How to Convert Tire Pressure?

What Should You Check Before Taking the Car on the Highway?

Before taking the car on the highway, you need to check the tires, engine oil, coolant, lights, and brakes. Here are the specific details: 1. Tires: Carefully inspect the appearance of each tire for any scratches. If it's just a rubber scratch, it doesn't affect usage, but if the inner tire cords are damaged, the tire must be replaced. If the tires haven't been rotated in over two years, it's best to swap the front tires with the rear ones. Thoroughly check the consistency of all four tires. Drive on a flat road without holding the steering wheel to see if the car moves straight; otherwise, get a four-wheel alignment immediately. 2. Engine Oil: Park the car on a level surface, wait for it to cool, then pull out the dipstick, wipe it clean, reinsert it fully, and pull it out again to check. The oil level should be between the minimum and maximum marks on the dipstick; it must not exceed these limits. 3. Coolant: Coolant prevents the engine's cooling liquid from freezing and expanding during cold winter stops, which could crack the radiator and engine block. Coolant should be used year-round. 4. Lights: This includes headlights, reverse lights, brake lights, turn signals, interior lights, fog lights, etc., especially fog lights—if there's an issue, replace them immediately. 5. Brakes: Check the thickness of the brake pads; if they seem too thin (less than 2mm), they need replacement. Drive at normal speed and test the brakes for any abnormalities. Park the car on a slope to check if the handbrake works effectively.

11

5

Share

What material is generally good for engine guard plates?

Golden Science alloy plastic steel protective plate material is the best, with the advantages of light weight, high strength, corrosion resistance, good resilience, fully enclosed, and does not affect the engine sinking. The following is more related introduction: Benefits of installing engine guard plates: 1. Prevent sand and stone scratches: This is very similar to the role of the guard plate, one relies on a plate, the other relies on a layer of protective film (paint), just like putting a case on a mobile phone, it is very easy to understand. 2. Prevent moisture: Rust is also one of the fatal injuries of the chassis, especially in the rainy southern regions, the acidic substances in the rain can damage the chassis. Therefore, anti-corrosion (or anti-rust) is also a very important point. 3. Reduce noise: As for noise reduction, mainly when gravel or foreign objects hit the bottom of the car, the sound is relatively loud, the chassis armor has a certain sound insulation effect. Temperature control is because the car air conditioning airflow generally moves from bottom to top, the chassis armor can provide a certain thermal insulation effect.

16

5

Share

How Many Months Does a Car Stay in Inventory Before Being Considered a Stock Vehicle?

Generally, a car that has been in inventory for more than three months or half a year can be considered a stock vehicle. For imported cars, due to factors such as transportation cycles, a car that is six months or more from its manufacturing date is also considered a stock vehicle. The method to check the production date of a new car is by examining the vehicle's nameplate, usually located on the passenger side or in the engine compartment. Here is some additional information: 1. Issues with stock vehicles: After leaving the factory, new cars may not be sold immediately and may not receive proper maintenance. Most stock vehicles are stored in open parking lots, exposed to sun and rain without basic upkeep, which can lead to moisture and aging of various fluids, electronic components, batteries, rubber seals, and tires. 2. What to do if you buy a stock vehicle: If the car has been in inventory for over a year, you can request the dealership to replace the original engine oil. Additionally, check the production date of the tires, as new tires older than two years may face rubber aging risks, so you should also ask the dealership to replace them. If these two aspects are not problematic, the stock vehicle should not affect its usability.

1

3

Share

Should the Cadillac XT5 use 92 or 95 octane gasoline?

The Cadillac XT5 should use 95 octane gasoline, as this is the recommended fuel grade specified in the vehicle's official user manual. In addition to checking the appropriate gasoline grade in the user manual, you can also find this information on the fuel tank cap, where it is usually indicated. Typically, the fuel grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. If the compression ratio is even higher, 98 octane gasoline is recommended. However, with the application of new technologies, the compression ratio alone cannot determine the appropriate gasoline grade. High compression ratio engines can also be tuned to use lower octane gasoline due to other influencing factors such as ignition timing, turbocharging technology, and Atkinson cycle technology. Generally, the higher the gasoline grade, the higher the octane number and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. If the Cadillac XT5 occasionally uses the wrong gasoline grade, simply switch back to the correct grade after the current tank is used up. However, prolonged use of the wrong gasoline grade can have the following effects: For vehicles designed for lower octane gasoline, using a higher octane grade will not cause damage, but the increased octane number may alter the fuel's ignition point, leading to delayed combustion. This can reduce the engine's power output and thermal efficiency, resulting in poorer performance. For vehicles designed for higher octane gasoline, using a lower octane grade can cause engine knocking. The significantly lower octane number reduces the fuel's ignition point, causing premature ignition during the compression stroke. If combustion occurs before the spark plug fires, resistance is generated during the upward stroke. This resistance makes the engine run very unevenly. Mild knocking may only increase noise without significant engine damage, but severe knocking indicates serious engine conditions. The vibrations not only affect driving stability but can also cause abnormal wear on pistons and cylinders, and in extreme cases, even cylinder scoring.

9

3

Share

Is Part-Time Four-Wheel Drive Useful in Urban Areas?

Part-time four-wheel drive systems can be very useful on some slippery urban roads. Relevant information about part-time four-wheel drive systems is as follows: 1. Modes: A part-time four-wheel drive system allows the driver to switch modes. Generally, there are three modes: high-speed four-wheel drive mode, low-speed four-wheel drive mode, and high-speed two-wheel drive mode. Both high-speed two-wheel drive mode and high-speed four-wheel drive mode can be used on urban roads. 2. High-speed four-wheel drive mode: After switching to high-speed four-wheel drive mode, a vehicle equipped with a part-time four-wheel drive system performs similarly to one with a full-time four-wheel drive system. Four-wheel drive can enhance the vehicle's mechanical grip, thereby improving driving stability and safety. If driving on slippery surfaces, the four-wheel drive system can also be very useful.

20

1

Share

Is Installing a Roof Rack Considered Illegal?

Privately installing a roof rack is not considered illegal as long as it does not exceed the specified height. Exceeding the height limit will result in a 1-point deduction by traffic police. Below is more information about installing roof racks on vehicles: 1. Legal Basis: Article 54 of the "Road Traffic Safety Law Implementation Regulations." 2. Height Regulations: (1) For heavy and medium-duty trucks, semi-trailer cargo, the height from the ground must not exceed 4 meters; for vehicles carrying containers, it must not exceed 4.2 meters. (2) For other cargo-carrying motor vehicles, the height from the ground must not exceed 2.5 meters. (3) For motorcycles, the height from the ground must not exceed 1.5 meters, and the length must not exceed the body by 0.2 meters. The width of cargo on two-wheeled motorcycles must not exceed the handlebars by 0.15 meters on each side; for three-wheeled motorcycles, the width must not exceed the body. Passenger vehicles are not allowed to carry cargo except on external roof racks and built-in luggage compartments. For passenger vehicles, cargo on roof racks must not exceed 0.5 meters in height from the roof or 4 meters in height from the ground.

2

1

Share

How to Convert Tire Pressure?

What Should You Check Before Taking the Car on the Highway?

What material is generally good for engine guard plates?

How Many Months Does a Car Stay in Inventory Before Being Considered a Stock Vehicle?

Should the Cadillac XT5 use 92 or 95 octane gasoline?

Is Part-Time Four-Wheel Drive Useful in Urban Areas?

Is Installing a Roof Rack Considered Illegal?

What to Pay Attention to When Learning to Drive in Winter?

What to do if the driver's license is overdue?

Can Water Enter the Transmission After a Car Drives Through Water?

What Are the Car Light Indicators?