batteries: 1. Introduction to new energy power batteries: The power batteries used in new energy vehicles are lithium-ion batteries, which can be structurally divided into cathode materials, anode materials, battery separators, electrolytes, and other components. From the perspective of cathode materials, new energy vehicle power batteries can be broadly classified into two types: lithium iron phosphate (LFP) batteries and ternary lithium batteries. 2. Relevant information about new energy power battery materials: Among the costs of power batteries, cathode materials account for the largest proportion, reaching 28.27%. The cost of cathode materials is primarily composed of lithium carbonate and various corresponding precursor materials. Anode materials account for 6.85% of the power battery cost, and the main resource required for anode material manufacturing is graphite, with the largest application field of graphite resources being steel smelting. Electrolytes are mainly composed of solutes (lithium hexafluorophosphate), solvents, and additives, with the preparation materials for lithium hexafluorophosphate primarily being lithium carbonate and corresponding fluorine products. Different power battery products have significant differences in the usage of separator materials. Taking lithium iron phosphate batteries as an example, separators account for 7.67% of the battery manufacturing cost.

10

1

Share

How to Handle Traffic Violations for Out-of-Town Vehicles in Shanghai?

Verify the authenticity of the traffic violation, as out-of-town violations can only be checked after seven to ten days. For on-the-spot ticketing violations, you can directly pay the fine at the vehicle management office, postal outlets, or the four major state-owned banks. For electronic surveillance violations, you can also confirm and pay the fine at the vehicle management office, postal outlets, or online. Additionally, vehicles with out-of-town license plates (excluding special vehicles such as police and emergency rescue vehicles) are prohibited from entering all elevated roads in Shanghai during the morning and evening rush hours on non-weekends and national holidays, from 7:00 AM to 9:00 AM and from 4:30 PM to 6:30 PM. Below are the relevant traffic restriction details: 1. Relevant regulations: To improve road traffic efficiency and ensure traffic safety and smoothness, Shanghai has prohibited the passage of certain small vans on some roads and areas. 2. Restricted vehicles: The types of vehicles subject to restrictions in Shanghai include out-of-town fuel vehicles, local fuel vehicles, out-of-town pure electric vehicles, local pure electric vehicles, out-of-town plug-in hybrid vehicles, and local plug-in hybrid vehicles.

3

4

Share

Does low car AC temperature consume more fuel or does high fan speed consume more fuel?

Turning on the AC consumes more fuel mainly because the AC compressor requires significant power to operate, while changes in fan speed have minimal impact on power requirements. Therefore, within a certain speed range or wind resistance, using the AC consumes more fuel, while turning it off saves fuel. As for the impact of AC fan speed on fuel consumption, it is negligible, including when only using the heater in winter. More details are as follows: 1. Fan speed is mainly related to the blower's speed: The blower's speed is maintained by the battery, meaning the speed of the fan has little to do with fuel consumption. Secondly, temperature is controlled by adjusting the mix of hot and cold air. Generally, if all windows are closed and the AC is set to recirculate air, and the temperature difference between inside and outside the car is not extreme (e.g., 18°C inside and 50°C outside), the temperature setting has minimal impact on fuel consumption. Theoretically, lower temperatures consume more fuel, but car AC compressors, unlike household ACs, cannot adjust frequency to save energy. 2. Engine power is mainly used to overcome air resistance: Studies show that at speeds above 80 km/h, engine power is primarily used to overcome air resistance (along with mechanical resistance and tire friction, etc.). Opening windows increases resistance significantly, far more than the AC compressor's resistance, so it's advisable to keep windows closed at higher speeds.

19

4

Share

Why Does the Radiator Run Out of Water?

The reasons for water shortage in the radiator are as follows: 1. Leakage at the hose connection or the hose itself; replace the hose or reinforce the seal. 2. Cracks in the cylinder block or a loose/damaged cylinder head gasket, causing water leakage. 3. Damaged seals or sand holes in the oil cooler, leading to water leakage. 4. The radiator cap is not tightly sealed. 5. Leakage in the heater radiator. 6. Leakage in the three-way connector. Methods to determine a three-way connector leakage are as follows: 1. Check if the exhaust pipe emits white smoke; if so, it may indicate water burning due to cracks in the cylinder block or a loose/damaged cylinder head gasket. 2. Cracks in the cylinder block may cause air to bubble up in the radiator, but without boiling over. 3. A loose or damaged cylinder head gasket can result in insufficient engine power. 4. Start the engine and use an absorbent cloth or tissue to check for leaks at various connections. 5. Fill the radiator with water (without capping it), start the engine, and rev it to around 2000 RPM to see if bubbles emerge from the radiator, which may indicate a deformed cylinder head. 6. For damaged oil cooler seals or sand holes, check the engine oil for water droplets or emulsification as a diagnostic measure.

6

3

Share

Is It Okay to Drive a New Car on a Long Trip?

It is possible to drive a newly purchased car on a long highway trip, but you should pay attention to the speed and engine RPM. It is best not to exceed 100 km/h and keep the engine RPM below 3000. Avoid driving for extended periods and ensure the vehicle gets sufficient rest. Here are specific precautions for driving a new car on the highway: 1. Speed Control: Do not exceed 100 km/h on the highway, avoid sudden acceleration or deceleration, and gently apply the brakes and throttle. 2. Pre-Trip Inspection: Before the trip, it's advisable to have the car checked at a 4S dealership (usually free). Inspect tire pressure and check for any leaks of fluids or oil. 3. Avoid Overloading: Overloading a new car can damage its components. For the first 1000 km, domestic cars should not exceed 75%-80% of the rated load capacity, while imported cars should not exceed 90%. Additionally, choose smoother road surfaces to minimize excessive vibration, impact, or emergency braking, reducing stress on the body and powertrain. 4. Take Breaks: For trips longer than 2 hours, take breaks at service areas—both the driver and the car need rest. Prolonged engine operation increases the likelihood of accelerated component wear.

8

2

Share

How to Set Up the Rearview Camera?

Step on the car's brake pedal and press the one-touch start button to turn on the dashboard and power up the vehicle. Shift the car's gear lever to the R position to engage reverse gear. Check if the rearview camera image is misaligned. Adjust the camera angle if necessary.

2

5

Share

How to Deal with Nervousness During Driving Test Subject Two?

What are the materials used in new energy power batteries?

How to Handle Traffic Violations for Out-of-Town Vehicles in Shanghai?

Does low car AC temperature consume more fuel or does high fan speed consume more fuel?

Why Does the Radiator Run Out of Water?

Is It Okay to Drive a New Car on a Long Trip?

How to Set Up the Rearview Camera?

Is it still necessary to display the auto insurance sticker now?

What to Do If Your Car Is Towed and You Can't Find It?

What Causes Car Air Conditioning Not to Cool During Midday High Temperatures?

What Causes the Engine Shutdown Indicator Light to Illuminate?