How to Calibrate the Tire Pressure Sensor on the Trumpchi GA6?
2 Answers
To calibrate the tire pressure sensor on the Trumpchi GA6, follow these steps: Select the system, choose TPMS, read the fault codes, read the data stream, select special functions, click continue, choose tire pressure sensor calibration, turn on the ignition without starting the engine, click confirm to recalibrate, activate to obtain the sensor ID, check the removed left rear tire pressure sensor, note the ID printed on the sensor, input the IDs of all four tire pressure sensors, and the tire pressure sensor calibration will be successful. There are generally three reasons for abnormal tire pressure: Abnormal tire pressure: An alarm will sound if the pressure is below 1.8 bar or above 3.0 bar. In this case, the tires should be checked and the pressure adjusted. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure is not reset in time, the tire pressure monitoring system will still record the previous data, causing the tire pressure monitoring indicator to light up. Simply reset the tire pressure to resolve this issue. Damaged tire pressure sensor: The tire pressure sensor, which monitors tire pressure, is installed inside the tire and connected to the tire inflation valve. If the sensor is damaged while driving, the tire pressure warning light will illuminate. If the sensor is damaged, it must be replaced with a new one.
I've been driving a Trumpchi GA6, and calibrating the tire pressure sensor is quite straightforward. First, make sure the tire pressure in all four tires is within the recommended range, usually around 30-35 psi, and check it with a tire pressure gauge. Then, get in the car, turn the key to the ignition position without starting the engine, find the settings menu on the steering wheel, navigate to the tire pressure monitoring system option in the vehicle information, and select the reset or calibrate function. You may need to press the button a few times, and when the indicator light flashes a few times, it means the calibration has started. Finally, drive for a short distance, like a few kilometers, and the system will automatically learn the new tire pressure. I do this every time I change tires, and it takes less than 10 minutes, avoiding false alarm fault lights. Regularly checking tire pressure can also extend tire life and make highway driving safer. Remember not to turn off the engine during calibration, or you'll have to start over.
