How to Connect CarPlay in Lexus?

What is the fuel tank capacity of the 2019 Audi A4L in liters?

2019 Audi A4L has a fuel tank capacity of 56L, while the 45TFSI quattro version has a capacity of 58L. This data is official. Owners of the 2019 Audi A4L can also check this information in the vehicle's configuration sheet. The 2019 Audi A4L is equipped with two different displacement engines. Models with the 1.4TL turbocharged engine use 95-octane fuel, with an NEDC combined fuel consumption of 5.8L per 100km, allowing a range of 965km on a full tank. Models with the 2.0T turbocharged engine also use 95-octane fuel, with an NEDC combined fuel consumption of 6.2L per 100km, allowing a range of 903km on a full tank. The 45TFSI quattro National V model has an NEDC combined fuel consumption of 6.9L per 100km, allowing a range of 840km on a full tank. The 45TFSI quattro National VI model has an NEDC combined fuel consumption of 7.2L per 100km, allowing a range of 805km on a full tank. During daily driving, it is necessary to pay attention to the remaining fuel level in the tank. This is usually observed through the fuel gauge inside the car. If there are no other issues, the fuel level will be accurately reflected on the gauge. The fuel gauge typically has 5 to 6 segments, and it is advisable to refuel when there are 2 segments left to avoid running out of fuel midway. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the fuel tank capacity marked by the manufacturer is from the bottom of the tank to the safe limit, and there is additional space from the safe limit to the tank opening. This space ensures that the fuel can expand when the temperature rises without overflowing. If the tank is filled to the opening during refueling, the actual amount of fuel added may exceed the marked capacity. Other factors affecting vehicle fuel consumption include: Vehicle weight: There is a direct correlation between vehicle weight and fuel consumption. A 10% reduction in weight can lead to a corresponding reduction in fuel consumption. Vehicle aerodynamics: A lower drag coefficient results in noticeably lower fuel consumption. A higher drag coefficient increases fuel consumption proportionally. Low tire pressure: This increases tire friction and adhesion, leading to higher fuel consumption. Driving habits: Rapid acceleration and frequent braking can significantly increase fuel consumption. Wind direction: Driving with a tailwind reduces fuel consumption, while driving against a headwind increases engine workload and fuel consumption. Road conditions: Driving on flat roads consumes less fuel compared to uneven or steep roads. Use of additional electronic devices: Using devices like air conditioning while driving increases fuel consumption.

19

4

Share

Where is the New Santana Produced?

New Santana is produced in Shanghai. Santana Configurations: The entire Santana lineup is equipped with RKA tire pressure monitoring system, standard ESP electronic stability program, HBA hydraulic brake assist, ASR traction control system, and other safety features. Powertrain: Powered by a 1.5L naturally aspirated engine. The China V version delivers maximum power of 81kW (110PS) with peak torque of 150Nm, while the China VI version produces 82kW (111PS) and 145Nm, paired with either a 5-speed manual or 6-speed automatic transmission.

8

1

Share

Where is the air filter located in the Volkswagen CC?

The air filter in the Volkswagen CC is installed above the footwell on the passenger side. Below are the steps to replace the air filter: 1. Open the engine hood of the Volkswagen CC. 2. Use a T25 screwdriver to remove the screws and take off the air filter cover. 3. Loosen the screws, and the waterproof panel can be removed directly outward. 4. Press the clips with both hands, pull out the clips, and then lift the air filter box. 5. Remove the old air filter upward from the filter frame. 6. Install the new air filter onto the filter frame. Once the air filter is secured on the filter frame, it can be installed back into the vehicle.

20

4

Share

Where is the active braking system in the Tayron?

The settings page on the central display console provides detailed information about the active braking system: 1. It alerts you with audible and visual warnings when a potential front-end collision is detected. Sensors in the front of the vehicle monitor the road ahead to warn you if you are approaching another vehicle too quickly or if there is another critical situation involving an oncoming object. 2. Upon receiving a warning, you should apply the brakes. However, if the brakes are not used or insufficient force is applied, the automatic emergency braking technology can activate. This will actually apply the brakes to slow the vehicle down, avoiding a potential collision or minimizing possible damage. 3. How to retrofit a vehicle that does not come equipped with an active braking system.

17

1

Share

Where is the OBD interface of Haima M3?

The OBD interface of Haima M3 is located behind the storage box on the driver's side. Here are detailed introductions about the OBD interface of Haima M3: 1. The OBD function is the same for all vehicles. It is a mandatory configuration installed by the state to prevent vehicle exhaust from exceeding standards and polluting the environment, and it is not very useful for car owners. 2. OBD is the abbreviation of On-Board Diagnostics, which is translated into Chinese as "On-Board Automatic Diagnostic System". This system will monitor whether the vehicle's exhaust exceeds the standard at any time based on the engine's operating conditions, and will issue a warning immediately if it exceeds the standard.

19

1

Share

Is 'ON' for On or Off?

ON means the power is turned on, indicating the active state, while OFF means the power is turned off. Below are specific introductions to common car buttons: 1. MUTE button: MUTE can mute the sound with one press. 2. SEL key menu selection confirmation button: The SEL key is generally located on the multifunction steering wheel. The OK key has the same function as the SEL key, but some cars use SEL while others use OK. 3. VOL+/- are volume adjustment buttons: VOL is the abbreviation of the word 'volume', which can adjust the volume of the car audio.

7

4

Share

How to Connect CarPlay in Lexus?

What is the fuel tank capacity of the 2019 Audi A4L in liters?

Where is the New Santana Produced?

Where is the air filter located in the Volkswagen CC?

Where is the active braking system in the Tayron?

Where is the OBD interface of Haima M3?

Is 'ON' for On or Off?

Is Automotive Air Conditioning Leak Sealant Effective?

How long does it take to pick up a car after ordering?

What car has the WEY logo?

Is the Timing Mark on the Peugeot 408 Crankshaft Pulley Useful?