How to Adjust the Reversing Camera Alignment?
2 Answers
The method to adjust the reversing camera alignment is: Start the vehicle. If the vehicle is not moving, turn on the vehicle's power switch, insert the key into the keyhole below the steering wheel, and turn the key to complete the setting. The function of the reversing camera is: It allows the driver to see the situation behind the vehicle on the display while reversing, avoiding accidents caused by the driver's inability to see behind the vehicle, thereby enabling safer reversing. The working principle of the reversing camera is: A wide-angle far-infrared camera device is installed at the rear of the vehicle, and the situation behind the vehicle can be clearly seen on the display inside the car. The steps for wiring the reversing camera are: 1. Disconnect the power supply connection of the battery; 2. Remove the small license plate light and pass the wiring harness through the position of the small license plate light; 3. Connect the adapter cable—red to the positive terminal, black to the negative terminal, and the signal wire of the camera to one end of the signal extension cable; 4. Connect the signal extension cable to the display; 5. After completing the wiring, restore the battery power supply.
I recently dealt with a reversing camera misalignment issue, which seems quite common. First, check if the camera is loose or displaced—gently push the camera to see if it wobbles. If it's not properly secured, the image can tilt when reversing. Next, correct it through the vehicle system settings: start the car, shift into reverse to enter the camera mode, and look for the menu button on the central display. Typically, there's a 'Camera Calibration' option under 'Vehicle Settings' or 'Assistance Systems.' Once inside, use the steering wheel buttons or touchscreen to adjust the reference lines and grid, aligning the misaligned parts back to their correct positions to match the rear outline of the car. Newer models might have an auto-calibration feature—trigger it and wait a few seconds for self-adjustment. Remember to keep the vehicle stationary during the process to avoid accidents. If the issue persists after trying these steps, it could be a software bug or a faulty camera. In that case, try restarting the system or contact a dealership for a firmware update. Also, avoid spraying high-pressure water directly at the camera during car washes to minimize hardware damage that could cause misalignment issues.
