How to Change Tires on a Car with Tire Pressure Monitoring?
2 Answers
To change tires on a car with tire pressure monitoring, follow these steps: 1. Power on the car without starting the engine; 2. Press and hold both the lock and unlock buttons on the remote for 5 seconds until you hear two beeps, then release; 3. Reset each tire in the order of left front, right front, right rear, and left rear. Remove the valve cap and deflate the tire for 10 to 20 seconds until you hear a short beep, indicating the left front tire is set; 4. After the last tire is set, the car will emit two short beeps. Follow the same steps for the remaining three tires, then inflate them to complete the tire replacement.
I just bought a car with tire pressure monitoring and feel a bit worried when changing tires. Remember the steps: first, find a flat and safe place to park, pull the handbrake, and turn off the engine to ensure stability. Loosen the wheel hub bolts but don’t remove them completely, then use the jack to lift the car at the designated point—don’t go under the car, it’s risky. Carefully remove the old tire, avoiding damage to the tire pressure sensor—usually connected to the valve, move it gently. Install the spare tire or new wheel, tighten the bolts slowly in a diagonal sequence to ensure evenness. After lowering the jack, check if the bolts are tight. After the change, the tire pressure monitoring might trigger a warning light—that’s normal, drive a few hundred meters to let it adapt. If it doesn’t reset, follow the manual’s method to reset the system. Remember to check the spare tire’s pressure too—don’t wait until the next issue makes things worse. For safety, wear gloves when doing it yourself to protect your hands.
