How to Adjust the Rear Bumper Gap?
2 Answers
Methods to adjust the rear bumper gap: Adjust the lock on the hood to make it fit more tightly. It could also be due to aging clips and road conditions, which can easily cause gaps in the bumper. Simply push it firmly back into place. The bumper consists of three parts: an outer panel, cushioning material, and a crossbeam. The outer panel and cushioning material are made of plastic, while the crossbeam is formed by stamping cold-rolled sheet metal, about 1.5 mm thick, into a U-shaped channel. The outer panel and cushioning material are attached to the crossbeam, which is connected to the frame longitudinal beams with screws and can be removed at any time.
Adjusting the bumper gap isn't actually that complicated. First, press on the area with a large gap by hand to see if it can close. If it closes when pressed, it means the clips might not be secured properly or have shifted. Locate the corresponding fixing point screws, loosen them slightly, align the position, and then tighten them. If it doesn't move when pressed, the bracket might be deformed or not installed correctly during repair, and you'll need to disassemble it to check if the metal bracket is bent. I recommend keeping some plastic clip spares, as the original clips on older cars tend to become brittle and break. When installing, make sure the slots are aligned and avoid using excessive force to snap them in. Finally, remember to check the sealing strips around the taillights, as misalignment here can also cause gaps to appear.
