How to Change the Oil for the Haval H5 Diesel Version?
3 Answers
Run the engine until it reaches operating temperature; place an old oil container under the oil pan, locate the oil pan drain plug, and slowly loosen the drain plug; move the oil container under the oil filter, use an oil filter wrench to loosen the filter, and unscrew it by hand; select the appropriate oil filter; apply new oil to the new filter's gasket; pour new oil into the oil pan, and check for leaks under the engine. Key Considerations for Engine Oil: Choose engine oil based on the engine's requirements; multi-grade oil is preferred as it is economical, long-lasting, and efficient, providing better protection for the engine; if the engine is in good condition and the seasonal temperature is low, use lower-viscosity oil to ensure smooth oil flow. In high-temperature seasons or if the engine is severely worn, higher-viscosity oil helps form an oil film and reduces engine wear. Specifications: The body dimensions are 4649/1810/1735 (mm), with a wheelbase of 2700mm. The exterior design is dynamic, stylish, and bold.
As someone who frequently tinkers with cars, I find changing the oil in the Haval H5 diesel version quite straightforward. Preparation is key: first, purchase the appropriate new oil and oil filter—diesel engines require diesel-specific oil, with specifications like API CH-4 as per the manual. Park on level ground, engage the handbrake, and let the engine cool for half an hour to avoid burns. Tools needed include a wrench, oil pan, and funnel. Locate the oil drain plug under the car, loosen it to drain the old oil into the pan, and patiently wait a few minutes for it to fully drain. Next, remove the old filter, clean the contact surface, apply a bit of new oil to the new filter’s seal before tightening to prevent leaks. Reinstall the drain plug, being careful not to overtighten and damage the threads. Open the oil filler cap and slowly pour in the new oil, ensuring it doesn’t exceed the max line on the dipstick. Start the engine and let it idle for a minute to check for leaks, then turn it off and wait three minutes to confirm the oil level is centered. Finally, collect the used oil and take it to a recycling center—environmental responsibility is crucial. Doing it yourself saves over 200 yuan in labor costs and helps you familiarize yourself with your car’s condition to prevent minor issues.
I just tried changing the oil in my H5 diesel truck, and even a beginner can handle it. Prepare about 5 liters of diesel engine oil, a new filter, and simple tools like a wrench and an oil pan. It's safer to operate after parking the car on level ground, turning off the engine, and letting it cool. Squat down to locate the drain plug on the oil pan, use a wrench to loosen it, and place the pan underneath to catch the oil—it takes a few minutes to drain completely. Then replace the filter: remove the old one and install the new one, being careful not to get your hands dirty. After tightening the drain plug back, slowly pour the new oil through the fill port under the hood using a funnel to avoid spills. Pour half, check the dipstick, then top up as needed, ensuring it doesn’t exceed the max line. Start the engine and listen for any unusual sounds, then park and check that the oil level is within the proper range. Don’t dump the used oil—store it in the garage for recycling. The whole process takes about half an hour, saving money and giving you hands-on experience. Diesel engine oil gets dirtier, but frequent changes can save on repair costs.
