How to Check for Car Battery Drain?

1 Answers
CorbinDella
07/24/25 1:45am
Car battery drain can be checked by following these steps: 1. Turn off the car's ignition switch and wait for 5 to 10 minutes in a locked state to allow the car to enter a dormant mode; 2. Locate the tightening nut on the negative terminal of the battery, loosen it with a wrench, then gently pry open the tightening block with a flat-head screwdriver, and finally remove the negative terminal; 3. Set the multimeter to the DC 10A or 20A range, connect the red probe to the car's grounding wire, and the black probe to the negative terminal of the battery; 4. Observe the reading on the multimeter. If the reading falls within the normal range, it indicates that the car battery is functioning properly.
Was this review help?
17
5
Share
More Forum Discussions

How to Handle and Claim Compensation for Car Scratches?

In addition to reporting to the traffic management department, you must also report the incident to your insurance company within 48 hours. Visit the insurance company for damage assessment After reporting the incident, provide the relevant documents to the policyholder's insurance company. Go to the policyholder's insurance company or a specialized car repair shop for photo-taking, damage assessment, and claims processing. After the accident is handled, submit the claim documents within the specified period.
13
1
Share

How to Turn on the Night Lights of an Automatic Car?

When driving in urban areas at night, use low beam headlights. Using high beams will not only dazzle oncoming drivers but also affect the visibility of pedestrians on both sides of the road. Use high beams in rural areas or on roads without street lighting, but remember to switch back to low beams when encountering oncoming traffic to avoid dazzling other drivers.
19
4
Share

Is a Broken Engine Mount Serious?

Engine mount failure is a serious issue that can cause engine idling and vehicle shaking. In severe cases, it may lead to violent engine vibrations during operation, potentially creating hazardous driving conditions. Immediate replacement is required if the mount is damaged. The engine and transmission assembly within the engine compartment require proper support and fixation to ensure normal operation. Engine mounts, commonly referred to as engine mounts or engine supports, are components designed to secure the engine. Most vehicles are equipped with three engine mounts, which generally share similar structural designs.
9
5
Share

How to Handle Engine Stalling After Driving Through Water

When towing the vehicle, use a rigid towing method to prevent engine damage caused by accidental gear engagement. Only start the engine if everything is normal. If water has entered the engine, thorough drainage and lubrication must be performed before attempting to start it. Always disconnect the negative terminal of the battery to prevent short circuits in the vehicle's electrical components due to water exposure.
5
3
Share

How to resolve a flat tire on Q50L?

Try using an air pump to inflate the tire. If you can reach the normal tire pressure, simply inflate it to the recommended level and then visit the nearest tire repair shop for a patch. If you hear a noticeable air leakage sound while inflating and cannot reach the proper tire pressure, you will need to use a tire repair sealant. Reset the tire pressure in the tire settings, then drive the car for a certain distance to clear the alert.
3
4
Share

What is the method for removing the interior fuse box of the BYD F3?

You can see the yellow clips and the cover plate. After removing the clips and the cover plate, you will be able to see the vehicle fuse box. You can then take off the fuse box cover. After replacing the faulty fuse, cover the fuse box and press it to engage. You can now see the corresponding positions of the fuses in the vehicle. The position shown in the diagram is the location of the CD fuse.
19
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.