How to adjust the low beam of Changan CS75?
3 Answers
Steps to adjust the height of the low beam for Changan CS75: 1. First, locate the vehicle light height adjustment switch in the driver's compartment. 2. Turn the knob to position 0 for the highest light setting. 3. Rotate the knob to position 1 for a relatively high headlight position. 4. Continue rotating to position 2 for a relatively lower light height. 5. Adjust to position 3 if the lowest light height is needed. Below is some relevant information about the Changan CS75: 1. Powertrain: Equipped with a 1.5L turbocharged engine and a manual transmission. 2. Body dimensions: Length, width, and height are 4650mm, 1850mm, and 1715mm respectively.
I've driven several cars, including my friend's Changan CS75, so I'll share my experience with adjusting the low beams. This model usually has an adjustment hole near the low beam position under the hood. You'll need a Phillips screwdriver or a dedicated hex key. After turning off the engine, open the hood and locate the back of the headlights at the front of the car. There you'll find two screws - the top one controls vertical adjustment while the bottom adjusts horizontal direction. Turn the screws counterclockwise or clockwise with the wrench, testing the beam position after each small adjustment by starting the car. It's best to do this at night against a wall, ensuring the light beam's horizontal line stays above wheel height without shining too high to distract other drivers. The process isn't difficult, but be careful not to apply excessive force that might damage components. If unsure, consult the owner's manual or seek help from a repair shop. Regular adjustments prevent safety issues, especially when driving on mountain roads where misaligned lights can be dangerous. I always do it myself - it's cost-effective and reliable.
I just got my hands on a Changan CS75, and adjusting the low beams is actually pretty straightforward. You just need to prepare your tools, turn off the engine, and get under the front hood to locate the adjustment screws behind the headlight cover. One screw adjusts up and down, while the other adjusts left and right—I used a regular screwdriver. When turning the screws, don’t rush; take it slow and test the effect. For testing, start the engine at night in an open area, aim the lights at a wall or the ground, and make sure the beam doesn’t shine upward and blind others. The CS75’s light adjustment is beginner-friendly—just practice a few times. Also, remind yourself that misaligned headlights affect nighttime driving safety, so don’t delay fixing them. I adjusted mine right after buying the car without spending money on a professional. Oh, and cleaning the headlight cover is important too, or the light might appear blurry. The whole process is quick and simple, perfect for beginners.
