Browse

Antiques Collectibles Apparel Baby Kids Items Books， Movies And Music Electronics Free Stuff Garden Outdoor Health Beauty Home Goods Home Improvement Supplies Musical Instruments Office Supplies Pet Supplies Sporting Goods Ticket Toys Games Transportation Others

Used Cars New Cars Others

Business Crafts Design And Web Events Home Improvement Legal Lessons Personal Pets Photography Repair And Technical Support Wellness Writing， Translation， And Transcription Others

Activities & Groups Artists & Musicians Classes & Lessons Events Friendship & Networking Lost & Found Rideshare Sports Teams Volunteers Travel & Travel Partners Skills & Language Swap Other

How to align the timing of the new Santana?

1 Answers

DelAyla

07/28/25 5:28pm

New Santana timing method: 1. Align the crankshaft according to the marks on the crankshaft timing pulley, generally requiring the No. 1 cylinder piston to be at top dead center position. 2. Install the camshaft timing pulley marks to align the camshaft, with dual camshafts aligning both camshaft positions respectively. 3. Install the timing belt/chain properly. Below are detailed instructions: The engine timing gears only have marks on the camshaft gear, with no marks on the other gears. First, rotate the engine to bring cylinders 1 and 6 to top dead center. Then assemble all gears except the camshaft gear, observing the marks on the engine block to align the camshaft gear mark with this mark. Next, rotate the engine to about 22 degrees before top dead center, adjust the fuel injection pump to the state where the No. 1 cylinder just starts to discharge fuel, and tighten the screws.

Was this review help?

13

2

Share

More Forum Discussions

How to Replace the Headlight Bulb on a Honda Fit?

The method to replace the headlight bulb on a Honda Fit is: 1. Open the engine hood and locate the bulb to be replaced at the front of the vehicle; 2. Unscrew the dust cover and disconnect the power supply; 3. Then you will see the bulb is held by a spring clip, press the clip and slide it sideways to remove the old bulb; 4. Install the new bulb, then reattach the spring clip and dust cover. The Honda Fit is a compact 5-door, 5-seat hatchback with body dimensions of: length 4109mm, width 1694mm, height 1537mm, and a wheelbase of 2530mm. It is equipped with a 1.5L engine and a CVT transmission, delivering a maximum power of 96 kW and a maximum torque of 155 Nm.

Should You Not Press the Brake at All During the Entire Reverse Parking Process?

Reverse parking requires pressing the brake as needed based on actual operation. Below is the relevant introduction for Subject 2 of the driving test: 1. Test Content: The test for small cars, small automatic transmission cars, small automatic transmission passenger cars for the disabled, and low-speed trucks includes reverse parking, slope parking and starting (canceled from June 1, 2021), parallel parking, curve driving, and right-angle turning. 2. Passing Criteria: The full score is 100 points, with evaluation standards set for failing, deducting 20 points, deducting 10 points, and deducting 5 points. The following regulations apply for passing the test: For large passenger vehicles, tractors, city buses, medium-sized passenger vehicles, and large trucks, a score of 90 is required; for other vehicle types, a score of 80 is required.

Where is the OBD interface located in the Envision?

The OBD interface in the Envision is located under the dashboard on the driver's side, near the driver's left knee, and is a socket. OBD stands for On-Board Diagnostics, which translates to "on-board automatic diagnostic system" in Chinese. This system continuously monitors the engine's operating conditions to check if the vehicle's emissions exceed standards. If they do, it will immediately issue a warning. When a system malfunction occurs, the malfunction indicator light or Check Engine warning light will illuminate, and the Powertrain Control Module (PCM) will store the fault information in memory. Through a specific procedure, the fault code can be read from the PCM. Based on the fault code, maintenance personnel can quickly and accurately determine the nature and location of the fault.

How to Set the Time on a Focus?

To set the time on a Focus: 1. Turn on the ignition to display the time on the instrument panel; 2. Press and hold the protruding button in the center of the instrument panel for 3 seconds; 3. When the clock starts blinking, adjust the hour by pressing the button up or down according to the actual time; 4. After setting the hour, continue pressing the button up or down to adjust the minutes to the correct value. The Focus is a compact 4-door, 5-seater sedan with the following dimensions: length 4647mm, width 1810mm, height 1468mm, wheelbase 2705mm, and a fuel tank capacity of 53 liters. It is equipped with a 1.5L naturally aspirated engine and a 6-speed manual transmission, delivering a maximum power of 90 kW and a maximum torque of 153 Nm.

Does the Pajero Sport have a four-wheel drive version?

The Pajero Sport does have a four-wheel drive version, which utilizes a part-time four-wheel drive system. The Pajero Sport is a mid-size SUV launched by Beijing Jeep. Taking the 2004 facelift model as an example, its body dimensions are: length 4625 mm, width 1775 mm, height 1770 mm, wheelbase 2725 mm, fuel tank capacity 74 liters, and minimum ground clearance 185 mm. The 2004 facelift model of the Pajero Sport is equipped with a 3.0L naturally aspirated engine, delivering a maximum power of 123 kW at 5000 rpm, paired with a 5-speed automatic transmission.

How to Open the Cigarette Lighter in Emgrand?

Emgrand's cigarette lighter can be opened by following these steps: 1. Turn on the car power and insert the cigarette lighter into the power socket; 2. Press down and lock it. The Emgrand is a compact 4-door, 5-seater sedan with body dimensions of 4632mm in length, 1789mm in width, 1470mm in height, and a wheelbase of 2650mm. It is equipped with a 1.5L naturally aspirated engine and a 5-speed manual transmission, delivering a maximum power of 80 kW and a maximum torque of 142 Nm. The drive system is front-wheel drive, with a MacPherson strut independent suspension at the front and a torsion beam non-independent suspension at the rear.

Trending Ranking

How to Turn Off the Auto Start-Stop in the 14th Generation Sylphy?

What is the minimum ground clearance of the Geely Boyue?

Why is hot air blowing from the vents when the car air conditioner is off?

How to Spray Windshield Washer Fluid on Lavida?

Where to Install the Rear Camera of a Dash Cam?

Are there any requirements for steering wheel operation in Subject 2?

Do You Need to Remove the Sunroof to Replace the Sunroof Seal?

Does the Boyue come with automatic parking?

What to Pay Attention to for Long-Term Parking

Where to Renew Driver's License in Chongren County?

More Forum Discussions

How Often Should Motorcycle Brake Pads Be Replaced?

When Should the Second Maintenance for a New Car Be Performed?

What type of tires are suitable for motorcycle cornering?

What is the function of parking lights?

Help

Cookie

Cookie Settings

© 2025 Servanan International Pte. Ltd.