How to Connect the Reversing Camera Wiring?

[NadiaDella]

The method for connecting the reversing camera wiring is as follows: 1. Insert the original accessory camera wiring harness into the rear license plate light hole, then snap it directly into place; 2. Remove the trunk liner, pull out the waterproof wiring grommet, use a pulling wire to draw the camera wiring harness into the trunk, guide the camera wiring harness and data connector into the grommet wiring hole, and finally reinstall the waterproof grommet; 3. Remove the left decorative panel of the trunk, connect the combined data and power extension cable to the camera wiring harness, and guide it along the original vehicle wiring harness from inside the rear trim panel; 4. Peel back the door seal on the left side of the rear seat, guide the wiring into the rear cabin, and pull out the combined data and power plug along with the remaining extension cable; 5. Restore the trunk, tuck the extension cable into the plastic panel gap along the door seal, all the way to the edge of the driver's cabin door; 6. Remove the storage box below the headlight, pass it above the OBD interface, and then connect the wiring port to the navigation device's interface.