How to Close the Hood of the Buick Excelle?

[VanAriel]

Method to close the hood of the Buick Excelle: First, lower the front hood support bracket, then hold the hood with your other hand and slowly lower it. When the hood is about 50 to 60 millimeters from closing, release it to allow it to fall freely. You will hear a 'clunk' sound indicating that it is locked. If you do not allow the hood to fall freely, the engine hood may not close properly. After the hood is locked, check to ensure it is securely closed. The Buick Excelle is a compact car under the SAIC-GM Buick brand. The car has a length of 4609 mm, a width of 1798 mm, a height of 1464 mm, and a wheelbase of 2640 mm. In terms of power, the Buick Excelle is equipped with a naturally aspirated engine with a maximum horsepower of 113 hp, a maximum power of 83 kW, a maximum torque of 141 Nm, a maximum power speed of 6000 rpm, and a maximum torque speed of 4400 rpm.

[McFelicity]

I remember once helping my dad close the hood of his Buick Excelle. First, I had to make sure the support rod was fully retracted, otherwise it would get stuck. Holding the hood, I lowered it to about 30 centimeters above the latch—not too high or too low—then let it drop freely. A clear 'click' sound meant it was securely locked. I always liked to give the front edge of the hood an extra push with my hand; if it didn't budge, it was properly closed. Remember, never close the hood immediately when the engine is hot, as the coolant pipes might not have reset yet. Also, if it doesn't close properly, check if there's a misplaced rag or tool stuck along the edges of the engine bay.

[LucilleMarie]

My old Buick has been running for eight years, and there's a proper way to close the hood. Stand at the front of the car, lift the hood with both hands, and don't rush to let it go. First, make sure both hydraulic struts have retracted properly. Then, lower it steadily to about two fist-widths above the hinge position. At this point, release it decisively—don't hesitate or hold it mid-air. After the 'bang' of impact, immediately press down on the edge of the hood right above the emblem with your palm. If you feel a slight bounce, it means the latch has engaged securely. If you're doing this on a rainy day, remember to dry your hands first—wet metal hinges can easily slip out of place.

[CarlosDella]

Closing the hood of the Buick Excelle is actually a three-step process: First, secure the support rod back into its original position. Then, let the hood drop freely a short distance to engage the primary latch. Finally, press firmly with your entire palm on the center of the front end. Last time I found the hood not fully closed was due to fallen leaves stuck in the hinge groove, and it closed properly after cleaning. If it won't close, don't repeatedly slam it—check if there's a small stone stuck in the lock or if the support rod isn't fully retracted.

[AubreeLynn]

My neighbor's newly purchased Excelle once had an issue where the hood wouldn't close properly. I discovered it was caused by the hydraulic strut not resetting to its correct position, leading to misalignment. The correct operation is to lift the hood with both hands to a 45-degree angle and then release, allowing the inertia to engage the latch automatically. After closing, it's advisable to walk around the hood seam to check if the gaps are even. Significant differences between left and right gaps may indicate hinge deformation. Additionally, avoid placing fingers near the hinge area during operation to prevent pinching. Finally, pressing down on the center of the hood panel is the safest method for securing it.