How to Adjust the Wiper Speed of Infiniti QX50?
1 Answers
Introduction to adjusting the wiper speed of Infiniti QX50: 1. The wiper control lever of Infiniti QX50 is located below the right side of the steering wheel. There are two horizontal lines on the control lever. The thin horizontal line represents the low-speed gear of the wiper, which operates at a slower speed; the thick horizontal line represents the high-speed gear of the wiper, which operates at a faster speed. The wiper speed is adjusted through these two gears. 2. The working frequency of the wiper in continuous low-speed gear is approximately 20-45 times per minute (completing one cycle in as fast as 3 seconds), while the high-speed gear can even achieve a frequency greater than 45 times per minute. The intermittent gear wiper generally takes the same time as the continuous low-speed gear for one cycle but adds an interval of about 2-12 seconds. Precautions for using the wiper: 1. Check the rubber: If the wiper rubber strip has cracks or has hardened, it will produce a harsh screeching sound. In cases of minor wear, the owner can use sandpaper to smooth out any uneven surfaces. 2. Avoid exposure to sunlight: Try to park the car in a ventilated and shady place. Summer is particularly harsh on cars, and leaving the vehicle exposed to the sun will accelerate the aging of the wiper blades, which are made of rubber. 3. Refill the liquid: Adding plain water directly to the windshield washer fluid reservoir is not conducive to the long-term maintenance of the windshield and wiper blades. Therefore, using a reputable brand of windshield washer fluid is important. Pay attention to timely refilling of the washer fluid during daily driving.
