How to adjust the high beam of BYD F3?
4 Answers
The method to adjust the high beam of BYD F3 is as follows: 1. The high beam switch of BYD F3 is located on the left lever behind the steering wheel. To turn on the high beam, push the lever forward. 2. Although the high beam can be turned on by pushing the lever outward, there is a prerequisite for turning on the high beam: the low beam must be turned on. In other light positions (off or width light), the high beam cannot be turned on. 3. The headlights of BYD F3 can adjust the height of both low and high beams, as well as the width, so there are 3-4 adjustment bolts. Open the engine cover to find the adjustment bolts.
Adjusting the high beams on a BYD F3 is actually quite simple. I often do it myself to save time and money. Usually, you need to open the hood and locate the white or black adjustment screws at the rear of the headlight, which can be adjusted with a Phillips screwdriver. The vertical adjustment screw is typically on top or beside the headlight, while the horizontal one is on the side. The specific steps are: first, find a flat parking lot, turn off all lights, start the car, and park facing a wall about 5 meters away with the high beams on. Then, use the screwdriver to adjust until the beam focuses at the right height—not too high to blind others or too low to obscure the road. If you're not familiar, check the manual first to confirm the positions and try a few times slowly. Remember to regularly check the bulb lifespan to prevent burnout from affecting the adjustment. Safety first—proper adjustment can prevent nighttime accidents and make driving more reassuring.
As someone who frequently drives long distances, I believe adjusting the high beams should not be taken lightly. Incorrect settings can cause glare or even endanger safety. The adjustment for the BYD F3 is done via screws in the engine compartment—just open the hood and you'll see two screws. The vertical screw adjusts the beam's up and down angle, while the horizontal screw controls the left and right range. The steps are simple: First, park on level ground, turn off the engine, and preferably do this in a garage or dark environment. Then, start the car and turn on the high beams. Use a Phillips screwdriver to slowly turn the screws while observing the light spot on the wall to ensure it stays centered. After adjustment, remember to test the effect on the road to avoid scattered beams affecting other drivers. Pay attention to light changes while driving and perform regular maintenance to prevent major issues. The key is to be patient—avoid rushing and making mistakes that could lead to glare-related accidents.
I've been driving a BYD F3 for several years, and adjusting the high beams is really quick to get done. Open the hood and locate the two adjustment screws at the back—the vertical adjustment screw is on the top or side of the headlight, and the horizontal adjustment screw is on the side. Carefully turn them a few times with a regular Phillips screwdriver to align the beam onto a wall in front. The steps are super simple: first, park on a level surface and turn off the headlights, then turn on the high beams and aim them at a wall about 5 meters away. Slowly adjust the screws until the light doesn't glare. After adjusting, take a test drive at night to check the effect. If something feels off, it might be loose screws—just tighten them to avoid future trouble. Regularly check the bulbs and wiring, and keep them clean to prevent corrosion.
