How to Adjust the Time on a 2010 Honda Spirior?
3 Answers
After starting the engine, the CLK button is used to display and set the time. Press and hold the CLK button for about 5 seconds until the time display starts flashing. Use the adjustment buttons for hours and minutes to set the time, then press the CLK button again to confirm. The adjustment mode will exit automatically after a few seconds of inactivity. Below is an introduction to the Honda Spirior: 1. In terms of exterior design, it emphasizes the perfect fusion of sharp interfaces, dynamic lines, and modern aerodynamics. The wide, low-slung wedge-shaped body exudes a robust and majestic presence, while the bold waistline clearly conveys a sense of speed. 2. As a mid-to-high-end sedan, the Spirior's interior design does not deliberately cater to Chinese consumers' tastes but instead focuses on a tech-savvy and sporty feel. The driver-centric dashboard is meticulously layered and logically arranged.
Last time I adjusted the clock on my 2010 Honda Spirior, here's how I did it: First, sit in the driver's seat, turn the key to the power-on position without starting the engine. Then focus on the right control stalk connected to the instrument panel—that small lever. Press the TRIP button at the top of the stalk twice in quick succession, and the hour digits on the dashboard will start blinking. Next, rotate the stalk left or right until the numbers jump to the current hour, then stop. Press the TRIP button once more, and the minute digits will begin flashing—continue rotating to adjust the minutes to the exact time. Finally, press TRIP again to confirm, completing the entire setting process. After finishing, casually check if the date is correct to ensure the instrument panel display is complete. If you want to start over midway, simply turn off the ignition and restart to reset.
Adjusting the time on the Honda Spirior is actually quite simple. Remember to power on the vehicle first—the dashboard must be lit before operation. Locate the slender adjustment stalk behind the steering wheel and quickly press the top button twice. At this point, the hour digits will start flashing. Gently rotate the stalk with your wrist to adjust the hours. Once set, press the button once more to switch to minute adjustment, using the same method. The whole process feels a bit like tuning an old-fashioned radio—just use lighter movements. The first time I adjusted it, I turned too forcefully and overshot the minutes. After setting, remember to test the display stability by driving a short distance to avoid finding it off again next time. The car's design is quite thoughtful—time calibration takes just two minutes.
