How to Automatically Turn On the Headlights of the Avancier?

1 Answers
McMicah
07/30/25 5:14am
The method to automatically turn on the headlights of the Avancier: Rotate the headlight switch to the AUTO mode, and the headlights will automatically turn on or off based on the ambient light intensity. This is because there is a light sensor located near the windshield on the vehicle's dashboard, which is used to control the automatic headlights. This feature is particularly convenient when suddenly entering underground parking lots or tunnels. The Avancier is a mid-size luxury SUV launched by GAC Honda. In terms of power, taking the Avancier 2020 240TURBO 2WD Elite Edition as an example, it is equipped with a 1.5T direct-injection turbocharged engine, delivering a maximum power of 142KW and a maximum torque of 243NM, paired with a CVT continuously variable transmission.
Was this review help?
3
1
Share
More Forum Discussions

How to Maintain an Electric Vehicle Battery?

Maintenance measures and precautions for automotive batteries are as follows: 1. Keep the battery clean and dry at all times, ensuring the vent holes are unobstructed. If oxides appear on the plates or terminals, wipe them clean and apply a small amount of grease to prevent corrosion. 2. Avoid continuous use of the starter; each use should not exceed 5 seconds, with a rest period of 10-15 seconds between starts. In severe winter, the battery discharge level should not exceed 25%, and in summer, it should not exceed 50%. 3. A fully charged battery should not be left in a state of insufficient charge for extended periods; regular charging is necessary to prevent permanent damage. 4. When charging the battery, ensure the voltage is neither too low nor too high. Generally, the standard charging voltage for a 12V battery is within the range of (13.5~14.5)V, and for a 24V battery, it is within (28~29.9)V. 5. The electrolyte level should be (10~15)mm above the plates. If the level is too low, promptly add distilled water—do not add electrolyte. In the absence of distilled water, rainwater or melted snow can be used as a substitute, but never use river water or tap water.
9
0
Share

What to Do When the Car Windows Fog Up in the Rain?

On rainy days, you can use the air conditioning system to defog the car windows. Here are the relevant instructions for defogging: 1. Manual air conditioning: Turn on the front window defogging mode, then set the fan speed to maximum, turn on the A/C switch, and adjust the temperature to the lowest. The fog on the windows will be eliminated shortly. 2. Some car models are equipped with rear window electric heating and external rearview mirrors. Simply click the switch to turn them on, and the fog will be eliminated in about a minute. 3. Automatic air conditioning: Generally, you just need to press the one-touch defrost button. After pressing it, the air volume will automatically turn to maximum and the external circulation will be activated, which is both practical and convenient. 4. In winter, you can use the heating system to defog. If the car has just been started, do not turn on the air conditioning temporarily. Wait until the engine has been preheated for a few minutes and the water temperature rises. Then start the heating, set the air volume to maximum, and turn on the front window defogging mode. The fog will disappear in a few minutes.
7
4
Share

Should You Release the Clutch Before Stepping on the Accelerator?

No, you can step on the accelerator while releasing the clutch. Here is the relevant information: 1. Clutch and Throttle Coordination: When starting a manual transmission car, you need to release the clutch and step on the accelerator simultaneously, which is called clutch and throttle coordination. 2. Adjustment: Proper clutch and throttle coordination should be adjusted according to the vehicle speed. During the starting phase, place the gear in neutral, start the engine, press the clutch pedal, shift into first gear, slowly release the clutch, and coordinate with the accelerator pedal to ensure a smooth start. 3. Attention: The clutch pedal must be fully depressed when pressed. While slowly releasing the clutch pedal, feel the vehicle's vibration and movement tendency. When the vehicle shows slight vibration and a tendency to move, gently apply the accelerator while continuing to slowly release the clutch pedal until it is fully released, ensuring a smooth start. 4. Gear Shifting: Clutch and throttle coordination is equally important when shifting gears while the vehicle is in motion.
8
4
Share

How large a battery can be replaced for Nissan Sylphy?

Sylphy's battery can be replaced as long as the size is consistent and the weight does not exceed too much. It is best to replace it with a 60AH battery. The designed lifespan of the battery is 27 months. For general family use, the battery is relatively power-saving. Many new car batteries can last 3-4 years, but after the first replacement, it is generally necessary to replace it every 2 years or so. The steps to test the condition of the battery are as follows: 1. Check the appearance of the battery: Inspect whether the battery casing is bulging, leaking, has broken partitions, or corroded terminals. If any of these phenomena are present, it indicates that the battery is dead and needs to be replaced. 2. Check the battery voltage: After charging for two hours, check the voltage of each cell every 20 minutes. If it is below 13V, it means the battery has a problem. During discharge, check every 10 minutes in three intervals. If the discharge time is faster than other batteries and drops below 10V, the battery has a problem. 3. Check if the battery is 'dehydrated' or blackened: After charging the battery for 3-6 hours, if the charger's red light remains on, it indicates severe 'dehydration' of the battery. Open the caps on top of the battery to see six round holes. Check the color of the electrolyte in each hole. If it is black, it means the lead powder on the plates has fallen off, and the battery is dead.
1
2
Share

What are the main reasons for a car emitting black smoke?

Here are the main reasons for a car emitting black smoke: 1. The fuel injector pressure is adjusted too low. 2. The fuel injector pressure regulating spring is broken or stuck. 3. Carbon deposits on the fuel injector needle valve and valve seat, or the needle valve is stuck or excessively worn. 4. Excessive wear on the fuel pump outlet valve decompression ring, causing the fuel injector to drip. Here are the solutions for a car emitting black smoke: 1. Perform maintenance and replacement of corresponding parts, such as the air filter, fuel injector, valve seal, cylinder liner and piston assembly, oxygen sensor, etc. 2. Clean the corresponding parts to avoid blockages, such as the air filter and fuel injector, which are parts that require frequent cleaning. 3. Driving habits are also important. If you frequently slam the accelerator, problems like the car emitting black smoke will worsen and occur more often. 4. Regularly inspect a series of parts, including system oil pressure, air filter, fuel supply system, intake system, intake pressure sensor, wiring, spark plugs and ignition wiring, oxygen sensor, flow meter and related wiring, fuel injector-related wiring, pressure regulator and related wiring. 5. Do not use fuel oil arbitrarily; choosing the same brand of oil is important for quality. The selection of fuel type is also quite important; do not arbitrarily choose different types.
2
5
Share

What to Pay Attention to Before the Subject 2 Test?

Here are the precautions before the Subject 2 test: 1. When taking the Subject 2 test, never forget to fasten your seat belt. After getting into the car, first adjust to a comfortable sitting position, then adjust the rearview mirrors, fasten the seat belt, and prepare for the test. 2. The rearview mirrors are very important. The Subject 2 test is conducted in a closed venue and includes tasks such as reversing into a garage, parallel parking, starting on a slope, and navigating an S-curve. The key to reversing into a garage lies in judging the distance between the rear wheels and the two solid lines through the rearview mirrors. As long as this distance is well controlled, you can smoothly drive in. 3. After completing the Subject 2 test, you should leave the venue immediately. Additionally, mobile phones are not allowed to be brought into the test venue during the Subject 2 test.
12
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.