How to Cancel the Tire Pressure Monitoring on Honda CRV?
3 Answers
To cancel the tire pressure monitoring on Honda CRV: 1. Press the arrow button at the lower right of the steering wheel, and the central screen will display the personalized settings; 2. Press the reset button to enter the tire pressure monitoring system calibration; 3. Press the reset button, and the central screen will display the setting for tire pressure monitoring system calibration; 4. Press the arrow button at the lower right of the steering wheel to calibrate; 5. Press the reset button, and the central screen will display the calibration initiation. The Honda CRV is a compact SUV under Dongfeng Honda, with exterior dimensions of 4621mm in length, 1855mm in width, and 1679mm in height, and a wheelbase of 2661mm.
I've been driving a Honda CR-V for several years, and occasionally the tire pressure warning light comes on. Honestly, this system can't be permanently disabled, mainly for safety reasons. Honda's design is very thoughtful—the warning light indicates that a tire's pressure is low or the system has detected an issue. To turn off the warning, you first need to check all tire pressures to ensure they meet the standard values, typically around 230 kPa for both front and rear tires (check your car's manual or the label on the door for specifics). If the pressure is normal but the light remains on, you can reset the system using the controls on the steering wheel. The process is simple: start the vehicle, navigate to the settings menu on the steering wheel, enter vehicle settings, select tire pressure calibration, and confirm. Some models may require holding a button for a few seconds. After resetting, the light should turn off. If it doesn't, there might be a sensor issue, and you should visit a dealership for inspection. I make it a habit to regularly check my tires and maintain proper pressure to avoid frequent warnings—safety comes first. In short, don't try to disable it entirely; proper tire maintenance is the better approach.
As a car DIY enthusiast, I often tinker with my Honda CR-V and am quite familiar with the tire pressure monitoring system reset. To temporarily stop the alarm, not disable the system, but manually reset it, you first need to ensure all tire pressures are adjusted uniformly. Refer to the values on the door jamb or manual, typically around 230kPa. The TPMS reset for the CR-V is done in the system menu: after starting the car, find the vehicle settings on the center console or steering wheel, access the maintenance menu, select the tire pressure system calibration or a similar option, and press the confirm button to execute. The system will perform a self-check, requiring a few minutes of driving for data synchronization. On some models, holding the button at the bottom right of the instrument panel for a few seconds can also reset it. I've tried it several times, and the light goes off after resetting. If there's a sensor malfunction or wiring issue, the alarm will reappear, and then you'll need to check the sensor battery or replace parts. To minimize alarms, I've also learned to check tire pressure balance promptly after patching a tire. Safety is always the top priority—don't take unnecessary risks with it.
