Browse

Antiques Collectibles Apparel Baby Kids Items Books， Movies And Music Electronics Free Stuff Garden Outdoor Health Beauty Home Goods Home Improvement Supplies Musical Instruments Office Supplies Pet Supplies Sporting Goods Ticket Toys Games Transportation Others

Used Cars New Cars Others

Business Crafts Design And Web Events Home Improvement Legal Lessons Personal Pets Photography Repair And Technical Support Wellness Writing， Translation， And Transcription Others

Activities & Groups Artists & Musicians Classes & Lessons Events Friendship & Networking Lost & Found Rideshare Sports Teams Volunteers Travel & Travel Partners Skills & Language Swap Other

How to Deal with Insufficient Car Tire Pressure?

1 Answers

LeJuliette

07/30/25 2:10am

Visually inspect whether the tire can still continue to drive. If it can, drive to the nearest tire repair shop for handling; if the tire pressure is too low to drive, use a car air pump to inflate it a little, then go to the nearest repair shop; or replace the spare tire and then go for repairs. According to the international GBT2978-2008 standard, the tire pressures for different tires are as follows: Standard tires: 2.4-2.5bar; Reinforced tires: 2.8-2.9bar; The maximum pressure should not exceed 3.5bar. Normal tire pressure in winter: In winter, adjust the tire pressure based on the standard car tire pressure, increasing it by about 0.2bar. Normal tire pressure in summer: Generally, the lower limit of the standard car tire pressure is sufficient. For example, the lower limit for standard tires is 2.4bar. If the car is often parked outdoors, the tire pressure can generally be about 0.1bar lower than the standard to avoid high-temperature blowouts.

Was this review help?

6

1

Share

More Forum Discussions

Which fuse is for the Haima Family wiper?

Haima Family wiper fuse is located inside the fuse box in the engine compartment. The following is a detailed introduction to the fuse: 1. Function: The fuse box is an overcurrent protection switch, mainly used to control the circuit operation. There are many circuits in a car, and the fuse serves to protect the circuits. When the circuit temperature is too high or the current is too large, the fuse can blow to protect the circuit. 2. Impact of blowing: There are many fuses and relays in the car fuse box. When a fuse blows, certain functions of the car will be affected. After the fuse blows, it needs to be replaced with a new one. 3. Replacement precautions: When replacing a fuse, use a special clip to remove the fuse. The fuse box in the engine compartment is generally located near the battery, while the fuse box in the cabin is usually located in the main driver's position or the glove box of the co-driver.

Can You Continue Driving After the Coolant Warning?

You should not continue driving after the coolant warning. The warning light indicates that the coolant level is low and needs to be refilled. Insufficient coolant can affect the engine's heat dissipation, and continuing to drive may cause the engine to overheat, leading to internal component failures. The method for replacing coolant: 1. Drive the vehicle into the lift operation area and open the coolant expansion tank cap. 2. Raise the vehicle to a suitable working height, then unscrew the plastic drain plug on the engine radiator to drain the coolant. 3. After the coolant is completely drained, lower the vehicle and tighten the drain plug on the radiator. 4. Pour new coolant into the expansion tank until it is full, then start the vehicle. The coolant level will drop significantly; simply top it up as needed. 5. After turning off the vehicle, raise it again and check for any leaks around the drain plug.

How many liters of engine oil does the Geely Xingyue require?

Geely Xingyue requires 3.5 to 4 liters of engine oil. Below are the specific functions of engine oil: 1. Shock absorption and cushioning: When the pressure in the engine cylinder rises sharply, it suddenly increases the load on the piston, piston chips, connecting rod, and crankshaft bearings. This load is transmitted and lubricated through the bearings, providing a cushioning effect against impact loads. 2. Rust and corrosion prevention: Lubricating oil adheres to the surface of parts, preventing contact with water, air, acidic substances, and harmful gases. 3. Lubrication and wear reduction: There is rapid relative sliding between the piston and cylinder, as well as between the main shaft and bearing shells. To prevent excessive wear, an oil film must be established between the two sliding surfaces. A sufficiently thick oil film separates the relatively sliding surfaces, reducing wear. 4. Cooling: Engine oil carries heat back to the oil tank and dissipates it into the air, helping the radiator cool the engine.

Can a 4S shop perform dent repair?

4S shops cannot perform dent repair. Here are the methods for repairing car dents: 1. Location and size: Determine the location and size of the car dent. 2. Deep dents: For deeper dents or larger areas, the pulling method can be used. 3. Repair: First, insert the glue stick into the glue gun and heat it for a few minutes. Then, apply the glue from the center to the edges slowly onto the suction cup. Use the residual heat to stick the suction cup to the stress point of the larger dent. Next, connect the T-shaped tool to the head of the suction cup and pull it out evenly with force. The dent will gradually recover. Use a hook under lighting to slowly push out small dented areas, and finally, use a rubber hammer to handle the slightly protruding parts. After a car dent occurs, it is best to seek out a specialized repair shop for the repair.

What is the difference between Leopard Super Select 4WD and mechanical 4WD?

The differences between Leopard Super Select 4WD and mechanical 4WD are as follows: 1. Quality difference: Traditional mechanical 4WD has a simple structure, reliable performance and quality, can withstand heavy loads, and can handle harsh road conditions for a long time with low maintenance costs; while the biggest advantage of electronic 4WD is its extremely fast response speed, low price, comfort and energy saving, but it is generally only suitable for urban and highway driving, and its reliability is not as good as mechanical 4WD, with high maintenance costs when problems occur. 2. Fuel difference: For fuel vehicles, current urban SUVs need to consider fuel economy, so most models use on-demand 4WD. For electric vehicles, because they do not require mechanical devices such as drive shafts, their 4WD is controlled by motors.

What Causes the Timing Chain Noise in the Highlander?

The timing chain noise in the Highlander is caused by a lack of tension in the chain tensioner, elongation of the timing chain, or abnormal wear of the guide chain plate. Below are specific details about the timing chain: 1. Function: The engine timing chain drives the valve train of the engine, ensuring that the intake and exhaust valves open or close at the appropriate times to allow normal air intake and exhaust in the engine cylinders. In some models, such as the Volkswagen Jetta, Bora, and Audi, it also drives the water pump. 2. Effects of Timing Chain Elongation: Under high-speed engine operation, the timing chain may stretch, wear, and develop increased gaps. If the timing chain elongates due to these gaps, it can lead to inaccurate timing and increased noise. If the timing chain wears or stretches due to aging, causing timing misalignment, the valve stems may bend, the piston tops may dent, and in severe cases, the cylinder head may be damaged, preventing the engine from functioning properly.

Trending Ranking

Where is the temperature sensor located on the Haval H6?

What aspects does the 5T model include?

Why does the Audi fan keep running after the engine is turned off?

What is the working principle of a 4-wire brake switch?

Which province does the license plate 'Su' belong to?

What are the symptoms of a faulty car mass air flow sensor?

Why is there no air coming from the rear vents of the Audi A8?

What is the reason for the Haima M5's anti-theft light flashing but the car not starting?

Is it necessary to perform the first maintenance at over 1,000 kilometers?

Where to Go for Vehicle Inspection?

More Forum Discussions

What does 'Unfixable Land Rovers, Indestructible Toyotas' mean?

Is it normal for the Highlander to occasionally make sounds after starting?

How to Purchase Commercial Insurance for a Total Loss Vehicle After Repair?

How Much Fuel Should You Add to Your Car Each Time?

Help

Cookie

Cookie Settings

© 2025 Servanan International Pte. Ltd.