···
Log in / Register

How to Deal with Abnormal Tire Pressure in Volkswagen Bora?

4 Answers
McEmery
08/31/25 8:41am

If the tire pressure in your Volkswagen Bora is abnormal, turn on the power to let the vehicle perform a self-check; then press and hold the tire pressure monitoring button in front of the gear shift lever to reset it. Tire pressure refers to the air pressure inside the tires, which is like the blood pressure of a car. The level of tire pressure plays a crucial role in the performance and power of the vehicle. Hazards of Overinflated Tires: Reduced friction and adhesion of the tires, affecting braking performance; causes steering wheel vibration and deviation, reducing driving comfort; accelerates uneven wear of the tread pattern in the center, shortening tire lifespan; increases vehicle vibration, indirectly affecting the lifespan of other components; overstretches the tire cords, reducing tire elasticity and increasing the load on the car while driving. Hazards of Underinflated Tires: Increases friction coefficient with the road surface, leading to higher fuel consumption; makes the steering wheel heavy and prone to deviation, compromising driving safety; increases movement in various parts of the tire, causing abnormal heat due to excessive rolling; weakens the function of cords and rubber, leading to delamination or cord breakage, and excessive friction with the rim, resulting in damage to the bead area and abnormal wear.

Was this review help?
18
2
Share
StManuel
09/13/25 4:52am

My Volkswagen Bora has been running for almost five years now, and the tire pressure warning light has come on more than once or twice. Every time the alarm sounds, I immediately pull over to a safe spot and use the small tire pressure gauge from the trunk to check the pressure of all four tires one by one. The standard tire pressure is usually listed on the sticker by the door, around 38 psi for a Bora. If it's low, just top it up to the standard level using an air pump at a gas station. Once, I found the rear tire pressure was too low and discovered a small screw had punctured it, causing a slow leak. Fixing it only cost me 20 yuan. Don’t ignore this warning—incorrect tire pressure increases fuel consumption and raises the risk of a blowout, especially on highways. Now, I make it a habit to check the tire pressure at the beginning of each month. A tire pressure gauge only costs 30-40 yuan, saving trouble and extending tire life. When the alarm goes off, don’t delay—either handle it yourself or head straight to a repair shop. Safety first.

Was this review help?
10
1
Share
Expand All
LillianaLee
10/27/25 5:40am

If the tire pressure warning light comes on in your Volkswagen Bora, don't just freeze—slow down immediately and find a safe place to pull over. As an average young driver, I rely on a portable tire pressure gauge to check each tire. First, locate the recommended pressure on the door jamb sticker (usually 35-40 psi), then measure each tire's pressure. If one is significantly low, it might have a puncture or leak; if overinflated, release some air to adjust. Resetting the TPMS system is simple—just hold the dashboard button for a few seconds. Remember, incorrect tire pressure not only wastes fuel but also compromises braking stability and safety. After learning my lesson, I now set monthly phone reminders to check tire pressure proactively. If you can't handle it yourself, visit a gas station or repair shop—never gamble with safety. Developing good habits ensures your car runs smoother and lasts longer.

Was this review help?
19
4
Share
Expand All
DeMatteo
12/10/25 5:54am

The tire pressure warning in my Volkswagen Bora went off, which is extremely dangerous. Immediately slow down and pull over to avoid continued driving that could lead to a tire blowout or loss of control. Check the tires for nails or obvious leaks, then measure the pressure to ensure it's within the standard range of 35 to 40 psi. Low tire pressure accelerates wear and increases fuel consumption, while high tire pressure raises the risk of a blowout. After adjustment, use the instrument panel's reset button to confirm the warning is cleared. In winter, tire pressure tends to drop due to lower temperatures, so more frequent checks are necessary. If the warning persists, visit a professional auto repair shop to check for sensor malfunctions or deeper issues. Proper tire pressure is essential for safe driving—don't delay in addressing it.

Was this review help?
19
2
Share
Expand All
More Forum Discussions

Should I shift to N or P gear when waiting at a red light with an automatic transmission?

When waiting at a red light with an automatic transmission, you should shift to N gear. The reason is: the P gear in an automatic transmission vehicle is the parking gear, used for long-term parking, while the N gear is the neutral gear, used when the car is temporarily stopped and not moving. Automatic transmission refers to not requiring the driver to manually shift gears; the vehicle will automatically select the appropriate gear based on driving speed and traffic conditions. The correct method for parking an automatic transmission vehicle is: 1. Press the foot brake to stop the car; 2. Shift the gear from D to N; 3. Pull the handbrake and turn off the engine; 4. Release the foot brake without turning off the power; 5. Press the foot brake again and shift the gear from N to P; 6. Release the foot brake and turn the key back; 7. Turn off the power and remove the key.
19
0
Share

How to Check if the Battery is Leaking?

To check if the battery is leaking, follow these steps: 1. Turn off the car's ignition switch and wait for about 5 to 10 minutes with the car locked, allowing it to enter a dormant state; 2. Loosen the fastening nut on the negative terminal of the battery, use a screwdriver to pry open the fastening block, and remove the negative connector; 3. Set the multimeter to the DC 10A or 20A range, connect the red probe of the multimeter to the car body ground wire, and the black probe to the negative terminal of the battery; 4. Observe the reading on the multimeter. The battery is a type of cell, also known as a storage battery, which works by converting chemical energy into electrical energy.
13
4
Share

What Does the Engine Symbol on the Dashboard Mean?

When the engine symbol appears on the dashboard, it indicates that the ignition switch is turned on, the control indicator light is illuminated, and it should turn off shortly after the engine starts. An engine is a machine that converts one form of energy into another, typically transforming chemical energy into mechanical energy. The reasons for the engine yellow light appearing on the dashboard include: 1. A clogged car air filter causing restricted airflow; 2. Faulty spark plugs, ignition coils, fuel pump, or blocked fuel lines leading to poor combustion of the engine's air-fuel mixture; 3. Improper maintenance increasing the engine's operational burden; 4. Poor fuel quality resulting in increased carbon deposits inside the engine cylinders.
13
1
Share

When is it appropriate to use high beams?

High beams can be used in the following situations: 1. Roads with no street lighting or poor illumination; 2. When overtaking another vehicle; 3. When navigating corners or curves; 4. When driving in conditions of low visibility such as fog, rain, snow, dust, or hail; 5. When needing to read road signs. The method to activate high beams is to push the light control lever outward. Their purpose is to enhance visibility and expand the field of view. Vehicle lights and their functions can be categorized as: 1. Headlights: Illuminate the road and objects ahead to ensure driving safety; 2. Width indicators: Show the vehicle's width to alert oncoming and following vehicles; 3. Fog lights: Make the vehicle more noticeable to oncoming and following traffic; 4. Turn signals: Alert nearby vehicles and pedestrians.
18
2
Share

What should be noted after replacing brake pads?

After replacing brake pads, the following precautions should be taken: 1. Press the brake pedal several times to eliminate the gap between the shoe and the brake disc; 2. Check the brake fluid; 3. Use a special tool to push the brake caliper piston back. Brake pads are composed of a steel plate, an adhesive heat insulation layer, and a friction block. The steel plate is coated to prevent rust, and during the coating process, an SMT4 furnace temperature tracker is used to monitor the temperature distribution to ensure quality. Situations that require brake pad replacement include: 1. When the thickness reaches about 0.3 cm; 2. When the brake warning light is on; 3. When a hissing sound occurs during braking; 4. When the braking effect is significantly weakened.
12
1
Share

Where in Guangdong does the license plate Yue Q belong to?

Yue Q is the license plate of Yangjiang City in Guangdong Province, with Yue being the abbreviation for Guangdong license plates. Other license plate codes in Guangdong Province are as follows: Yue A for Guangzhou, Yue B for Shenzhen, Yue D for Shantou, Yue E for Foshan, Yue F for Shaoguan, Yue G for Zhanjiang, Yue H for Zhaoqing, Yue J for Jiangmen, Yue K for Maoming, Yue L for Huizhou, Yue M for Meizhou, Yue N for Shanwei, Yue P for Heyuan, Yue C for Zhuhai, Yue R for Qingyuan, Yue S for Dongguan, Yue T for Zhongshan, and Yue U for Chaozhou. License plates, commonly known as tags, also refer to vehicle registration plates, which are plates hung at the front and rear of vehicles. They are typically made of aluminum, sheet metal, plastic, or paper, and display the vehicle's registration number, registration region, or other relevant information.
16
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.