How to Choose a Vehicle License Plate Number Online?

What does it mean when the ABS warning light is on in a car?

The display of ABS on a car indicates a malfunction in the vehicle's anti-lock braking system. During emergency braking, if the wheels lock up, the vehicle may lose control and skid, preventing the driver from slowing down or adjusting the vehicle's trajectory, which poses significant safety risks. There are several conditions under which the ABS light may illuminate, each with different causes and solutions, as detailed below: Condition 1: ABS warning light stays on continuously (most common). Cause 1: The ABS speed sensor's sensing area is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle's speed and the wheel's slip rate, thus failing to issue appropriate commands to adjust braking. Solution: Clean the dirt from the speed sensor and adjust the gap between the speed sensor and the signal ring to restore normal function. Cause 2: Poor signal due to loose connections between system wires or poor contact in the ABS relay, leading to system failure. Solution: Check the wire connections and reconnect any loose parts. Condition 2: ABS warning light intermittently illuminates and turns off when accelerating. Cause: When multiple vehicle electrical devices are in use, the battery voltage drops below 10.5V. As the engine speed increases, the voltage rises, and the ABS warning light turns off. This may also occur if the ABS system's power supply voltage is too low, such as due to poor terminal contact or grounding. Solution: Check the battery's specific gravity; inspect the charging system; examine the power supply (e.g., voltage relay or poor power contact). Condition 3: ABS warning light stays on after engine start until the engine is turned off (IGFF). Cause: Poor grounding contact in the ABS hydraulic valve body; poor contact in the ABS hydraulic valve body's wiring connector; ABS computer malfunction. Solution: Loosen the grounding screw of the hydraulic valve body, then retighten it, cleaning the contact surface if necessary; check if the connector gap has widened; replace the ABS or ABS/ASR computer. Condition 4: ABS warning light illuminates during high-speed driving. Cause: At high speeds, the ABS computer detects a significant discrepancy between the rear and front wheel speed signals; incorrect tire or wheel rim specifications. Solution: Refer to the vehicle's tire and wheel rim specifications, as indicated on the label near the fuel tank cap. Condition 5: ABS warning light intermittently illuminates. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: With the engine running, press the brake pedal, push the brake switch linkage down fully with a finger, then release the brake pedal to complete the self-setting position; replace the brake light switch if necessary.

9

3

Share

What is the fuel consumption of the Chery QQ?

There are 4 models of the Chery QQ. The 2013 1.0L AMT Cruise Edition, Manual Fashion Edition, Happy Edition, and Vitality Edition are all equipped with a 69-horsepower engine, with an NEDC fuel consumption of 5.1L per 100km. This data is official. The fuel tank capacity of the Chery QQ is 35L. With a full tank, it can travel approximately 35/5.1*100=686km. Taking the 2013 Chery QQ as an example, its body structure is a 5-door, 5-seater hatchback. The dimensions are: length 3564mm, width 1620mm, height 1527mm, wheelbase 2340mm, front track 1390mm, rear track 1365mm, fuel tank capacity 35L, luggage compartment volume 190L, and curb weight 936kg. The 2013 Chery QQ has a MacPherson independent front suspension and a longitudinal trailing arm non-independent rear suspension. It is powered by a 1.0L turbocharged engine with a maximum output of 69PS, maximum power of 51kW, and maximum torque of 93Nm, paired with a 5-speed manual transmission. Vehicle fuel consumption is directly related to five major factors: driving habits, the vehicle itself, road conditions, natural wind, and environmental temperature. Specific factors that increase fuel consumption include: Driving habits: Aggressive driving behaviors such as sudden acceleration, frequent overtaking, and not easing off the throttle before red lights can increase fuel consumption. The vehicle itself: Vehicles with larger displacements generally consume more fuel than those with smaller displacements because larger displacements typically produce more power, requiring more gasoline for combustion. Heavier vehicles also have higher fuel consumption due to the need for greater driving torque. Road conditions: Driving on dirt roads, muddy roads, soft surfaces, or mountainous roads increases resistance and fuel consumption. Natural wind: Driving against the wind or on windy days increases vehicle resistance and fuel consumption. Low environmental temperatures: When the engine block is cold, the injected gasoline is less likely to vaporize, requiring more gasoline for combustion, which increases fuel consumption. Additionally, the engine control unit may operate at higher RPMs to warm up the engine in cold temperatures, further increasing fuel consumption.

18

5

Share

What Causes Small Bubbles in the Radiator and Constant Water Loss?

Radiator water loss can be attributed to the following reasons: 1. Hose issues: Leaks at hose connections or the hose itself, requiring replacement or reinforced sealing; 2. Cylinder block problems: Cracks in the cylinder block, or a loose/damaged cylinder head gasket causing coolant leakage; 3. Cooling system issues: Damaged seals or sand holes in the oil cooler leading to coolant mixing. After the radiator boils over, poor engine cooling and excessive temperature cause component expansion, reducing clearance between parts. Additionally, high temperatures lower oil viscosity, accelerating part wear. If not addressed promptly, severe engine damage or mechanical failure may occur.

18

2

Share

How to Install the Memory Card for the 14th Generation Sylphy Dash Cam?

14th Generation Sylphy Dash Cam simply requires inserting the memory card into the memory card slot. Below are some related details about the Sylphy: 1. Dimensions: The body length, width, and height are 4641/1815/1447mm respectively, with a wheelbase of 2712mm. 2. Features: Equipped with the latest Nissan Intelligent Mobility technology, including IFCW Intelligent Forward Collision Warning, Blind Spot Warning (BSW), Lane Departure Warning System, Rear Cross Traffic Alert, and Intelligent Driver Alertness Monitoring. 3. Powertrain: Powered by a 1.6L naturally aspirated engine with a maximum output of 126 horsepower, paired with a CVT transmission.

20

3

Share

Does the Magotan Really Have So Many Problems?

Minor issues being common is a widespread problem among many domestic cars, and the same goes for Brilliance BMW. Compared to other joint-venture brands, Volkswagen cars are actually quite durable. The price of spare parts is somewhat high, but many parts are currently imported. Once the localization rate of parts increases, this issue can be resolved. Below is an introduction to the Magotan: 1. Overview: The Magotan is a mid-sized sedan launched by FAW-Volkswagen, featuring a refined exterior and a longer body size that aligns well with consumer demands. 2. Exterior: From the side view, the car's body dimensions are quite sleek. Compared to the overseas version, the wheelbase is extended by 80mm, and compared to the previous generation, the current model's wheelbase is increased by 59mm.

6

5

Share

Which is the standard way to start: handbrake or footbrake?

Parking brake (handbrake) is the standard method. Here are the relevant details: 1. Principle of handbrake: The handbrake is a mechanical lever that generates braking force when pulled up by hand, and the braking force disappears when released. Note that before releasing the brake lever, you must press the button in front of the lever to lower it. 2. Common vehicle types with handbrake: In the current automotive market, mechanical handbrakes are commonly found in manual transmission models, low-end automatic transmission models, and racing cars. 3. Advantages of using handbrake: The handbrake method offers comfortable control during operation, with the advantages of low cost and simple, convenient maintenance.

5

Share

How to Choose a Vehicle License Plate Number Online?

What does it mean when the ABS warning light is on in a car?

What is the fuel consumption of the Chery QQ?

What Causes Small Bubbles in the Radiator and Constant Water Loss?

How to Install the Memory Card for the 14th Generation Sylphy Dash Cam?

Does the Magotan Really Have So Many Problems?

Which is the standard way to start: handbrake or footbrake?

What causes severe idle vibration in the Mondeo 1.5T?

What are the symptoms of a faulty dual-clutch transmission valve body?

What does it mean when the exclamation mark warning light in a Mazda comes on?

What are the structural components of a sedan body?