How to Change the Photo on a Driver's License?

What is the power of a 380V charging pile?

380V charging piles typically have a power of 40KW. Charging piles are generally divided into two categories: AC piles and DC piles. The time required to fully charge a car depends on the battery capacity of the vehicle. To calculate the charging time, it is necessary to understand the input voltage and current of the charger. Moreover, the current consumption of the charger continuously varies during the charging process and does not remain constant, so the calculated result is only a reference value. Below is some relevant knowledge about charging piles: 1. AC piles: The standard power is usually 7KW, but some manufacturers provide portable chargers or three-prong cables with only 2-3KW, which are not standard piles; 2. DC piles: Also known as fast-charging piles, they typically have power ratings of 15, 20, 30, 45, 60, 100, 150, 200, 250, and 300KW. Currently, most DC piles use modular power combinations, offering more flexible benefits and allowing users to freely combine the power of the charging pile according to their needs.

11

0

Share

Is it a big deal to cross the yellow line when turning left?

It is considered a violation, mainly depending on which yellow line was crossed. If it's the yellow line at the exit of the turn, generally no penalty will be imposed. However, if it's the double yellow line for a left turn, a fine and three demerit points will be issued. Below is the relevant information: 1. Function: Central dividers and double yellow lines are commonly found on main and secondary roads in urban areas, serving as primary facilities to separate opposing lanes. However, they differ in terms of roadside strips, safety zones, and lateral clearances. 2. Overview: Double yellow lines are common road traffic markings composed of two parallel solid yellow lines. They are typically placed in the middle of roads without central barriers, dividing opposite traffic directions and separating vehicles traveling in different directions with ground markings. Under normal circumstances, civilian vehicles are not allowed to cross these lines. Some roads with simple small guardrails may also have double yellow lines. Vehicles can only turn or make a U-turn at the break in the double yellow line when other traffic signs permit.

12

4

Share

What is the tire pressure for the CFMOTO 650GT?

The tire pressure for the CFMOTO 650GT is: front tire 220-250 kPa, rear tire 250-280 kPa. Generally, the standard tire pressure for vehicles is between 2.3-2.5 bar when the tires are cold, which is within the normal range. The maximum should not exceed 3.0 bar, and the minimum should not be lower than 2.1 bar. Hazards of over-inflation: The contact area between the tire and the road surface becomes smaller, leading to increased wear on the center of the tire; reduced traction affects driving safety; over-inflation also worsens the tire's shock absorption, impacting ride comfort. In hot summer conditions, over-inflation increases the risk of a blowout. Hazards of under-inflation: The contact area between the tire and the road surface increases, causing severe wear on both sides of the tire, heavier steering, increased rolling resistance, and higher fuel consumption. Additionally, repeated tire flexing generates excessive heat, which can lead to a blowout.

16

4

Share

Will there be any problems if the car is not driven for over a month?

Yes, there will be problems. The issues that may arise from leaving a car unused for a month are as follows: 1. Fluid deterioration: There are many fluids in a car, the most common being engine oil. These fluids can deteriorate if not used. If the vehicle is parked for a long time, the engine oil will undergo severe oxidation and eventually deteriorate. 2. Brake failure: When parking the car, the handbrake is often engaged, keeping the handbrake cable in a tense state, which significantly shortens the lifespan of the brakes. If the car is not parked on a level surface, this will further accelerate the wear. 3. Component and rubber aging: Prolonged parking makes electronic components more prone to moisture damage, and rubber parts will age faster due to exposure to wind and rain. These conditions will greatly reduce the car's waterproofing and sound insulation capabilities. 4. Battery drain: The component most affected by long-term parking is the car battery. The battery gradually charges while driving, but if the car is left unused for an extended period, the battery will remain in a state of constant discharge without being recharged.

18

4

Share

What does it mean when the SVS light comes on in a gasoline car?

The SVS light in a car is similar to the engine fault light. When the SVS indicator light comes on, it indicates that the engine control unit has detected an error signal from a sensor or that the sensor has exceeded its usage standard. When the ignition is turned on, the SVS indicator light will illuminate for an automatic check and then turn off after a few seconds, allowing the vehicle to operate normally. Here is some relevant information: 1. Introduction: The SVS indicator is an engine fault indicator. It will light up when the ignition key is turned on and will turn off once the vehicle is started. If the engine ECU detects a fault, the SVS light will illuminate. If this light comes on while driving, it indicates a fault in the vehicle's engine. It is recommended to contact a local 4S store for inspection and repair as soon as possible. 2. Risks: If the SVS light stays on and is accompanied by signs such as increased combustion chamber temperature or the oil pressure warning light, continued driving may lead to increased engine wear and early engine damage.

7

0

Share

What does the E gear in an automatic transmission car mean?

Automatic transmission E gear is the energy recovery mode, also known as the power-saving economy gear or snow gear. Its main function is to keep the engine speed low to save fuel consumption, and it is usually in the form of a button. The following is a detailed introduction to the gears of an automatic transmission car: 1. R gear (Reverse gear): When this gear is engaged, the hydraulic system reverse gear oil circuit is connected, causing the drive wheels to reverse for backward movement. When the vehicle is not completely stopped, do not forcibly shift to the "R" gear, as this may damage the transmission. 2. N gear (Neutral gear): When the neutral gear is engaged, the planetary gear system idles and cannot output power. 3. D gear (Drive gear): When the gear shift lever is in this position, the hydraulic system control device will automatically connect the corresponding forward gear oil circuit based on the throttle opening signal and vehicle speed signal. It can automatically shift up or down with changes in driving speed, achieving automatic transmission function. 4. P gear (Parking gear): It uses a mechanical device to lock the rotating part of the tire, preventing the car from moving.

9

5

Share

How to Change the Photo on a Driver's License?

What is the power of a 380V charging pile?

Is it a big deal to cross the yellow line when turning left?

What is the tire pressure for the CFMOTO 650GT?

Will there be any problems if the car is not driven for over a month?

What does it mean when the SVS light comes on in a gasoline car?

What does the E gear in an automatic transmission car mean?

Is 50 yuan for 60 kilometers fuel consumption too much?

How to Solve the Rear Wheel Lock-Up Issue in Santana?

What is the operation manual for the Audi Q5 center console?

Is an annual inspection required for small vehicles after six years?