How to adjust the time on the Bestune X40?

What is the actual fuel consumption of the Geely Boyue Pro?

Geely Boyue Pro has a comprehensive fuel consumption of 7.5L per 100 kilometers. The following is an introduction about the Geely Boyue PRO: 1. Introduction: The success of Geely Boyue has laid a solid foundation for the Boyue PRO. The Geely Boyue PRO is equipped with two turbocharged engines, the 1.8TD and 1.5TD. The 1.8T engine is already a "veteran" in Geely's lineup and was awarded the "China Heart" Top Ten Engines in 2016, demonstrating Geely's significant efforts in engine development and adaptation in recent years. 2. Configuration: The third-generation 1.8TD turbocharged engine equipped in the Boyue PRO has seen a notable improvement in power under Geely's tuning, with a maximum power of 135kW (184Ps) and a peak torque increase of 15N·m to 300N·m compared to the previous generation. It is gratifying that the Boyue Pro's comprehensive fuel consumption per 100 kilometers is only 7.5L.

16

0

Share

What causes the rattling sound in the engine?

Engine rattling sound depends on the engine's speed state. The following are the causes of abnormal sounds: 1. The abnormal sound only occurs during idle or low-speed operation. Possible causes include: excessive clearance between the piston and cylinder wall; overly tight piston pin assembly or overly tight connecting rod bearing assembly; excessive clearance between the tappet and its guide hole; wear on the camshaft profile; sometimes, a loose starter causing pulley noise (more noticeable during speed changes). 2. The sound becomes chaotic when maintaining a certain speed, and short sounds are emitted successively during rapid deceleration. Possible causes include: cracked camshaft timing gear or loose fixing nut; broken crankshaft; loose piston pin bushing; excessive axial clearance of the camshaft or loose bushing. 3. The abnormal sound appears during rapid acceleration of the engine and persists during high-speed operation. Possible causes include: loose connecting rod bearing, melted or mismatched bearing shell causing rotation; loose crankshaft bearing or melted bearing shell; broken piston pin; broken crankshaft.

8

2

Share

How to Adjust the Time and Date on a Ford Focus?

Method to adjust the time and date on a Ford Focus: 1. Turn the key to the second position. On the turn signal lever, there is a SET button and an adjustable switch that can be moved up and down; 2. Move the switch downward until SET is displayed on the instrument panel; 3. Press the SET button, then continue to move the switch downward until the indicator bar is on CLOCK; 4. Press the SET button, and now you can use the switch to adjust the year up or down. After setting the year, press the SET button to proceed to adjust the month, and use the same method to adjust the hour and minute; 5. After completing the adjustments, press the SET button and select EXIT to return. Taking the 2021 Ford Focus as an example, its body structure is a 4-door, 5-seater sedan with a length, width, and height of 4674mm, 1810mm, and 1468mm respectively, a wheelbase of 2705mm, a fuel tank capacity of 53 liters, a trunk capacity of 511 liters, and a curb weight of 1242kg.

6

1

Share

What is the difference between a 3.7 ratio and a 4.11 ratio?

The difference between a 3.7 ratio and a 4.11 ratio is that the 3.7 ratio is faster than the 4.11 ratio. The exact speed difference depends on the transmission gear and engine RPM. Below is an example with an engine speed of 1500 RPM: 1. In overdrive gear, when the engine speed is 1500 RPM, a vehicle with a 3.7 ratio can reach 105 km/h, while a 4.11 ratio can only reach 95 km/h. 2. In direct drive gear, when the engine speed is 1500 RPM, a vehicle with a 3.7 ratio can reach 83 km/h, while a 4.11 ratio can only reach 74 km/h. Here are some additional related details: 1. The smaller the ratio, the faster the vehicle and the more fuel-efficient it is. Conversely, a larger ratio consumes more fuel. 2. However, with the same transmission, a 3.7 ratio achieves a higher top speed but has lower load capacity compared to a 4.11 ratio. A 4.11 ratio can handle heavier loads and accelerates faster than a 3.7 ratio, but its top speed is lower than that of a 3.7 ratio.

8

1

Share

Where is the keyhole for the Tiida's one-button start?

Below the start button, there is a slot the size of a smart key. Insert the entire smart key into it. In case the smart key runs out of battery, first use the mechanical key to open the door. After opening the door, reinsert the mechanical key and insert the entire smart key into the hole located below the start button. Press the brake pedal and press the start button to start the car. Relevant information about the one-button start is as follows: 1. Introduction: The one-button start device is part of a smart car, a button device that simplifies the starting process and can also turn off the engine. This device can be retrofitted at the original key lock position or as an independent panel. 2. Function: Unlike traditional mechanical key ignition and conventional starting procedures, simply pressing the one-button start button can start or turn off the engine, avoiding the hassle of losing or searching for keys. Most of the time, the brake pedal needs to be pressed during the ignition process.

9

4

Share

Where is the frame number of Foton?

On the front or rear end of the right frame near the rear wheel, and the engine number is located on the central plane of the right rear end of the engine. Here is some additional information: 1. Frame number: The frame number and chassis number are colloquial terms, the accurate term should be the Vehicle Identification Number or VIN. The combination and arrangement of the Vehicle Identification Number ensures that no two vehicles of the same model will have the same number within 30 years. The VIN can be used to deduce information such as the vehicle's manufacturing year, country of manufacture, production date, etc., functioning similarly to a vehicle's 'ID card'. 2. Foton Motor: Foton Motor was established on August 28, 1996, and is a state-controlled listed company that spans regions, industries, and ownership types. Foton Motor is a large enterprise group with its management center in Beijing, possessing vehicle and parts divisions in eight provinces and municipalities including Beijing, Tianjin, Shandong, Hebei, Hunan, Hubei, Liaoning, and Guangdong, with R&D branches distributed in regions such as China, Japan, Germany, and Taiwan.

10

4

Share

How to adjust the time on the Bestune X40?

What is the actual fuel consumption of the Geely Boyue Pro?

What causes the rattling sound in the engine?

How to Adjust the Time and Date on a Ford Focus?

What is the difference between a 3.7 ratio and a 4.11 ratio?

Where is the keyhole for the Tiida's one-button start?

Where is the frame number of Foton?

What is the typical idle speed when starting a sedan?

What are the signs of timing chain failure in the EA111 engine?

Which region does the license plate 'Gui L' belong to?

What is the difference between tire 95w and 91v?