How to Align the Timing Marks on a Citroen C-Quatre?

1 Answers
LoganRose
07/29/25 8:06pm
Citroen C-Quatre timing mark alignment method is as follows: 1. There is a relatively prominent tooth on the car's timing wheel, and there are three teeth on the oil pump near the upper part of the timing wheel. 2. Align the tooth on the timing wheel with the middle one of the three teeth on the oil pump. Below is a partial introduction to the Citroen C-Quatre: 1. The Citroen C-Quatre comes standard with BS+EBD+EBA, ASR traction control system, Bosch 9.1 version ESP, and HAC hill start assist control system. 2. The top-of-the-line flagship model is also equipped with an automatic anti-glare rearview mirror, making it even more considerate.
Was this review help?
5
3
Share
More Forum Discussions

Which red lights allow left turns?

When the red light is on, left turns are not allowed, and vehicle passage is prohibited. Relevant regulations: Article 38: Motor vehicle traffic signals and non-motor vehicle traffic signals indicate: When the green light is on, vehicles are permitted to pass, but turning vehicles must not impede the passage of released straight-moving vehicles or pedestrians; When the yellow light is on, vehicles that have already crossed the stop line may continue to pass; When the red light is on, vehicle passage is prohibited. Relevant legal provisions: Article 13: Motor vehicle license plates shall be hung at designated positions on the front and rear of the vehicle, kept clear and intact. Heavy and medium-duty trucks and their trailers, tractors and their trailers shall have enlarged license numbers painted on the rear of the body or carriage, with characters upright and kept clear.
2
3
Share

How long should you avoid rain after crystal coating?

Generally, you should avoid rain within 24 hours after crystal coating, refrain from wiping the paint surface for three days, and avoid car washing for one week. If the car gets wet on the same day of crystal coating, it may damage the crystal layer on the paint surface, significantly affecting the subsequent crystal coating effect, and potentially causing the coating to fail. Here are some precautions after crystal coating: 1. Do not rinse the vehicle within one week after coating. 2. The crystal coating agent takes 24 hours to fully bond with the car paint and form the final crystal protective layer. 3. After 4 to 6 months of crystal coating, you can visit a car beauty shop for paint surface restoration to enhance the coating effect and prolong its durability. 4. Try not to touch the paint surface after coating to avoid affecting the final crystal coating effect.
8
2
Share

How many seconds does it take for a rally car to go from 0 to 100?

Rally cars take 2.5 seconds to accelerate from 0 to 100 km/h. F1's top speed: is 415 km/h. An F1 car can accelerate from 0 to 100 km/h in 2.5 seconds and reach 200 km/h in 5 seconds; F1 cars have strong braking characteristics, capable of decelerating from 200 km/h to 0 in 1.9 seconds with a braking distance of 55 meters. The electric supercar Roadster takes only 2.1 seconds to accelerate from 0 to 100 km/h. Acceleration capabilities of other Tesla models: are very impressive. The Model 3 takes 3.4 seconds at its fastest, the Model S takes 2.6 seconds, the Model X takes 2.9 seconds, and the Model Y takes 3.7 seconds, significantly faster than fuel-powered cars in the same price range.
8
2
Share

What Causes Water Leakage Under the Car After Parking?

There are three main reasons for water leakage under the car. Condensate water dripping from the air conditioning system in use: Check if the coolant in the radiator is insufficient, then inspect whether the cooling system pipes are loose or damaged, and examine if there are any scratches on the bottom of the radiator. Cooling system failure in the radiator causing water leakage under the car: Ensure the coolant reservoir level is not too full (overflow may occur when temperature rises). Another possibility is windshield washer fluid dripping: Inspect the windshield washer fluid reservoir, pipes, and connections for looseness or damage. Determine whether the dripping is caused by prolonged air conditioning use in hot weather leading to condensate water discharge (this is normal).
16
4
Share

What are the hazards of using a motorcycle cover?

The hazards of using a motorcycle cover are as follows: The cover can wear down the paint: Some covers have a flocked interior. If there is fine dust on the surface of the motorcycle, after the cover is put on, the dust can act like sandpaper under the influence of wind, gently, slowly, and thoroughly grinding the surface of the paint from almost every angle. It can easily corrode car parts: If you cover the motorcycle with a cover in a high-temperature state, it is equivalent to covering a steaming pot with a plastic sheet. After parking the motorcycle and covering it, the local temperature rises instantly, leading to increased humidity. Excessive humidity can cause parts to rust, as 80% of the motorcycle's components are made of steel, which is prone to corrosion when exposed to water.
19
0
Share

What is the emission standard of the ninth-and-a-half generation Accord?

The ninth-and-a-half generation Accord complies with the China V emission standard. Introduction to the ninth-and-a-half generation Accord: 1. Powertrain: Offers two engine options, a 2.0L and a 2.4L. Both engines are paired with a CVT transmission and feature an engine start-stop system, reducing the fuel consumption of both powertrains to 7.0L per 100 kilometers. 2. Body dimensions: The length, width, and height are 4915mm, 1845mm, and 1470mm respectively, with a wheelbase of 2775mm. 3. Lighting: The headlights are projected by multiple LED light groups, providing impressive visual impact whether it's day or night.
16
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.