How to Connect Motorcycle Wiring for Ignition?

1 Answers
StAmelia
07/24/25 8:13pm
The black wire is used for the stator ignition coil of the magneto, connecting to the socket of the two-pin plug on the ignition unit. The blue-white and green-white wires are for the stator trigger coil. The red and yellow wires are used for the lighting coil, connecting to the rectifier. The ignition unit has a total of two wires that need to be connected; the rest can simply be plugged in.
Was this review help?
8
4
Share
More Forum Discussions

How to Use the Cruise Control in the Buick Excelle?

The control indicator light on the instrument cluster illuminates white. Accelerate to the desired speed, then press the SET/- button to save and maintain the current speed. The control indicator lights on the instrument cluster will illuminate green. At this point, the accelerator pedal can be released. Pressing the accelerator pedal will increase the vehicle speed.
1
0
Share

What to Do When the Car Doesn't Supply Fuel During Ignition?

If the fuel pump diaphragm is cracked or damaged, gasoline may leak into the crankcase, diluting the engine oil and causing the oil level to rise, which can be checked using the oil dipstick. It should be replaced promptly. Ensure that all individual pieces and the holes on the pump body are properly aligned, and the fastening nuts are securely tightened. When disassembling, first clamp the diaphragm pull rod in a bench vise, remove the nuts, and take out the old diaphragm.
1
0
Share

What to Do When the Car Radiator Water is Too Dirty?

Slowly add radiator automatic cleaner into the radiator until the coolant reaches the normal level, then tighten the radiator cap. Allow the water temperature to reach normal operating temperature, then run the engine for 1-40 hours as needed. If there are hard water deposits in the cooling system, extend the running time to 10-48 hours. Drain the coolant containing deposits and replace it with antifreeze or clean coolant. Clean the radiator with automatic cleaner once a year.
13
0
Share

How to Connect Car Audio Wires?

Connect the two 6-inch speakers in parallel at the front doors, with the white wire connecting to the front right speaker. The gray wire connects to the front left speaker. Sony CD players cannot directly drive subwoofers; if the subwoofer has a built-in amplifier, you can add a low-frequency line to the RCA interface.
12
5
Share

How to Replace Summer Windshield Washer Fluid in Winter?

If it's the same brand of windshield washer fluid, there's no need to drain the summer fluid - you can directly add the winter fluid as they are mixable. For different brands, first completely drain the summer fluid before pouring in the winter formulation. To remove summer fluid, simply hold down the windshield washer button until the system is emptied. Locate the filler neck (typically marked with a washer symbol and blue cap), open the cap, and pour in the winter windshield washer fluid.
6
0
Share

What to do if the car's PS won't start?

Be sure to refuel at regular gas stations, and you can bring a gauze to wrap around the fuel gun nozzle when going out to filter impurities. Poor quality antifreeze can easily cause the engine to freeze and crack, resulting in the car's water pump being unable to operate and the car not starting. It is necessary to add suitable antifreeze. Excessive carbon buildup in the vehicle can cause the car not to start. Frequently driving at high speeds can reduce carbon buildup.
3
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.