How to adjust the reversing mirror tilt on Lavida Plus?

What Causes Jerking When Starting in D Gear with an Automatic Transmission?

Jerking when starting in D gear with an automatic transmission is caused by persistent dirt and contaminants inside the transmission, particularly when these accumulate in the valve body, forming blockages that prevent effective regulation of oil pressure, leading to jerking, impact, and slipping issues. More details are as follows: Main causes of jerking: High temperatures can degrade the quality and frictional properties of automatic transmission fluid, increasing friction and wear, which leads to transmission noise. Simultaneously, sludge (contaminants or dirt) can form inside the transmission (e.g., in the valve body), causing jerking and impact. If the temperature exceeds 120°C, rubber sealing materials begin to harden, eventually leading to leaks and reduced hydraulic pressure. Solution: If the temperature rises further, the transmission may start to slip, and slipping in turn raises the temperature even higher. (High-end models like Audi may trigger warnings and enter transmission protection mode.) If not addressed promptly, the transmission may fail. Therefore, thoroughly removing stubborn dirt and contaminants from the transmission and effectively controlling its operating temperature are essential to completely resolve transmission issues and prevent recurrence.

10

0

Share

Is it necessary to go to a 4S store for tire repair?

New car tire punctures do not necessarily require going to a 4S store. Here is an introduction to car tire repair methods: Mushroom plug repair: Offers good repair results and is more durable, but the cost is relatively higher, takes longer, and is mainly suitable for larger punctures. Hot patch repair: Very durable after repair, but requires precise heating temperature and time control, which can easily damage the tire structure. The price varies significantly depending on the tire size. Plug repair: Does not require tire removal or wheel balancing, is quick and convenient, and relatively cheap, costing between 10-30; however, it requires enlarging the puncture, which may lead to air leakage over time. This method is mainly suitable for small, clearly located punctures.

2

4

Share

What Causes the CVT Light to Illuminate?

The reasons for the CVT light illuminating are as follows: 1. Exhaust emissions not meeting standards: Issues such as poor fuel quality, failure of the catalytic converter, excessive carbon buildup in the intake manifold, clogged fuel injectors, malfunctioning oxygen sensors, or occasional engine misfires can all cause the engine warning light to illuminate. Among these, poor fuel quality leading to the engine warning light is the most common. 2. Poor engine system performance: The engine warning light may illuminate due to poor performance in the engine system, such as faults in the throttle pedal sensor, throttle position sensor, air flow meter, crankshaft position sensor, or poor wiring connections. 3. Transmission system faults in some vehicles: The engine warning light may also indicate transmission system issues, such as internal transmission faults, slipping, or overheating.

20

0

Share

What does CVT gear mean?

Refers to a device used to adjust the mechanical operating speed and control direction, used for reversing or changing driving speed. The following is an introduction to CVT: 1. Definition: The system mainly includes basic components such as the driving pulley set, driven pulley set, metal belt, and hydraulic pump. Both the driving pulley set and driven pulley set consist of movable discs and fixed discs. The side of the pulley close to the oil cylinder can slide on the shaft, while the other side is fixed. 2. Working principle: In the CVT transmission system, traditional gears are replaced by a pair of pulleys and a steel belt. Each pulley is actually a V-shaped structure composed of two conical discs. The engine shaft is connected to the small pulley, which drives the large pulley through the steel belt.

19

2

Share

What are the precautions for learning to drive at a driving school?

Learning to drive requires attention to the following issues: 1. Maintain a safe following distance: Novice drivers often struggle to judge the distance from the car in front, frequently leaving too much space, which slows down traffic flow and creates opportunities for other vehicles to merge in front, increasing the risk of accidents. Some bold beginners follow too closely but lack the ability to handle emergencies, making rear-end collisions likely if the car ahead brakes or stops suddenly. 2. Wear a seatbelt: It’s crucial to emphasize that after adjusting the driving position, always remember to fasten the seatbelt to avoid sudden panic and unsafe conditions while driving. 3. Release the handbrake: Another common mistake beginners make is forgetting to release the handbrake when starting the car cold. Although the car can still move if the clutch and throttle are well-coordinated, this increases vehicle wear, raises fuel consumption, and may produce a burning smell. Beginners often pull the handbrake at red lights but forget to release it when driving off. If the car stalls at this point, they may panic and sweat without identifying the issue. It’s advisable for beginners to develop the habit of releasing the handbrake immediately when moving to prevent vehicle damage and personal stress.

17

2

Share

What are the penalties for driving a motorcycle with a C-class license?

C-class license holders driving motorcycles will be penalized under the "driving a vehicle not covered by the license" standard, with 12 demerit points, a fine, and in severe cases, up to 15 days of detention. Below is relevant information about C-class licenses: 1. Definition: The C1 driver's license is one type of driver's license code. Applicants can directly apply for the license with their resident ID card anywhere in the country without submitting proof of residence registration. 2. Driving requirements: The C1 driver's license permits driving small and mini passenger cars, as well as light and mini cargo trucks. Light, small, and mini special operation vehicles; small passenger cars with seating capacity of 9 or fewer. According to these standards, the C1 license does not permit driving vehicles with more than 9 seats.

11

4

Share

How to adjust the reversing mirror tilt on Lavida Plus?

What Causes Jerking When Starting in D Gear with an Automatic Transmission?

Is it necessary to go to a 4S store for tire repair?

What Causes the CVT Light to Illuminate?

What does CVT gear mean?

What are the precautions for learning to drive at a driving school?

What are the penalties for driving a motorcycle with a C-class license?

Does stopping midway during Subject 3 result in point deduction?

What does the sawtooth lane on the highway represent?

Is it dangerous to charge an electric vehicle in direct sunlight?

What does it mean when the online application for Subject 2 is successful?