How to Change the Transmission Fluid for an Old Sylphy 4AT?

Is there a 2021 model of the Explorer?

There is a 2021 model of the Explorer. Explorer model positioning: The Ford Explorer is a mid-to-large-size SUV. Explorer interior features: The 12.8-inch vertical central control screen is equipped with the SYNC+2.0 intelligent information entertainment system, which supports GPS navigation, voice recognition control, multimedia entertainment, and other functions. Additionally, the L2-level Ford Co-Pilot360 intelligent driving assistance system is standard across all models. Explorer powertrain: The entire lineup features a high-specification 2.3T+10AT powertrain combination, with the engine delivering a maximum power of 276Ps and a maximum torque of 425Nm. The rear-wheel-drive model can accelerate from 0 to 100km/h in just 7.6 seconds. Except for the entry-level model, all other models come with a four-wheel-drive system, with fuel consumption around 12L per 100km.

17

2

Share

What is the reason for BMW having heating in the front but no heating in the rear?

BMW having heating in the front but no heating in the rear is due to the following reasons: Thermostat always open or opening too early: If the thermostat is always open or opens too early, the cooling system prematurely enters a large circulation cycle. With low external temperatures, especially when starting the car, cold air quickly cools the antifreeze, resulting in lower engine water temperature and ineffective heating. Damaged or slipping water pump impeller: A damaged or slipping water pump impeller reduces the flow rate through the small heater core, causing slow heat buildup. Air lock in the engine cooling system: An air lock causes poor circulation in the cooling system, leading to high water temperature and ineffective heating. If there is always air in the cooling system, it may be due to a damaged cylinder gasket allowing air into the cooling system. If the inlet pipe of the small heater core is very hot while the outlet pipe is relatively cool, this indicates a blockage in the small heater core, which should be replaced.

3

0

Share

Where is the Liana's cabin air filter located?

Liana's cabin air filter is located inside the glove compartment blower on the passenger side. You can see it after removing the glove compartment. The cabin air filter should normally be replaced every 10,000 to 15,000 kilometers of driving. During regular maintenance, you can take it out for inspection - if it's not dirty, there's no need to replace it, just clean it with an air pump. The primary function of the cabin air filter is to filter dust from the air, preventing dust from entering the evaporator and forming sludge that could clog it. If the airflow from the vents significantly decreases, it indicates a clog. Another important function of the cabin air filter is air purification. Cabin air filters typically contain activated carbon, which can absorb certain harmful substances from the air, benefiting your health.

4

1

Share

How to Measure Cylinder Pressure with a Pressure Gauge?

Method for measuring cylinder pressure with a pressure gauge: 1. Start the engine and run it until the coolant temperature reaches approximately 80 degrees Celsius, then stop; 2. Use compressed air to clean the dust around the spark plugs, remove the spark plugs from each cylinder, and open the throttle and choke valves; 3. Remove exhaust gases from the cylinder, place the rubber tip of the cylinder pressure gauge over the spark plug hole, and press firmly; 4. Quickly turn the crankshaft using the starter or hand crank, record the pressure gauge reading, repeat the test 2 to 3 times, then measure the remaining cylinders in sequence; 5. If the cylinder pressure is below the standard, add 20 to 30 grams of fresh engine oil to the top of the piston and retest the pressure. If the pressure increases significantly, it indicates piston ring wear. If the pressure remains unchanged, it suggests valve or cylinder head gasket leakage.

12

2

Share

What are the reasons for the gear lever of Geely Emgrand being stuck?

Geely Emgrand gear lever being stuck may be caused by the following reasons: Failure of the positioning part of the gear lever ball head: The gear lever can rotate freely around its own axis, making it impossible to accurately control the gear position; it could also be due to the wear of the spherical working surface at the lower end of the gear lever, preventing it from controlling the shifting fork or the shifting groove of the shifting head, thus making both gear engagement and disengagement impossible. Incomplete clutch disengagement: While the gear shifting mechanism of the transmission works normally. This issue can be resolved by adjusting the clutch or replacing some clutch components to ensure the clutch has appropriate free play and separation clearance. Pressure plate failure: Many vehicles experience heavy clutch pedals and difficulty in shifting gears when the engine is hot, which is mostly caused by prolonged wear of the pressure plate or aging of the release fingers. The pressure plate needs to be replaced, which is relatively complex as it requires removing the entire transmission to replace the pressure plate.

3

Share

What is the power generation capacity of the Mercedes-Benz S600?

The battery voltage of the Mercedes-Benz S600 is 12 volts DC, which can be converted to 220 volts AC through an inverter. Introduction to car batteries: Car batteries are an essential part of a vehicle and can be divided into traditional lead-acid batteries and maintenance-free batteries. Since the battery uses a lead-calcium alloy for the grid frame, the amount of water decomposition during charging is minimal, and the water evaporation rate is also low. Additionally, the sealed structure of the housing releases very little sulfuric acid gas. Therefore, compared to traditional batteries, these batteries have advantages such as not requiring the addition of any liquid to the terminal posts and having a long power storage time. Normal voltage of car batteries: In a no-load state, the normal voltage of a car battery is around 13 volts, and the load voltage should not be lower than 11 volts. Below this voltage, starting the car may become difficult. After starting, since the generator begins to generate electricity, the normal voltage of the car battery should be between 13.5 volts and 14.5 volts.

6

3

Share

How to Change the Transmission Fluid for an Old Sylphy 4AT?

Is there a 2021 model of the Explorer?

What is the reason for BMW having heating in the front but no heating in the rear?

Where is the Liana's cabin air filter located?

How to Measure Cylinder Pressure with a Pressure Gauge?

What are the reasons for the gear lever of Geely Emgrand being stuck?

What is the power generation capacity of the Mercedes-Benz S600?

Is the Haval F7 a Front-Wheel Drive Vehicle?

Why does the Passat Lingyu report oil pressure?

Do I need to replace my driver's license after one year?

What is the size of the Odyssey car window glass?