How to Clean Carbon Fiber?

[LeKai]

Heating carbon fiber under the protection of inert gas can remove adsorbed water and improve structural strength. Add ozone to a tube furnace and perform oxidation treatment at a high temperature of 600 degrees.

[DiAllison]

When cleaning carbon fiber components, I first ensure the vehicle is completely cooled to prevent thermal stress damage to the fiber material. Then, I use low-pressure water flow to rinse off surface dust and coarse sand, avoiding high-pressure washers to prevent scratching the fibers. Next, I take a soft cloth dipped in a diluted solution of mild dish soap and gently wipe away stubborn stains. Never use strong chemical cleaners like gasoline or degreasers, as they can corrode the surface paint layer. After rinsing thoroughly, I dry it with a microfiber cloth or let it air dry naturally to prevent water spots from leaving marks. Doing this weekly or during every car wash helps maintain aesthetics while extending the component's lifespan.

[StManuel]

Cleaning carbon fiber might seem simple, but it requires attention to detail. I typically use a pH-neutral dedicated car cleaner because it's gentle and won't damage the surface. First, use compressed air to blow away dust, reducing friction during wiping. Then, lightly dip a soft-bristle brush in water and scrub in circular motions, focusing on removing dirt from crevices. After rinsing, I thoroughly dry it with a clean, soft cloth to ensure no moisture remains. Don't forget to avoid working under direct sunlight, as high temperatures can make the fibers brittle. A frequency of once every two weeks is sufficient.

[OBryce]

Here's how I usually clean carbon fiber parts: mix warm water with a small amount of neutral soap to create a foamy solution, then gently wipe with an ultra-soft sponge. For oil stains, avoid scrubbing too hard—keep the motion gentle and even. Rinse with a light stream of ordinary tap water. Finally, let it air-dry or use a clean, dry cloth to absorb water droplets. Remember, the material is delicate, so avoid rough tools like steel wool. This method is practical and quick.