How to Check the Oil Level in a Porsche Macan?

Why was the Great Wall H2s discontinued?

Great Wall H2s has not been discontinued, and this model is still in production and available for sale. Below is the relevant information about the Great Wall H2s: 1. The Great Wall H2s is a compact SUV with a wheelbase of 2550mm, and its length, width, and height are 4195mm, 1772mm, and 1638mm respectively. 2. The Great Wall H2s is equipped with a 1.5-liter turbocharged engine across all variants. The 1.5-liter turbocharged engine delivers 150 horsepower and a maximum torque of 210 Nm. The engine features dual VVT technology and multi-point fuel injection, and it uses an aluminum alloy cylinder head and block. This engine is paired with either a 6-speed manual transmission or a 7-speed dual-clutch transmission. 3. The front suspension of the Great Wall H2s uses a MacPherson independent suspension, while the rear suspension employs a torsion beam non-independent suspension. The use of a torsion beam suspension at the rear helps to expand the rear seating space and trunk space, and it also reduces the overall manufacturing cost of the vehicle.

11

4

Share

Can the Lingpai remotely close the windows?

The Lingpai can remotely close the windows by using the remote lock function, which will automatically raise and close all the windows. Additionally, holding down the trunk unlock button (or pressing it twice for some models) will automatically pop open the trunk. Method to set up remote window control: Turn on the ignition, use the switch to partially open the power window, then fully push the switch until the window is completely closed, and hold the switch for 3 to 5 seconds after the window is fully closed. If you forget to close the windows after exiting the car and are at a distance, simply take out the key and lightly press the lock button on the remote, and all four windows and the sunroof will automatically close. Precautions for using the Honda Lingpai key: Most smart key casings are quite sturdy, but the internal circuitry is less resistant to impact and can be easily damaged in case of severe collisions. Moreover, if the smart key gets wet, the internal circuitry may short-circuit, leading to remote failure. Since smart keys use low-intensity radio waves, they may not function properly in the presence of magnetic interference. If the smart key is exposed to high-intensity radio waves, it may excessively drain the battery. Therefore, avoid placing the smart key near electronic devices.

16

3

Share

Where is the manual maintenance light reset button located on the Lynk & Co 01?

The trip meter reset button on the combination instrument panel serves as the maintenance light reset button. Maintenance light reset procedure: First, turn off the engine and remove the key. Then, press and hold the right button below the instrument panel while inserting and turning the key to the ignition-on position. Once the ignition is on, release the right button - a small wrench icon will appear. After the wrench icon appears, press the left button below the instrument panel once to make the wrench icon disappear. Reason for maintenance light illumination: When the vehicle reaches a certain mileage, the onboard computer detects that maintenance is required and illuminates the warning light on the instrument panel. For optimal vehicle reliability, it's recommended to perform maintenance immediately when the maintenance reminder light comes on.

10

3

Share

Can the Lingpai Hybrid get a green license plate?

The Honda Lingpai Hybrid model has a pure electric range of less than 150 kilometers, which does not meet the conditions for obtaining a green license plate in China. Hybrid vehicles can get green license plates, but it depends on the specific model. Some hybrid vehicles cannot obtain green plates. Hybrid models are divided into plug-in hybrids and range-extended hybrids. Only plug-in hybrid models with a pure electric range of over 150 kilometers meet the requirements for new energy license plates. Common examples include BYD's Tang DM, BMW 5 Series Le models, and other hybrid vehicles that meet the above conditions. These not only qualify for green license plates but also enjoy certain national subsidy policies, although the subsidies are slightly lower than those for pure electric vehicles. On the other hand, models like the Toyota Corolla Hybrid, Honda Hybrid, and Buick Hybrid, which are not plug-in hybrid systems, are considered energy-efficient vehicles and do not fall under the new energy vehicle category, so they cannot get green license plates. Generally, pure electric vehicles and plug-in hybrid models can obtain green license plates. Green license plates are exclusive to new energy vehicles and are specially designed by the government for easier differentiation and management, helping to quickly distinguish between traditional fuel vehicles and new energy vehicles.

2

0

Share

What are the reasons for the Peugeot 3008 burning engine oil?

The reasons for the Peugeot 3008 burning engine oil are as follows: 1. Generally, engine oil burning is caused by excessive clearance between the piston rings and cylinder walls, improper installation of piston rings, or reduced sealing performance, allowing oil on the cylinder walls to enter the combustion chamber, leading to oil burning. 2. Additionally, poor sealing performance of the valve seals, damage to the crankcase forced ventilation valve (PCV), or blockage of the crankcase ventilation port causing excessive pressure in the crankcase can all result in oil entering the cylinder along with crankcase gases and participating in combustion. Relevant information about engine oil is as follows: 1. Engine oil, also known as engine lubricant (English name: Engine-oil), has a density of approximately 0.91×10³ (kg/m³) and serves to lubricate and reduce friction, assist in cooling, seal against leaks, prevent rust and corrosion, and provide shock absorption in the engine. 2. Engine oil consists of two parts: base oil and additives. The base oil is the main component of lubricating oil, determining its basic properties, while additives compensate for and improve the shortcomings of the base oil, imparting certain new properties, making them an important part of lubricating oil.

12

1

Share

Which button is the cruise control on the Elantra?

Beijing Hyundai Elantra 1.6L's cruise control button is located on the right side of the steering wheel. CRUISE activates it, CANCEL turns it off, RES+ increases speed, and SET- decreases speed. Below is more information about cruise control: 1. Cruise control is used to maintain a constant vehicle speed. Once set, the engine's fuel supply is controlled by the computer, which continuously adjusts fuel delivery based on road conditions and driving resistance to maintain the set speed without throttle input, reducing driver fatigue and unnecessary speed fluctuations while improving fuel efficiency. 2. In case of cruise control malfunction while driving, you can shift to neutral, turn off the engine, apply brakes, or use the handbrake. If shifting to neutral doesn't work, try turning off the engine. For key-start vehicles, turning off just one position won't disable power steering or brake assist.

8

3

Share

How to Check the Oil Level in a Porsche Macan?

Why was the Great Wall H2s discontinued?

Can the Lingpai remotely close the windows?

Where is the manual maintenance light reset button located on the Lynk & Co 01?

Can the Lingpai Hybrid get a green license plate?

What are the reasons for the Peugeot 3008 burning engine oil?

Which button is the cruise control on the Elantra?

What is the reason for the key light flashing on the Sylphy dashboard?

What is the ground clearance of the Lynk & Co 01?

What is the fuel tank capacity of the Lexus 570 in liters?

Is the Elantra CVT transmission equipped with a steel belt or a chain?