How to Adjust the High Beam of Roewe 360?

[OSophie]

Roewe 360 high beam adjustment method: 1. Turn on the high beam and park about 2.5 meters away from the wall; 2. Position the front of the car towards the wall and observe the light beam position; 3. Rotate the headlight scale gear to adjust to the desired height and range. The Roewe 360 is a sedan product from SAIC Roewe, offering models equipped with either a 1.4T or 1.5L power configuration. In terms of body dimensions, the Roewe 360 measures 4579mm in length, 1804mm in width, and 1490mm in height, with a wheelbase of 2660mm.

[SanNolan]

As a DIY-savvy car owner, adjusting the high beams on your Roewe 360 is quite straightforward, but safety is paramount. First, park on level ground and pop the hood. Behind the headlights, you'll spot two small adjustment holes—one for vertical height and another for horizontal alignment. Use a suitable Phillips screwdriver or hex key to gently turn the vertical screw for beam height adjustment. For best results, perform this at night by aligning the beams against marked lines on a wall. The light should hit the road a few centimeters below the headlight's center point to avoid dazzling oncoming traffic. Test the screw rotation carefully without applying excessive force to prevent part damage. After adjustments, take a test drive to check beam pattern uniformity and brightness. Repeat if necessary. Regular maintenance should include checking headlight alignment to enhance nighttime safety—consult Roewe's official manual or online tutorials if unsure.

[StMiranda]

After driving my Roewe 360 for a long time, adjusting the high beams is quite straightforward. Park the car in a suitable spot, release the hood latch, and lift the hood to locate the small holes behind the high beam assembly. There are usually two small holes corresponding to adjustment screws. Use a common tool like a small wrench to gently turn them—one adjusts the vertical angle to prevent the beam from shining too high and disturbing others, while the other adjusts the horizontal angle to avoid excessive light deviation. For best results, do this at night by marking a cross on a wall and adjusting the beam's center point to a lower position, ensuring it illuminates the ground. DIY adjustments save time, but don’t rush—turn the screws slowly and check the beam’s focus afterward. Proper alignment is crucial to avoid accidents, as headlights can shift over time. Regular checks help save money and ensure safer driving.

[HoldenRose]

Adjusting the high beams on the Roewe 360 is quite straightforward. Based on my experience, you should park the car, open the hood, and then feel or look for the adjustment hole markings at the rear of the headlight. Commonly, you can use a screwdriver to align and turn the adjustment screw. Turning the height adjustment hole a few times can significantly affect the beam direction. The goal is to focus the light beam on the center of the road without scattering. It's recommended to perform the adjustment on level ground and then take a test drive to verify the effect. Proper adjustment ensures clearer and safer visibility during night driving.