How to Change the Transmission Fluid for GAC Trumpchi GM8?

[AugustFitz]

The method for changing the transmission fluid for GAC Trumpchi GM8 is as follows: 1. The principle is the same as changing the engine oil. Loosen the bolt of the oil pan and let the transmission fluid drain out by gravity. This method is the simplest, but it cannot completely drain the transmission fluid, as some fluid remains in dead corners such as recesses and uneven areas due to the mechanical structure. 2. Add new transmission fluid into the circulation machine, then connect the circulation machine to the transmission fluid circuit interface. Under hydraulic pressure, the new fluid will push out the old fluid. This method cleans the fluid circuit more thoroughly. The more new transmission fluid used, the cleaner the system will be. A single circulation machine fluid change requires approximately 10-13 liters of transmission fluid. The process takes about 40-80 minutes.

[DelDiana]

As an experienced individual who has changed transmission fluid for many cars, I'd like to share the procedure for the GM8. Raising the car to a safe height is crucial, using either a jack or a lift. Locate the transmission oil pan, loosen the drain plug to let the old fluid drain completely, waiting about ten minutes. Take this opportunity to inspect the pan for any residue and clean it thoroughly; replace the filter if there's one. Then, tighten the drain plug and slowly pour in new fluid through the fill port, using a funnel to prevent spills. The amount of fluid should be as specified in the user manual, typically around 5 liters of SP-grade ATF. Start the engine and let it idle for a few minutes, shift through the gears, then check if the fluid level meets the standard. When doing it yourself, prepare the necessary tools and proceed with caution to avoid mistakes that could lead to leaks or damage. It's recommended to change the fluid every 60,000 kilometers to prolong the transmission's lifespan.

[DeAshlyn]

I've been driving the GM8 for almost three years, and the process of changing the transmission oil myself was quite thrilling. The first step was preparing the tools: a lifting device, oil drain pan, new oil, and wrenches. After lifting the car, I made sure it was stable, located the drain plug to release the old oil, and cleaned the surrounding debris. Replacing the filter is crucial, as not doing so can lead to dirt accumulation. When adding new oil, take it slow—pour it in a small stream to avoid overfilling. After completion, run the engine to check the oil level. DIY saves money but carries risks; improper installation leading to oil leaks could cause accidents. Spending a few hundred dollars at a professional shop might be more worry-free. Transmission oil should be changed every 50,000 kilometers to protect the internal gears and ensure smooth operation.

[McOmar]

I changed the transmission fluid for my GM8 by first purchasing the correct fluid model, consulting the manual or asking the seller. Then, I lifted the vehicle to drain the old fluid and replaced the old filter to ensure filtration effectiveness. New fluid was added through the fill hole, and the fluid level was precisely measured using equipment. After a test drive, I checked if the fluid level was normal. The entire process takes about half an hour. With the right tools, it's not difficult but time-consuming. I usually choose to spend 400 yuan at a quick repair shop to get it done, which is more efficient than doing it myself. Regular changes, such as every two years, prevent fluid degradation from affecting smooth gear shifts and save money by avoiding major repairs.