How to Cancel the Maintenance Reminder on the Ford Kuga?

1 Answers
BentleyAnn
07/30/25 8:04am
The method to cancel the maintenance reminder on the Ford Kuga is: 1. Close all doors and windows; 2. Press the one-touch start button; 3. Simultaneously press and hold the accelerator and brake pedals for about 3 seconds until the dashboard displays "serviceOilresetinprog," then maintain this for 25 seconds; 4. After 25 seconds, "completede" will appear, indicating the process is done. Taking the 2019 Ford Kuga as an example, it belongs to the compact SUV category, with body dimensions of: length 4525mm, width 1838mm, height 1685mm, and a wheelbase of 2690mm. The 2019 Ford Kuga is equipped with a 1.5T turbocharged engine, delivering a maximum horsepower of 182PS, a maximum power of 134kW, a maximum torque of 245Nm, and is paired with a 6-speed automatic transmission.
Was this review help?
7
1
Share
More Forum Discussions

How is Car Horsepower Calculated?

Power (W) = 2π × Torque (N-m) × RPM/60. The horsepower of an engine refers to the output capacity of the engine, which is the output power. Power (kW) = Torque (N-m) × RPM (rpm)/9549. This is how the horsepower of a car is calculated.
16
2
Share

How to Claim for a Total Loss Vehicle?

Insurance vehicle suffers total loss. If the insured amount is higher than the actual value at the time of the accident, the compensation will be calculated based on the actual value at the time of the accident. The compensation is calculated according to the insured amount, i.e., Claim Amount = (Insured Amount - Residual Value) * Accident Liability Ratio * (1 - Deductible Rate).
17
0
Share

How to Operate the Car Light Switch?

The car light control button is located not only below the steering wheel but also near the door. To turn on the low beam, twist the button to the right twice, and the low beam will be activated. Twisting it to the right once turns on the parking lights, while pulling the button upward activates the front fog lights. Different lights serve various purposes.
7
1
Share

What to Do When Your Car Is Submerged in Water?

When a car is submerged in water, turn off the engine and do not restart it, then call for rescue. Try to use a wrench to loosen the screw securing the battery cable and remove the negative terminal of the battery. This requires the owner not to rashly open the door to get out, as it may cause the computer board to short-circuit due to water ingress.
20
2
Share

How to Fix a Hard-to-Open Car Door Handle?

Open the car door, and you will find a small hole on the door edge. Use a T-20 Torx screwdriver to loosen the screw inside, allowing the small cover of the door handle to be removed by hand. Then, you will see the internal cable secured in the handle's slot. If the cable is tightly stretched, simply adjust it to loosen slightly. Apply screw loosening agent to lubricate the door lock mechanism.
15
2
Share

What to Do When There's Glue Residue After Removing a Car Sticker?

Use a hairdryer to blow hot air until it becomes too hot to touch, then immediately apply even pressure to peel off the car sticker. You can first dampen and soften the paper of the car sticker with a wet towel, then rub it off. Diluent can also be used to easily remove it. For glass that already has a film, never use cleaning agents, as some chemical agents may damage the car film.
19
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.