How to Connect the Trunk Speaker Wires for the 2018 Geely Vision?
2 Answers
Here are the installation steps for the trunk speaker wires of the 2018 Geely Vision: 1. First, fold down the rear seats and remove the three plastic screws on the back of the seats. Pry them up and pull them out, then remove the side panels. 2. Next, lift the rear door sill plates and remove the front door sill plates. Then, dismantle the navigation center console, starting with the silver decorative panel on the far right. Pry it up and remove the four screws on the console. Positions 1, 2, 6, and 8 correspond to the rear left and right speaker jacks. 3. After connecting the wires, route them from the center console along with the rear taillight wires to the rear speakers. There are a total of four wires. Once the speaker screws are secured, turn on the music to test the connections, ensuring to distinguish between left and right. The advantage is that the center console sound effects can be adjusted. 4. After installing the speakers, reassemble everything in the reverse order of disassembly. The sound will be perfect with excellent effects.
When I was adding speaker wires to the trunk of my 2018 Geely Vision, I found it quite interesting. First, locate the reserved interface position in the trunk, usually behind the left inner trim panel—some owner’s manuals even have diagrams for guidance. Use wire strippers to prepare the wire ends—red is positive, black is negative—just plug them into the interface. If there’s no reserved interface, you’ll need to run wires from the audio head unit. The job requires tools like electrical tape and wire splitters; I bought mid-range stuff from the hardware store. The key step is disconnecting the battery’s negative terminal to avoid short circuits—I forgot at first and blew a fuse, costing a few bucks. DIY feels awesome, and the sound after installation is fantastic, but don’t overcomplicate it—30 minutes tops. Remember to test the sound; I usually play some light music to check the effect.
