How to Claim Compensation for Lost Wages When Rear-Ended and the Other Party is Fully at Fault?

1 Answers
Teixeira
07/29/25 1:48am
Negotiation is possible. If the vehicle is not a commercial vehicle, lost wages and transportation expenses should be calculated together. If it is a commercial vehicle, lost wages need to be calculated. If negotiation fails and the individual believes their losses are significant, they can seek resolution through litigation.
Was this review help?
12
3
Share
More Forum Discussions

What is the data stream channel number for the Volkswagen throttle?

The data stream channel number for the Volkswagen throttle is 060. Below is a detailed introduction about the throttle: 1. Introduction to the Throttle: The throttle is a controllable valve that regulates the airflow into the engine. There are two types: the traditional cable-operated throttle and the electronic throttle. After entering the intake pipe, the air mixes with gasoline to form a combustible mixture, which then burns to generate power. The responsiveness of the vehicle's acceleration is closely related to the cleanliness of the throttle. 2. Classification of the Throttle: There are two types of throttles: the traditional cable-operated throttle and the electronic throttle. In traditional engines, the throttle control mechanism operates via a cable (flexible steel wire) or a rod, with one end connected to the accelerator pedal and the other to the throttle linkage plate. The electronic throttle primarily uses a throttle position sensor to adjust the throttle opening angle based on the engine's power requirements, thereby regulating the amount of air intake.
11
0
Share

What sound does a faulty tensioner make?

The sound of a damaged tensioner is a buzzing or squeaking noise. The following are symptoms of a faulty tensioner: 1. If the tensioner pulley fails, the engine's timing may skip, causing ignition and valve timing to become disordered. The engine may shake and have difficulty starting, and in severe cases, it may not start at all. If the car does start, it could deform the valves. 2. It is recommended to replace the tensioner pulley immediately. The tensioner pulley mainly consists of a fixed housing, tension arm, pulley body, torsion spring, rolling bearing, and spring bushing. 3. It can automatically adjust the tension according to the tightness of the belt, ensuring the stability, safety, and reliability of the transmission system. 4. The function of the tensioner pulley is to adjust the tightness of the timing belt, but its lifespan is not very long. Many cars experience the tensioner failing before the belt does. Generally, the tensioner pulley is replaced together with the timing belt.
10
5
Share

What is the fuel consumption of the GAC Trumpchi GS8?

The fuel consumption of the Trumpchi GS8 is approximately 9.6L/100Km for the two-wheel-drive version and around 9.9L/100Km for the four-wheel-drive version. Here are specific methods to reduce fuel consumption: 1. Lightly press the accelerator: When starting at low speeds, the car consumes the most fuel. Therefore, gently pressing the accelerator during startup can prevent excessively high RPM and effectively reduce fuel consumption. 2. Avoid high RPM: Try to avoid unnecessary high RPM as fluctuating engine speeds can significantly increase fuel consumption. 3. Regular maintenance: Change the engine oil and remove carbon deposits. 4. Avoid sudden braking: Anticipating road conditions in advance not only enhances driving safety but also saves fuel. For example, gradually slowing down before traffic lights and utilizing inertia to coast.
14
3
Share

How to Turn on the Hazard Warning Lights?

The hazard warning light switch is independent, featuring a red triangle. Press it once to activate the hazard lights. Below is relevant information about hazard warning lights: 1. Definition and Usage: The hazard warning lights are also known as emergency flashers. Commonly referred to as 'hazard lights', the technical term is hazard warning lights. The button is located in the center of the dashboard, marked with a red triangle. Pressing it will cause all four turn signals to flash. 2. Usage Scenarios: Hazard warning lights are the highest level of warning lights, so many people instinctively turn them on in heavy fog. However, this practice is prohibited in some countries because it can make it difficult for following vehicles to determine the direction of the vehicle ahead. It is especially important to note that you should never change lanes with the hazard lights on. Avoid changing lanes in foggy conditions whenever possible. If lane change is necessary, turn off the hazard lights and use the turn signals instead.
3
2
Share

Where is the license plate 'Yu Z' from?

Currently, there is no 'Yu Z' license plate. 'Yu' is the abbreviation for Henan Province. The license plate codes for various cities in Henan Province are as follows: Yu A is Zhengzhou, Yu B is Kaifeng, Yu C is Luoyang, Yu D is Pingdingshan, Yu E is Anyang, Yu F is Hebi, Yu G is Xinxiang, Yu H is Jiaozuo, Yu J is Puyang, Yu K is Xuchang, Yu L is Luohe, Yu M is Sanmenxia, Yu N is Shangqiu, Yu P is Zhoukou, Yu Q is Zhumadian, Yu R is Nanyang, Yu S is Xinyang, and Yu U is Jiyuan. License plates serve as identification and information registration for vehicles. Their primary function is to indicate the region to which the vehicle belongs and to allow the vehicle's owner and registration information to be traced based on the license plate.
4
4
Share

How to reset the maintenance light on the Haima S5?

Haima S5 maintenance light is located on the dashboard, and the reset is done using a computer for maintenance clearance. As driving time increases, the wear and tear of internal vehicle components gradually becomes more severe. To ensure normal operation of the car, manufacturers have set up some reminder indicator lights during production. After reaching a certain mileage, the owner must promptly replace the components. After successful replacement, it is also necessary to reset the car's maintenance light. Additional Information: Regularly pay attention to cleaning the car's filters. During the use of the car's internal combustion engine, dust and other impurities will continuously mix into the engine oil, while the oxidation effect of air and combustion exhaust gases on the oil will gradually cause the oil to form gum or sludge. This not only accelerates the wear of parts but also easily causes oil passage blockages. Therefore, it is necessary to clean the car's filters regularly.
11
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.