How to Change Transmission Fluid for Nissan Sylphy?

1 Answers
AugustLynn
07/29/25 7:09pm
Nissan Sylphy transmission fluid replacement methods are as follows: 1. Manual fluid change: Start the engine to warm up the transmission to operating temperature, remove the drain bolt, drain the old fluid completely before reinstalling the bolt, add new ATF fluid, start the engine, shift from P to N, D, L1, L2 and other gears repeatedly, staying in each gear for at least 5 seconds, then check if the automatic transmission fluid level is normal. 2. ATF exchanger fluid change: Disconnect one cooling pipe of the automatic transmission, properly connect the ATF exchanger's inlet/outlet pipes and high-pressure air pipe, fill the exchanger with sufficient new ATF fluid, start the engine and let it idle, turn on the exchanger's adjustment knob to allow new fluid to flow into the transmission while old fluid flows into the waste oil recovery tank, observe the cleanliness of the fluid in the exchanger's inlet pipe, and stop the fluid change when the fluid appears relatively clear.
Was this review help?
3
1
Share
More Forum Discussions

How to Open and Close the Fuel Tank Cap of the Lingpai?

Locate the fuel tank cap release switch below the left side of the driver's seat inside the car and pull it up, then unscrew the inner fuel tank cap counterclockwise. After refueling, screw the cap back on clockwise to close the fuel tank cap.
13
3
Share

What to Do When Your Lynk & Co Car Battery Dies?

Emergency measures include finding another car for a jump start after mutual agreement, or calling the 4S dealership or repair shop for roadside assistance. After normal startup, promptly inspect whether the battery is discharging and replace it in time if necessary.
10
5
Share

How to Switch the Dashboard Theme on the Lynk & Co 05?

The vehicle features four newly designed theme displays, allowing drivers to switch freely according to personal preferences. The control button is located on the steering wheel. On the right side of the steering wheel, there is an up and down adjustment button. Press it to make a selection.
13
1
Share

How to Use the Seat Memory Function in Lynk & Co?

Press the start switch, adjust the seat to your preferred position, and then press the memory button M. The indicator light on the button will illuminate at this point. Within a short time, hold down the button until the indicator light turns off and an audible reminder sounds. The corresponding position will then be stored under the button.
11
4
Share

How to Remove the Lynk & Co Mechanical Key?

Press the release button. Slide the key cover outward slightly, then flip it open. While pressing the release button, pull out the mechanical key directly. After using the mechanical key, insert the key blade into the slot until you hear a click sound, then reattach the key cover.
8
0
Share

How to Connect Land Rover CarPlay?

Before using CarPlay, you need to prepare an original USB cable. Connect the data cable to the car's USB port, and follow the prompts that appear. The car system will automatically start CarPlay. If the CarPlay interface does not appear on the car's main screen, click the CarPlay icon on your phone to activate the system.
2
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.